Epson Progression Manual de usuario
EPSON® PROGRESSION™
Setup Guide
@
This manual is printed on recycled paper and is 100% recyclable.
IMPORTANT NOTICE
DISCLAIMER OF WARRANTY
Epson America makes no representations or warranties, either express or implied, by or
with respect to anything in this manual, and shall not be liable for any implied warranties
of merchantability and fitness for a particular purpose or for any indirect, special or
consequential damages. Some states do not allow the exclusion of incidental or
consequential damages, so this exclusion may not apply to you.
COPYRIGHT NOTICE
All rights reserved. No part of this publication may be reproduced, stored in a retrieval
system, or transmitted, in any form or by any means, electronic, mechanical,
photocopying, recording, or otherwise, without the prior written permission of Epson
America, Inc. No patent liability is assumed with respect to the use of information
contained herein. Nor is any liability assumed for damages resulting from the use of the
information contained herein Further, this publication and features described
herein are
subject to change without notice.
TRADEMARKS
Epson is a registered trademark and Epson Progression is a trademark of Seiko Epson
Corporation.
VirtualCache is a trademark of Epson Portland, Inc.
General notice: Other product names used herein are for identification proposes only and
may be trademarks of their respective companies.
Copyright
Q
1992 by Epson America, Inc.
Torrance,Califomia
Y74599100200
ii
1.
Read all of these instructions and save them for later reference.
2.
Follow all warnings and instructions marked on the computer.
3.
Unplug the computer from the wall outlet before cleaning. Use a
damp cloth for cleaning; do not use liquid or aerosol cleaners.
4.
Do not spill liquid of any kind on the computer.
5.
Do
not
place the computer on an unstable cart, stand, or table.
6.
Slots and openings in the cabinet and the back or bottom are
provided for ventilation; do not block or cover these
openings.
Do not place the computer near or over a radiator or
heat
register.
7.
Operate the computer using the type of power source indicated
on its label. If you are not sure of the type of power available,
consult your dealer or local power company.
8.
If you plan to operate the computer in
Germany,
observe the
following safety precaution:
To provide adequate shortcircuit protection and over-current
protection for this computer, the building installation must be
protected by a 16 Amp circuit breaker.
9.
Connect all equipment to properly grounded (earthed) power
outlets. If you are unable to insert the plug into an outlet,
contact your
electrician
to replace your outlet. Avoid using
outlets
on the
same circuit as photocopiers or air control
systems that regularly switch on and off.
Important Safety Instructions
10. Do not allow the computer’s cord to become damaged or frayed.
iii
11.
If you use an extension cord with the computer, make sure the
total of the ampere ratings of the devices plugged into the
extension cord does not exceed the ampere rating for the
extension cord. Also, make sure the total of all products
plugged into the wall outlet does not exceed 15 amperes.
12. Do not insert objects of any kind into this product through the
cabinet slots.
13. Except as specifically explained in this manual, do not attempt to
service the computer yourself. Refer all servicing to qualified
service personnel.
14.
Unplug the computer from the wall outlet and refer servicing to
qualified service personnel under the following conditions:
A.
When the power cord or plug is damaged.
B.
If liquid has entered the computer.
C. If the computer does not operate normally
when the
operating instructions are followed. Adjust only those
controls that are covered by the operating instructions.
Improper adjustment of other controls may result in
damage and often requires extensive work by a qualified
technician to restore the computer to normal operation.
D.
If the computer has been dropped or the cabinet has
been
damaged.
E. If the computer exhibits a distinct change in performance.
iv
V
Contents
Introduction
Chapter 1
Setting Up Your System
1 Choosing a Location.
.......................
1-2
2 Removing the Protective Card
..................
1-3
3 Connecting a Monitor
.......................
1-4
Using a Display Adapter Card
................
1-7
4
Connecting a Printer or Other Device
.............
1-8
Using the Parallel Port.
....................
1-9
Using
SeriaI
......................
1-11
5 connecting the Keyboard.
...................
1-12
6 Connecting the Mouse
......................
1-13
7
Connecting the
Power Cord
...................
1-15
8 Turning On the Computer
....................
1-16
Where To Go Next
..........................
1-17
Chapter 2
Running the SETUP Program
Starting the SETUP Program
....................
2-2
Selecting Options
........................
2-4
Setting the Date and Time
.....................
2-5
Setting the Processor Speed Options
...............
2-6
Setting the Fast Boot Option
....................
2-8
Setting the System and Video BIOS Options
...........
2-8
Setting the Keyboard Options
...................
2-10
InstaIled Equipment
.........................
2-11
Setting the Built-in Parallel and SeriaI Port Options
.......
2-12
Setting the Speaker
.........................
2-14
Setting the Disk Drive Controllers
.................
2-14
Setting the Password Options
...................
2-15
Changing a Password
.....................
2-17
Deleting a Password.
.....................
2-17
Setting the Diskette Drive Type(s)
................
2-18
Setting the Hard Disk Drive(s)
..................
2-19
Hard Disk Drive Types
....................
2-19
Setting the Non-cache Areas
....................
2-23
Setting the Cache Test and Use Control Options
........
2-24
Saving Your Settings and Exiting SETUP
............
2-25
You made changes, and want to save them and
exit SETUP
........................
2-26
You made no changes and want to exit SETUP
......
2-26
You made changes and want to exit SETUP
without saving the changes
...............
2-27
You saved your settings with
[F101
............
2-27
Post-SETUP Procedures
......................
2-29
Appendix A
Using Memory
Types of Memory . . . . . . . . . . . . . . . . . . . . . . . . . .
A-1
viii
This manual explains how to set up your Epson
®
Progression™
computer. Chapter 1 provides simple step-by-step instructions
for setting up your system and connecting peripheral devices
such as the monitor, mouse, and printer.
Chapter 2 describes how to run the SETUP program to define
your computer’s configuration. Do this before you use your
computer. If you change the configuration later, you will need
to run it again.
After you set up your system and run SETUP, you can install
your operating system and software. (For general installation
guidelines, see the Read This First card that came with your
system.)
Note
If your computer has already been configured, you don’t
need to run SETUP or install any software. Just set it up as
described in Chapter 1 and turn it on. (Ask your dealer if
you are not sure if your computer was preconfigured.)
For information on using system memory, see Appendix A.
The instructions in this manual are designed to get your system
up and running; for complete information about using your
computer, see the User’s Guide.
If you need help while you are setting up your computer in the
United States, you can contact your dealer or call the Epson
Customer Support Center at (800) 922-8911. If you purchased
your computer outside the United States, contact your nearest
Epson dealer. International Marketing locations are listed
inside the back cover of your User’s Guide.
Chapter 1
Setting Up Your System
To set up your computer, follow the eight steps in this chapter.
You may want to open this manual’s back cover foldout so you
can refer to the illustrations identifying the different parts.
Setting
Up Your System
1-1
Otros manuales para Progression
4
Tabla de contenidos
Otros manuales de De oficina de Epson
Epson
Epson EQUITY II+ Dimensiones
Epson
Epson Equity 386/25 Manual de usuario
Epson
Epson Apex 110 Dimensiones
Epson
Epson Endeavor WG Manual de usuario
Epson
Epson Equity 386/20 Manual de instalación y operación
Epson
Epson NX Manual de instalación y operación
Epson
Epson EL 3S/33 Dimensiones
Epson
Epson QX-10 Manual de usuario
Epson
Epson Stylus Pro 5000 - Print Engine Manual de instalación y operación
Epson
Epson Apex Dimensiones
Epson
Epson Equity 386SX PLUS Manual de instalación y operación
Epson
Epson ActionTower 2000 Manual de usuario
Epson
Epson ExpressStation Manual de instalación y operación
Epson
Epson Progression 4 Manual de usuario
Epson
Epson Equity 386SX/16 PLUS Manual de instalación y operación
Epson
Epson Equity III Manual de usuario
Epson
Epson Equity 386SX PLUS Manual de usuario
Epson
Epson Endeavor 486C Manual de instalación y operación
Epson
Epson LT-286 Manual de usuario
Epson
Epson Progression Dimensiones
