Epson WorkForce 600 Series Manual de usuario
Network Installation Guide
WorkForce™600 Series
Artisan™700 Series
Artisan™800 Series
2Before You Begin
Before You Begin
Make sure you installed ink cartridges and loaded paper as described on the
Start Here poster. Then follow the instructions in this guide to set up the printer
for use on a network.
Tip:
For a video tutorial and other information about setting up a wireless network, go to:
epson.com/support/wireless
Do one of the following:
■If you’re installing the printer for the first time, see below.
■If you’re setting up an additional computer to use the printer on the network,
follow the steps in “Install on Additional Computers” on page 23.
Choose Your Connection Type
Wireless To add the printer to your wireless network, see page 3.
Wired To add the printer to your wired network, see page 15.
Wireless Network Installation 3
Wireless Network Installation
To add the printer to your wireless network, you need to know the name (SSID)
of your wireless network. If it has security enabled, you also need to know the
WEP key or passphrase. Write down the SSID and WEP key or passphrase below:
■Network name (SSID): _________________________________________
■WEP key or passphrase: _________________________________________
Note:
If the WEP key is either 5 or 13 characters, it’s ASCII. If the WEP key is either 10 or 26
characters, it’s hexadecimal. The default WEP key is usually 1.
If your passphrase contains upper- or lowercase letters, be sure to note it correctly.
The printer supports the following wireless security modes: WEP 64, WEP 128, and
WPA-PSK.
If you don’t know your wireless network name (SSID) or WEP key or passphrase,
contact the person who set up your wireless network before you begin.
Connect the Ethernet Cable
Note:
This is a temporary connection used to configure the printer. You will be prompted to
remove the cable when configuration is complete.
1. Connect an Ethernet network cable to the LAN (10/100) port on your printer.
4Wireless Network Installation
2. Connect the other end to any available LAN port on your router, access point,
or hub.
If you don’t have access to an Ethernet port on your router, access point, or
hub, connect the printer directly to your computer’s Ethernet network port.
Note:
To use this configuration method, your computer must be connected to the
network wirelessly, and your computer’s Ethernet connection must be set to
obtain an IP address automatically.
3. Continue with the steps in the next section to install software.
Wireless Network Installation 5
Install Software
The steps show installation screens for the WorkForce™600 Series, but the
installation instructions are the same for the other models.
1. Insert the printer software CD.
2. Windows Vista®:If you see the AutoPlay window, click Run Epsetup.exe.
When you see the User Account Control screen, click Continue.
Windows®XP: When you see the Software installation screen, continue with
step 3.
Mac OS®X: Double-click the icon.
3. Click Install.
6Wireless Network Installation
4. When you see this screen, select Install driver for network connection and
click Next.
5. Follow the on-screen instructions to install the software for your product.
Note:
These installations take several minutes to complete.
6. Select Set up this printer for the first time, then click Next.
7. Continue with the steps in the next section to configure the printer and add it
to your wireless network.
8Wireless Network Installation
4. Do one of the following:
■If the printer is connected to your router, access point, or hub, select
Method 1: Connect via a router/access point (RECOMMENDED).
■If the printer is connected directly to your computer, select
Method 2: Connect directly to the computer (ADVANCED).
Important:
Do not select Method 3: Connect with WPS or SES (NOT SUPPORTED).
5. Click Next.
6. If you see a firewall alert message click Unblock or Allow to let Epson
EasyInstall continue. Do not select Ask Me Later, Keep Blocking, or Block.
Note:
Make sure that you allow network access for Epson EasyInstall. In Windows, verify
that the publisher is SEIKO EPSON, then click Unblock. In Mac OS X, configure
your firewall software to allow network access for Epson EasyInstall.
Wireless Network Installation 9
7. Select the printer you want to configure, then click Next.
Note:
It may take up to 90 seconds for your computer to find the printer on the network.
If your printer doesn’t appear in the list after 90 seconds, make sure that the printer
is turned on and the Ethernet cable is connected as described on page 3. Then
click the refresh button.
8. Select Wireless (remove Ethernet cable when prompted) as the network
communication type, then click Next.
10 Wireless Network Installation
9. Select your network name (SSID) from the list, then click Next.
Note:
If your router or access point doesn’t broadcast its network name (SSID), select
Manually Enter Network Name (SSID) and enter the network name. Click Next.
On the next screen, select your wireless network security type, then click Next.
10. If your wireless network doesn’t have security enabled, continue with step 11.
If your wireless network has security enabled, do one of the following:
■If you see the WEP Security Settings screen, select ASCII if your WEP
key is either 5 or 13 characters, or select Hexadecimal if your WEP key
is either 10 or 26 characters. Enter your WEP key in the two text fields,
leave the active WEP key set to 1(usual default), and click Next.
Otros manuales para WorkForce 600 Series
6
Este manual sirve para los siguientes modelos
7
Tabla de contenidos
Otros manuales de Impresora todo en uno de Epson
Epson
Epson AcuLaser CX11NF Manual de usuario
Epson
Epson L3160 Manual de instrucciones
Epson
Epson ET-2750 series Manual de usuario
Epson
Epson SC-S60600 Series Manual de usuario
Epson
Epson WorkForce Pro ST-C5000 Manual de usuario
Epson
Epson WF-R8590 Manual de usuario
Epson
Epson STYLUS NX127 Series Manual de usuario
Epson
Epson Expression Home XP-3150 Series Manual de usuario
Epson
Epson Stylus CX6000 Series Manual de usuario
Epson
Epson STYLUS OFFICE BX610FW Series Instrucciones de instalación y mantenimiento
Epson
Epson CX7800 - Stylus Color Inkjet Manual de usuario
Epson
Epson WF-C5890 Manual de usuario
Epson
Epson NX300 - Stylus Color Inkjet Manual de usuario
Epson
Epson CX6600 - Stylus Photo Printer Manual de usuario
Epson
Epson XP-8700 Series Manual de usuario
Epson
Epson Stylus CX5500 Series Guía
Epson
Epson C11CE90401 Manual de usuario
Epson
Epson Stylus NX625 Series Manual de usuario
Epson
Epson WorkForce 633 Manual de usuario
Epson
Epson Printer Manual de usuario
