EPOX EP-3VBM+ Manual de usuario

TRADEMARK

All products and company names are trademarks or registered

trademarks of their respective holders.

These specifications are subject to change without notice.

Manual Revision 1.0

December 20, 1999

EP-3VBM+EP-3VBM+

EP-3VBM+

A SocA Soc

A Sockk

ket 370 Pret 370 Pr

et 370 Pret 370 Pr

et 370 Processor basedocessor based

ocessor basedocessor based

ocessor based

AGP MainboarGP Mainboar

GP MainboarGP Mainboar

GP Mainboard (133/100/66MHz)d (133/100/66MHz)

d (133/100/66MHz)d (133/100/66MHz)

d (133/100/66MHz)

EP-3VBM+

User Notice

No part of this product, including the product and software may be reproduced,

transmitted, transcribed, stored in a retrieval system, or translated into any language in

any form without the express written permission of EPoX Computer Company

(hereinafter referred to as EPoX) except for documentation kept by the purchaser for

backup purposes.

We provide this manual “as is” without warranty of any kind, either expressed or

implied, including but not limited to the implied warranties or conditions of merchant-

ability or fitness for a particular purpose. In no event shall EPoX be liable for any loss

of profits, loss of business, loss of use or data, interruption of business or for indirect,

special incidental, or consequential damages of any kind, even if EPoX has been advised

of the possibility of such damages arising from any defect or error in the manual or

product. EPoX may revise this manual from time to time without notice. For updated

BIOS, drivers, or product release information you may visit our websites at http://www.

epox.com or http://www.epox.com.tw.

Products mentioned in this manual are mentioned for identification purposes only.

Product names appearing in this manual may or may not be registered trademarks or

copyrights of their respective companies. The product name and revision number

are both printed on the mainboard itself.

Handling Procedures

Static electricity can severely damage your equipment. Handle the EP-3VBM+ and any

other device in your system with extreme care and avoid unnecessary contact with

system components on the mainboard. Always work on an antistatic surface to avoid

possible damage to the mainboard from static discharge. Always have the power supply

unplugged and powered off when inserting and removing devices within the computer

chassis. EPoX assumes no responsibility for any damage to the EP-3VBM+ mainboard

that results from failure to follow instruction or failure to observe safety precautions.

CAUTION

The EP-3VBM+ mainboard is subject to

damage by static electricity. Always

observe the handling procedures.

EP-3VBM+

Technical Support Services

If you need additional information, help during installation or normal use of this

product, please contact your retailer. Your retailer will have the most current informa-

tion about your configuration. If your retailer cannot help, you may visit our online

technical support website and/or contact our support technicians at the locations listed

below.

Record your serial number before installing your EP-3VBM+ mainboard. (The serial

number is located near the ISA slots at the edge of the board.)

EP-3VBM+ serial number: _________________________________

Contacting Technical Support

EPoX technical support is working hard to answer all of your questions online. From

our website you can find answers to many common questions, drivers, BIOS updates,

tech notes, and important technical bulletins. If you are still unable to locate the

solution you are seeking, you always have the option to contact our support technicians

directly.

North American website (English language)

http://www.epox.com

[email protected]

European website (Multi-language)

http://www.epox.nl

[email protected]

Taiwan website (Chinese language)

http://www.epox.com.tw

[email protected]

Thank you for using EPoX mainboards!

EP-3VBM+

Table of Contents

Section 1 Introduction

Components Checklist ....................................... 1-1

Overview

EP-3VBM+ Form-factor.................................... 1-2

I/O Shield Connector......................................... 1-3

Power-On/Off (Remote).................................... 1-3

System Block Diagram ...................................... 1-4

Section 2 Features

EP-3VBM+ Features ......................................... 2-1

Section 3 Installation

EP-3VBM+ Detailed Layout ............................. 3-1

Easy Installation Procedure

CPU Insertion .................................................... 3-3

Jumper Settings.................................................. 3-5

SystemMemoryConfiguration .......................... 3-6

Device Connectors ............................................ 3-9

External Modem Ring-in Power On and

Keyboard Power On Function (KBPO) ............. 3-11

Section 4 Award BIOS Setup

BIOS Instructions .............................................. 4-1

Standard CMOS Setup....................................... 4-2

BIOS Features Setup ......................................... 4-3

Chipset Features Setup ...................................... 4-8

Power Management Setup ................................. 4-11

PNP/PCI Configuration ..................................... 4-15

Load Setup Defaults .......................................... 4-17

Integrated Peripherals........................................ 4-17

EP-3VBM+

Sensor and CPU Speed Setup ............................ 4-22

Change Supervisor or User Password ............... 4-24

IDE HDD Auto Detection.................................. 4-25

Save & Exit Setup ............................................. 4-27

Exit Without Saving ........................................... 4-27

Section 5 Appendix

Appendix A

Memory Map ..................................................... A-1

I/O Map ............................................................. A-1

Timer & DMA Channels Map ........................... A-2

Interrupt Map..................................................... A-2

RTC & CMOS RAM Map ................................. A-3

Appendix B

POST Codes...................................................... A-4

Unexpected Errors............................................. A-7

Appendix C

Load Setup Defaults .......................................... A-9

Appendix D

GHOST 5.1 Quick User’s Guide ....................... A-11

EP-3VBM+

Page Left Blank

Introduction

EP-3VBM+

Page 1-1

Section 1

INTRODUCTION

Components Checklist

üü

üA. (1) EP-3VBM+ mainboard

üü

üB. (1) EP-3VBM+ user’s manual

üü

üC. (1) Floppy drive ribbon cable

üü

üD. (1) Hard drive ribbon cable

üü

üE. (1) Driver and utility

USER’S

MANUAL

EP-3VBM+

Introduction EP-3VBM+

Page 1-2

EP-3VBM+ Form-Factor

The EP-3VBM+ is designed with Micro-ATX form factor - the new industry

standard of chassis. The Micro-ATX form factor is essentially a Baby-AT

baseboard rotated 90 degrees within the chassis enclosure and a new mounting

configuration for the power supply. With these changes the processor is relocated

away from the expansion slots, allowing them all to hold full length add-in cards.

Micro-ATX defines a double height aperture to the rear of the chassis which can

be used to host a wide range of onboard I/O. Only the size and position of this

aperture is defined, allowing PC manufacturers to add new I/O features (e.g.; TV

input, TV output, modem, LAN, etc.) to systems. This will help systems integra-

tors differentiate their products in the marketplace, and better meet your needs.

• Smaller size promotes a smaller system size.

• I/O shield does not need to be retooled in an ATX 2.01 or later. The

mainboard should be used in an ATX 2.01 (or later) compliant case.

• A smaller power supply cam be used. High integration on mainboard reduces

the system costs.

Fulllength

slots

Expandable I/O

5 1/4"

Bay

3 1/2"

Bay

Figure 1: Summary of MicroATX chassis features

CPU located near

Power Supply

Single chassis

fan for

system

Micro-

ATX

Power

Supply

ATX power

connector

Floppy / IDE

connectors

close to

peripheral

bays

Introduction

EP-3VBM+

Page 1-3

ATX

POWERSUPPLY

Power-On/Off (Remote)

The EP-3VBM+ has a single 20-pin connector for ATX power supplies. For ATX

power supplies that support the Remote On/Off feature, this should be connected

to the systems front panel for system Power On/Off button. The systems power

On/Off button should be a momentary button that is normally open.

The EP-3VBM+ has been designed with “Soft Off" functions. You can turn Off

the system from one of two sources: The first is the front panel Power On/Off

button, and the other is the "Soft Off" function (coming from the EP-3VBM+’s

onboard circuit controller) that can be controlled by the operating system. Win-

dows 95/98 will control this when the user clicks that they are ready to Shutdown

the system.

Figure 3: Simple ATX Power ON/OFF Controller

Case (chassis) Power

ON/OFF button (J 3)

J 3

I/O Shield Connector

The EP-3VBM+ is equipped with an I/O back panel. Please use the appropriate

I/O shield (figure 2).

PS/2 Mouse

PS/2

KEYBOARD

USB port

COM1 COM2

parallel port

SpeakerLine_in

MIC

Figure 2: I/O back panel layout

Joystick/Midi port

Introduction EP-3VBM+

Page 1-4

Figure 4: System Block Diagram

System Block Diagram

PAC

PCI Bridge

and memory

controller

VT82C693A

VT82C686A

I/O Bridge

100/66MHz

133/100/66MHz

66MHz

USB 0,1 USB 2,3

AMR Slot

Tabla de contenidos

Otros manuales de Placa madre de EPOX

EPOX

EPOX 9npa Manual de usuario

EPOX

EPOX EP-5P945-J3 Manual de usuario

EPOX

EPOX EP-BX5C Manual de usuario

EPOX

EPOX EP-4PEAE 11 Manual de usuario

EPOX

EPOX BX5 Manual de usuario

EPOX

EPOX 3WXM4 Manual de usuario

EPOX

EPOX EP-5ATXA-M Manual de usuario

EPOX

EPOX BXB Manual de usuario

EPOX

EPOX mu-3vsa Manual de usuario

EPOX

EPOX EP-3WXM2 Manual de usuario

EPOX

EPOX AMD Socket et A Processor based AGP (8X)... Manual de usuario

EPOX

EPOX EP-5NVA+SLI Manual de usuario

EPOX

EPOX S7-530A Manual de usuario

EPOX

EPOX MVP4A Manual de usuario

EPOX

EPOX P2-112A Manual de usuario

EPOX

EPOX EP-MVP4F Manual de usuario

EPOX

EPOX EP-6VBA2 Manual de usuario

EPOX

EPOX kl-133m Manual de usuario

EPOX

EPOX EP-ZX370Y Manual de usuario

EPOX

EPOX KP6-LS Manual de usuario

EPOX

EPOX KP6-FX2 Manual de usuario

EPOX

EPOX EP-3VCA2 Manual de usuario

EPOX

EPOX EP-D3VA Manual de usuario

EPOX

EPOX EP-GXB-M Manual de usuario

Manuales populares de Placa madre de otras marcas

DFI

DFI SD170 Manual de usuario

ASROCK

ASROCK ROMED8-2T Manual de usuario

Asus

Asus P2L97A Manual de usuario

Winmate

Winmate IC70 Manual de usuario

Asus

Asus MES-B Manual de usuario

Grantech

Grantech SYS8F377VGGA-3OMN Manual de usuario

Telit Wireless Solutions

Telit Wireless Solutions SL869-3DR Manual de usuario

Gigabyte

Gigabyte GA-9IVDT Manual de usuario

Texas Instruments

Texas Instruments ADS8372EVM Manual de usuario

Commell

Commell MS-C73 Manual de usuario

IBT Technologies

IBT Technologies MB860 Manual de usuario

Nvidia

Nvidia TEGRA DG-04927-001_V01 Manual de usuario

Biostar

Biostar M7VIT Bravo Instrucciones de funcionamiento e instalación

Intel

Intel D33217CK Manual de usuario

Asus

Asus F1A55-M LX PLUS R2.0 Manual de usuario

EPC

EPC EPC9147C Manual de usuario

Asus

Asus EX-B760M-V5 D4 Manual de usuario

Ski-Doo

Ski-Doo Bombardier MPEM 219 700 090 Manual de usuario