Epever XTRA Series Manual de usuario
MPPT Solar Charge Controller
User Manual
Models:
XTRA1206N/XTRA2206N
XTRA1210N/XTRA2210N
XTRA3210N/XTRA4210N
XTRA3215N/XTRA4215N
XTRA3415N/XTRA4415N
Important Safety Instructions
Please keep this manual for future review.
This manual contains all safety, installation, and operation instructions for the XTRA N series
Maximum Power Point Tracking (MPPT) controller ("controller" as referred to in this manual).
General Safety Information
Read all the instructions and warnings carefully in the manual before installation.
No user-serviceable components exist inside the controller. DO NOT disassemble or attempt
to repair the controller.
Mount the controller indoors. Avoid exposure to the components and do not allow water to
enter the controller.
Install the controller in a well-ventilated place. The controller’s heat sink may become very hot
during operation.
Suggest installing appropriate external fuses/breakers.
Disconnect all PV array connections and the battery fuse/breakers before controller
installation and adjustment.
Power connections must remain tight to avoid excessive heating from a loose connection.
CONTENTS
1 General Information 1
1.1 Overview 1
1.2 Characteristics 2
1.3 Naming Rules 3
1.4 Product Classification 3
2 Installation 5
2.1 Attentions 5
2.2 PV Array Requirements 5
2.3 Wire Size 7
2.4 Mounting 9
3 Display units 12
3.1 Basic Display unit(XDB1) 12
3.2 Standard Display unit (XDS1) 13
3.3 Adanced Display unit (XDS2) 17
4 Parameters Setting 22
4.1 Battery parameters 22
4.1.1 Supported battery types 22
4.1.2 Local setting 22
4.1.3 Remote Setting 26
4.2 Load modes 29
4.2.1 LCD setting 29
4.2.2 RS485 communication setting 31
1
1 General Information
1.1 Overview
XTRA N series controller, which can carry different display units (XDB1/XDS1/XDS2), adopts the
advanced MPPT control algorithm. It can minimize the maximum power point (MPP) loss rate and
time and quickly track the MPP to obtain the maximum energy under any conditions. It can also
increase the solar system's energy utilization ratio
Limiting the charging power & current and reducing charging power functions ensure the system is
stable with over PV modules in a high-temperature environment. IP33 Ingress protection and
isolated RS485 design improve the controller’s reliability and meet the different application
requirements.
XTRA N series controller owns a three-stage charging mode, which can effectively prolong the
battery's lifespan and significantly improve the system performance. Comprehensive electronic
protection of overcharge, over-discharge, PV & battery reverse polarity, etc., ensures the solar
system is more reliable and durable. This controller can be widely used for RV, household systems,
field monitoring, and many other applications.
Features：
CE certification(LVD EN/IEC62109,EMC EN61000-6-1/3)
100% charging and discharging in the working environment temperature range
Optional LCD units (XDB1/XDS1/XDS2)
High quality and low failure rate components of ST or IR to ensure the service life
Advanced MPPT technology & ultra-fast tracking speed guarantee the tracking efficiency of up
to 99.5%
Maximum DC/DC transfer efficiency is as high as 98.5%★; full load efficiency is up to 97.2%★
Advanced MPPT control algorithm to minimize the MPP lost rate and lost time
Accurate recognizing and tracking of multi-peaks maximum power point
Wide MPP operating voltage range
2
Support the lead-acid and lithium batteries; voltage parameters can be set on the controller
Programmable temperature compensation
Limit charging power & current over the rated value
Real-time energy statistics function
Power reduction automatically over-temperature value
Multiple load work modes
Comprehensive electronic protection
Isolated RS485 with 5V/200mA protected output for no power devices, with Modbus protocol
Support monitoring and setting the parameters via the APP or PC software
IP33▲Ingress protection
★XTRA4415N@48V system
For the BCV, FCV, LVD, and LVR, users can modify them on the local controller when the
battery type is "USE."
▲3-protection against solid objects: protected against solid objects over 2.5mm.
3-protected against sprays to 60°from the vertical.
1.2 Characteristics
Figure 1 Product Characteristics
❶
RTS★port
❺
RS485 communication port
❷
PV Terminals
❻
Terminal protection cover
3
❸
Battery Terminals
❼
Display units
❹
Load Terminals
❽
Mounting Hole Φ5mm
★If the temperature sensor is short-circuited or damaged, the controller will charge or
discharge according to the setting voltage at 25 ºC (no temperature compensation).
1.3 Naming Rules
XTRA 1 2 10 N - XDS2
Display Unit(XDB1/XDS1/XDS2)
Product Series
Charge & discharge current 1-10A;2-20A;3-30A;4-40A
System Voltage 1-12VDC; 2-12/24VDC
Max. PV open circuit voltage 10-100V;15-150V
Common Negative System
1.4 Product Classification
Classify
Model
Picture
Display
Basics
XTRA****N-XDB1
LED Indicators: PV & battery working
status
Button:
In manual work mode, it switches
ON/OFF the load by pressing the
button.
Clear the error information.
Standard
XTRA****N-XDS1
LED Indicators: PV & load working
status
Buttons: View or set the parameters
or clear the error information.
LCD：PV display:voltage/current
/generated energy
Battery display:
voltage/current/temperature
Load display:
current/consumed energy/load working
mode
4
Advanced
XTRA****N-XDS2
LED Indicators: PV & battery & load
working status
Buttons: View or set the parameters
or clear the error information.
LCD: PV display:voltage/current
/generated energy/power
Battery display:voltage/current/
temperature/capacity
Load display: voltage/current/power
/consumed energy/load working mode
Este manual sirve para los siguientes modelos
10
Tabla de contenidos
Otros manuales de Controladores de Epever
Epever
Epever LS-B Series Manual de usuario
Epever
Epever Epsolar eBox-WIFI-01 Manual de usuario
Epever
Epever Tracer2606BP Manual de usuario
Epever
Epever Tracer LPLI Series Manual de usuario
Epever
Epever DuoRacer Series Manual de usuario
Epever
Epever Tracer BPL Series Manual de usuario
Epever
Epever TRIRON N Series Manual de usuario
Epever
Epever ViewStar VS1024AU Manual de usuario
Epever
Epever LS-E Series Manual de usuario
Epever
Epever TRIRON1206N Manual de usuario
Epever
Epever Tracer BPL Series Manual de usuario
Epever
Epever iTracer-ND Series Manual de usuario
Epever
Epever Tracer1206A Manual de usuario
Epever
Epever TRACER 6420 Manual de usuario
Epever
Epever MPPT Manual de usuario
Epever
Epever LandStar LPLI Series Manual de usuario
Epever
Epever LS EPD Series Manual de usuario
Epever
Epever RC-10 Manual de usuario
Epever
Epever LandStar BPL Series Manual de usuario
Epever
Epever Tracer-AN Series Manual de usuario
