Enwork Zori Manual de usuario
Zori Media Cart
Assembly Instructions
Zori Media Cart Installation Guide rev A
1) Parts and Fasteners Included
INSTALLATION GUIDE
#10 x 1-1/4 Button Head Screw 1/4-20 x 2in. Flat Head Screw
2) Tools and Supplies Required
INSTALLATION GUIDE
Phillips Head Screw Driver
3) Assembly Overview
INSTALLATION GUIDE
Fig #1 Frame Assembly
Fig #2 Credenza Assembly
Fig. #3 Base Frame Assembly
Fig. #4 Power Unit
(specific unit may vary)
4) Assembly:
INSTALLATION GUIDE
Fig #5
Fig. #6
Fig.#7
•Lay the Credenza Assembly(Fig.#1) top face down
on a non-marring surface. Fig.#4
•Place the Base Frame Assembly(Fig.#3) on the
bottom panel, spaced evenly from all sides .
•Attach the base frame to the bottom panel using
the included (16) #10 x 1-1/4 Button Head Screws.
•Rotate the Credenza Assembly/Base Frame
Assembly to an upright position and lock the
casters. Fig.#5
•Using a philips head screw driver, remove the (5)
screws and top cap from the Frame
Assembly(Fig.#1)
•Carefully remove the whiteboard panels and set
aside.
Media Table Assembly
4) Assembly:
INSTALLATION GUIDE
Fig.#8
Fig.#9
•Place the Frame Assembly(Fig.#1)on top of the
Credenza Assembly/Base Frame Assembly(Fig.#5).
•Align the frame holes with the predrilled holes on
the Credenza. Fig.#4
•Start to thread the (8) 1/4-20 x 2in. Flat Head Screw
but do not tighten until all the screws are loosely
placed.
•Tighten the (8) 1/4-20 x 2in. Flat Head Screws.
•Carefully replace the whiteboard panels..
•Replace the frame assembly top cap and replace
and tighten the philips head screws
•Insert Power unit(Fig.#4)
•The assembly is now ready for the monitor mount.
Media Table Assembly
Otros manuales para Zori
3
Tabla de contenidos
