1 ATMOS®WALL
01423 810 810
SHOULD YOU ENCOUNTER ANY PROBLEMS
WITH YOUR UNIT, CALL US ON:
SAFETY
Ensure that you read and understand these instructions before beginning installation. The unit
should be installed by a competent person.
LOCATION
Check there is space for the unit in your chosen location including room for access and future
servicing of the unit. The unit must not affect the operation of open-flue appliances. Consult local
regulations or a qualified gas engineer. The unit should not be installed in wet rooms.
After installation, the air outlet must face a minimum 1m unobstructed path away from any smoke
detectors, walls or other obstructions. For installations where the unit is required to connect to a
smoke alarm see page 10 for wiring instructions.
USERS
This unit can be used by children above 8 years and by people with reduced physical sensory or
mental capabilities or lack of experience and knowledge if they have been instructed on the safe
use of the unit and they understand the hazards involved. Children must not play with the unit.
Cleaning and user maintenance must not be performed by children without supervision.
ELECTRICAL CONNECTION
All wiring must comply with Building Regulations and the current IET Wiring Regulations (BS7671 in
the UK) or equivalent standards for other countries. All wiring should be completed by a competent
person and the final installation should be examined and tested by a qualified electrician.
The unit requires a continuous electrical power supply. Connection to the fixed wiring must be
made outside the unit in a suitable location. The unit must be able to be disconnected from the
mains supply after installation. The unit must be earthed and a double pole switch with minimum
contact separation of 3.0mm must be used to provide isolation for the unit (see the wiring diagram
on page 2). When wiring the unit, the included unswitched fuse spur should be incorporated in the
fixed wiring.
The power supply cable running into the unit must remain the supplied flexible cable (not a solid
core lighting cable). If the power supply cable becomes damaged, it must be replaced by EnviroVent,
an authorised service agent for your region/country, or a similarly qualified person in order to avoid
a hazard. Do not remove or tamper with any electronic components inside the product.
This product is not suitable for use with a Type AC RCD
