Emson Big Boss Manual de usuario

200 Watt Power

2 Speed Operation

With a Mix/Measuring Cup

CUSTOMER SERVICE: 1-800-423-4248

BIG BOSS STICK BLENDER™200 Watt ITEM NO. 8452

CONTENTS

IMPORTANT SAFEGUARDS.................................................................3

UNPACKING - PARTS AND FEATURES................................................5

USAGE - BLENDER ATTACHMENT...................................................... 6

CLEANING AND MAINTENANCE......................................................... 8

IMPORTANT SAFEGUARDS IMPORTANT SAFEGUARDS

Before using the electrical appliance, the following basic precautions should

always be followed including the following:

1. Read all instructions.

2. Before use check that the voltage of wall outlet corresponds to the one shown on the

rating plate.

3. Do not operate any appliance with a damaged cord or plug or after the appliance

malfunctions, or is dropped or damaged in any manner. Return appliance to the nearest

authorized service facility for examination, repair or electrical or mechanical adjustment.

4. If the supply cord is damaged it must be replaced by the manufacturer or a authorized

service agent or a qualified technician in order to avoid a hazard.

5. Unplug from outlet when not in use, before putting on or taking off parts, and before

cleaning.

6. Do not let cord hang over edge of table or hot surface.

7. Do not immerse upper part of blender into water due to the risk of electric shock.

8. Close supervision is necessary when your appliance is being used near children.

9. This appliance is not intended for use by persons (including children) with reduced

physical, sensory or mental capabilities, or lack of experience and knowledge, unless

they have been given supervision or instruction concerning use of the appliance by a

person responsible for their safety. Children should be supervised to ensure that they

do not play with the appliance.

10. Ensure fingers are kept well away from moving parts.

11. Keep hands and utensils out of container while blending to reduce the risk of severe

injury to persons or damage to the blender. A scraper may be used but must be used

only when the blender is not running.

12. To reduce the risk of injury, never place cutting blade on base without first putting

bowl properly in place.

13. The use of accessory not recommended by the manufacturer may cause injuries to

persons.

14. Do not operate the appliance for other than its intended use.

15. Do not use outdoors.

SAVE THESE INSTRUCTIONS

FOR HOUSEHOLD USE ONLY

POLARIZED PLUG

This appliance has a polarized plug (one blade is wider than the other). To reduce the

risk of electric shock, this plug will fit in a polarized outlet only one way. If the plug

does not fit fully into the outlet, reverse the plug. If it still does not fit, contact a qualified

electrician. Do not attempt to modify the plug in any way.

USAGE-BLENDER ATTACHMENTUNPACKING - PARTS AND FEATURES

BLENDER

ATTACHMENT

BLADE GUARD

WITH STAINLESS

STEEL BLADE

LOW/HIGH

SPEED SWITCH

MIXING CUP

(3 cup/800mL capacity)

Ideal for measuring

and for blending

directly in the cup LOCK

To attach, turn the blender

attachment counterclockwise

to lock in with the main body.

MAIN BODY

WITH MOTOR

MAIN BODY WITH MOTOR

BLENDER ATTACHMENT

MIXING CUP

UNPACKING

NOTE: The blending blades are extremely

sharp, use caution when handling.

Before using the unit for the first time,

wipe the outside of the unit with a clean

damp cloth to remove any dust from

shipping, dry it thoroughly. Refer to p.8

for complete cleaning instructions.

USAGE - Blender

Before first use, hold the unit with blender attachment in the cup half filled with water

and turn on for a few seconds.

IMPORTANT: Do not operate unit without food or liquid, unless performing

a Quick Cleaning on p.8.

CAUTION: Blade is very sharp, handle with care. Ensure that the unit

with blender attachment is unplugged from the power outlet before

assembling or removing attachments.

1. To assemble the Blender Attachment with the

motor unit, turn the attachment clockwise

until tightened. To disassemble, just turn the

attachment counterclockwise.

2. Plug the unit with blender attachment into the

power outlet.

3. IMPORTANT: Maximum operation time on high

speed cannot exceed 60 seconds (1 minute). To

avoid spatter, don’t turn the unit on until the blade is submerged in the

food mixture. Lower the unit with blender attachment into food and

depress the switch on the top of the main body.

LOCK

LOW/HIGH

SPEED SWITCH

BLENDER ATTACHMENT

CAUTION: Blade is very sharp, handle with care.

1. Unplug the appliance. To disassemble, just turn the attachment counterclockwise.

Note: Do not immerse the blender attachment in water because overtime the

lubrication on the bearings may wash away.

2. Wash the blender attachment under running water, without the use of

abrasive

cleaners or detergents.

3. After finishing cleaning the blender

attachment, place it upright so that any water

which may have got in, can drain out. The blender attachment is dishwasher safe.

CLEANING AND MAINTENANCE

QUICK CLEANING

Between processing tasks, hold the unit with blender attachment in the cup half filled

with water and turn on for a few seconds.

MAIN BODY

1. Unplug and remove the attachment. To disassemble, just turn the attachment

counterclockwise.

2. Wipe the motor unit with a damp cloth. Never immerse it in water for cleaning as

electric shock may occur.

3. Dry thoroughly. Place the attachment back onto main unit.

4. You can use the provided Mixing Cup for blending and easy pouring.

5. For best results, use an up and down motion to blend the ingredients. For easier

blending, chop or cut the ingredients prior to blending. To avoid possible damage to the

blade, remove all of the hard materials such as pits and/or bones from the mixture before

blending.

6. If mixing soups and sauces, or any other liquids, make sure that there is about 1 inch

clearance from where the main body connects to the blender attachment.

7. To avoid spatter, turn the unit off first, letting the blade stop completely before lifting

the unit out of the food mixture. To stop the unit, simply release the switch at the top of

the main body.

8. Unplug after use.

USAGE-BLENDER ATTACHMENT

Otros manuales para Big Boss

Tabla de contenidos

Manuales populares de Licuadora de otras marcas

ROTOR

ROTOR 1125.201 Manual de usuario

Braun

Braun Multiquick 5 Vario series Manual de usuario

ARENDO

ARENDO MIRA 305424 Manual de usuario

CHEF-BUILT

CHEF-BUILT CCB-3500 Manual de usuario

Viconte

Viconte VC-4406 Manual de usuario

Oster

Oster BLSTAB-CB0 Manual de usuario

HOFFEN

HOFFEN MC-3005 Manual de usuario

Black & Decker

Black & Decker BLC18750DM Manual de usuario

Sunbeam

Sunbeam 4182 Manual de usuario

Bialetti

Bialetti FMX35 Manual de usuario

Black & Decker

Black & Decker BL8000 Manual de usuario

Duronic

Duronic BL530 Manual de usuario

Exquisit

Exquisit MS 3002 wes Manual de usuario

Lumme

Lumme LU-KP1891A Manual de usuario

Binatone

Binatone HB-735 Manual de usuario

Moulinex

Moulinex LM936E10 Manual de usuario

Oster

Oster VERSA Manual de instalación y operación

Ninja

Ninja NN210Q Manual de usuario