EMILTONIA BABYSCALE | USER MANUAL [ENG]
EMILTONIA BABYWAAGE | GEBRAUCHSANWEISUNG [DE]
www.emiltonia.de
info@emiltonia.de
1. Do never dismantle the scale housing.
2. Remove the batteries before storing the equipment for long periods of time.
3. Do not wipe the equipment with corrosive chemicals. Use a neutral detergent to clean the equipment.
Do not spill water or chemical liquid on or in the unit.
4. Avoid subjecting the equipment to excessive shocks or vibrations.
5. When disposing of this unit, please do so in accordance with local standards for industrial waste.
USER INSTRUCTIONS
Please observe the following instructions for accurate measurement.
1. Measurement may not be possible on a surface that is strongly vibrating. In such cases transfer the
equipment to a stable surface with little or no vibration.
2. If the scale is moved, and the new location has a temperature difference of more than 20 °C (36 °F)
please allow at least 2 hours before using.
3. Avoid scale placement near heating/cooling vents, heating appliances or areas of high airflow.
4. To avoid malfunctions, avoid storing the equipment where there is direct sunlight, significant
temperature changes, the risk of dampness, a large amount of dust, in the vicinity of fires, or where
there is the risk of receiving vibrations or shocks. When in storage do not put anything on the tray.
BABY TRAY ATTACHEMENT & REMOVAL
A. Attachment
The baby tray is not attached to the main unit when unpacked.
1. Pull the lever out
2. Align the far edge of the tray with the stickered line
3. Slide the tray over the platform until it stops, and you hear a “click”
4. Make sure the tray is firmly secured. Fix it to the platform by pushing in the lever until you hear a “click”
B. Removal
The baby tray can be removed and washed.
1. Pull out the lever
2. While gently pushing down the lever, slide out the tray in the displayed direction.
3. Remove the tray once its far edge is aligned with the stickered line.
OPERATOR INTERFACE
• “ON/ OFF”button, can be on and off operation. Press the button and in the power off state to
START. Press the button in the power on state to OFF.
• Press the “TARE”button to perform the tare-function: To weigh a baby without taking into account
a weight of a blanket lying on the scale plate, place a blanket or cushion on the scale plate. After the
weight of the blanket or cushion or diaper is displayed, press the tare button. The weight will be “tared”
to the value of “0.000”.
• Press the “UNIT”button as often as you want to get to the desired weighing unit
• Press the “HOLD”button to save the displayed weight
