Connect+
quick reference guide
1. To set your alarm when leaving home:
a. Close doors and windows until no zones show open.
b. Press the icon that says
ARM AWAY
.
c. The keypad will begin to beep. Exit the home, close the door, and
lock it behind you.
2. To disarm the system when you return home:
a. Press the icon that says
DISARM
and enter your four-digit user code.
3. To set the alarm with a delay when at home:
a. Close doors and windows until no zones show open.
b. Press the icon that says
STAY
.
4. In the morning, or before opening any protected door or window:
a. Press the icon that says
DISARM
, and then enter your four-digit
user code.
5. To set the alarm when at home with no delay:
a. Press the clock icon (top right). The display should change to
INSTANTLY
.
b. Press the
STAY
icon.
6. If an alarm has been triggered:
a. Before proceeding, verify that the alarm was triggered accidentally.
If you aren’t sure, wait for the phone call from central station.
b. If accidental, press the icon that says
DISARM
and enter your
four-digit user code. This will silence the alarm and cancel
dispatch.
Continued on Back
