ELTRA ZEBU 06PLL Manual de usuario

INSTRUCTION MANUAL

model

ZEBU 06PLL

www.eltra.pl

www.audiox.eu

AUDIOX, Narcyzowa 2a, 86-005 Lipniki

- 2 -

Location of Controls

Unit

1. POWER

2. LED Digital Clock Display

3. VOLUME / AL1

4. VOLUME / AL2

5. FM ANTENNA

6. TUNING / HR

7. TUNING / MIN

8. SLEEP

9. SET

10. SNOOZE

11. DIM

12. MEM (Memory)

13. Battery Door

LED Display

14. AL1 buzzer indicator

15. AL1 radio indicator

16. AL2 buzzer indicator

17. AL2 radio indicator

Memory Backup for Time Settings and Preset Stations

It is advisable to fit back-up batteries (not supplied) to the unit to prevent loss of the clock time

(keep operating), alarm time and preset stations settings during a power failure.

1. Slide off the Battery Door (13) from the underside of the unit.

2. Insert 2xAAA size/LR03 (or equivalent) batteries with correct polarity +/- in the battery

compartment

3. Refit the Battery Door (13).

- 3 -

Basic Operation

Standby Mode

After connecting the power supply, the unit is in standby mode and the clock time 0:00 will

flash. Please refer to “Clock and Alarm Time Setting”to set the time. Press the POWER (1)

button to turn on the unit or press it again to go back to the standby mode.

Power On / Radio Mode

Press the POWER (1) button to switch on the unit, the current radio frequency appears on the

display for about 5 seconds, after which the current time indication returns to the display.

Clock and Alarm Time Setting

Clock Time Setting

In standby mode,

1. Press and hold the SET (9) button until the hour and minute

digits flash.

2. Press the HR (6) button to set the hours.

3. Press the MIN (7) button to set the minutes.

4. Press the SET (9) button again to confirm the clock time setting (hour

and minute digits will become solid when finished)

Alarm 1 Time Setting

In standby mode,

1. Press and hold AL1 (3) button until the hour and minute digits flash.

2. Press the HR (6) button to set the hours.

3. Press the MIN (7) button to set the minutes.

4. Press AL1 (3) button again to confirm the alarm 1 time setting (current time indication

returns to the display when finished).

Alarm 2 Time Setting

In standby mode,

1. Press and hold AL2 (4) button until the hour and minute digits flash.

2. Press the HR (6) button to set the hours.

3. Press the MIN (7) button to set the minutes.

4. Press AL2 (4) button again to confirm the alarm 2 time setting (current time indication

returns to the display when finished).

PLEASE NOTE: When operating from batteries only (during back-up mode), the display will

be off and the clock will only remain accurate for a short period of time. The clock accuracy will

decrease due to the voltage drop of the backup batteries. It is important that the mains supply

is restored as soon as possible. If no backup battery is installed or the power interruption is

prolonged, you will need to set the clock again.

- 4 -

Alarm Operation

Wake up by Buzzer or Radio

In standby mode, you can set the alarm mode at the preset alarm times :

1. To set or adjust the alarm time, follow the steps in “Clock and Alarm Time Setting”.

2. To set alarm mode (radio or buzzer) or disable the alarm function for ALARM 1, Press

AL1 (3) repeatedly until the desired alarm mode appears on the display. Each time you

press AL1 (3), the alarm indication changes as follows :

No alarm indication (alarm 1 is disabled) AL1 buzzer indicator (14) 

AL1 radio indicator (15) No alarm indication (alarm 1 is disabled)

3. To set alarm mode (radio or buzzer) or disable the alarm function for ALARM 2, Press

AL2 (4) repeatedly until the desired alarm mode appears on the display. Each time you

press AL2 (4), the alarm indication changes as follows :

No alarm indication (alarm 2 is disabled) AL2 buzzer indicator (16) 

AL2 radio indicator (17) No alarm indication (alarm 2 is disabled)

4. When the preset alarm time is reached, the alarm will sound in the selected alarm mode

unless the alarm function is disabled.

Note: While volume of buzzer alarm is fixed and cannot be adjusted, the volume and frequency

of radio alarm are preset as last tuned. When the radio alarm sounds, you can also adjust the

listening level by VOLUME (3) / (4) buttons. To select the station, refer to “Radio

Operation”.

Review the Alarm Time

In standby mode, press and hold AL1 (3) button for ALARM 1 or AL2 (4) button for ALARM 2

until then the alarm time setting blinks in the display. Press AL1 (3) (for ALARM 1) or AL2 (4) (for

ALARM 2) again to return to the clock time display.

Snooze Function

When the alarm is sounding, press the SNOOZE (10)button to stop the alarm temporarily. The

“AL1/AL2 buzzer indicator (14)/(16) or AL1/AL2 radio indicator (15)/(17)”will keep

blinking while the snooze function is in operation, and the alarm will sound again after about 9

minutes. To stop the alarm, press the POWER (1) button once. The alarm indicator will

become solid and the alarm will function at the same time the next day.

Adjusting the brightness of the display (dimmer control)

Press the DIM (11) button to switch between High or Low dimmer as required.

Radio Operation

Listen to the Radio

1. Press the POWER (1) button to turn on the radio.

The default frequency 87.5 (MHz) (for first use) or the last tuned

frequency will be displayed.

- 5 -

2. Automatic tuning - Press and hold TUNING (6) / (7)button until the frequency

displayed move up or down. Release the button. The tuner will scan and stop for the first

strong station. Repeat until the desired station is reached.

3. Manual fine-tuning - Press TUNING (6) / (7) button repeatedly to adjust the

frequency by each step.

Volume Control

In radio mode, Press the VOLUME (3) / (4) button to adjust the volume level.

Achieve Optimum Reception

Extend the FM antenna (5) fully to increase reception sensitivity.

Program Preset Radio Stations

You can store up to 10 preset stations for radio.

1. Tune in the station you want to preset.

2. Press and hold the SET (9) button until the program number flashes.

Press the SET (9) button again to store the station.

3. Repeat these steps to store additional stations.

Recall a Preset Station

In radio mode, press the MEM (12)button repeatedly to the program number of which the

desired station is stored.

SLEEP TIMER

In radio mode, you can use this function to turn off the unit automatically after a certain duration

(up to 90 minutes).

1. Press the SLEEP (8) button, and“90”is

displayed.

2. Press the SLEEP (8) button repeatedly to select

the duration: 90, 80, 70…. Each time the button is pressed, the duration is reduced by

10 minutes, until “OFF”is displayed.

3. The radio will turn off automatically after the preset duration has elapsed.

4. To check the remaining playing time, press the SLEEP (8) button once.

5. To cancel the sleep function and continue to listen to the radio, press the SLEEP (8)

button again and set the timer to “OFF”. To turn off the radio immediately, press the

POWER (1) button.

Care and Maintenance

Clean the cabinet with a soft cloth moistened with water or mild detergent. Do not use solvents

such as alcohol, benzene or thinner, as they may damage the cabinet finish. Make sure to

disconnect the mains lead from the supply before cleaning.

- 6 -

Caution

1. Do not attempt to disassemble or alter any part of the equipment that is not expressly

described in this guide. Disassembly or alteration may result in high-voltage electrical

shock. Internal inspections, alterations and repairs should be conducted by qualified

service personnel only.

2. Ensure minimum distances of 5cm around the apparatus for sufficient ventilation. Do not

place the product in closed bookcases or racks without proper ventilation. Ensure that the

ventilation is not impeded by covering the ventilation openings with items, such as

newspapers, table-cloths, curtains, etc.

3. No naked flame sources, such as lighted candles, should be placed on the apparatus.

4. It shall not be exposed to dripping or splashing and that no objects filled with liquids, such

as vases, shall be placed on the apparatus.

5. Use of power sources, or batteries not expressly recommended for this equipment may

lead to overheating, malfunction of the equipment, fire, electrical shock or other hazards.

Use only the recommended power source.

6. Do not use or store the equipment in humid or dusty area. Attention should be drawn to

the use of apparatus in tropical and/ or moderate climates.

7. Danger of explosion if battery is incorrectly replaced. Replace only with the same or

equivalent type. Batteries shall not be exposed to excessive heat such as sunshine, fire or

the like. Never throw batteries in fire! Attention should be drawn to the environmental

aspects of battery disposal.

8. Where the mains plug or an appliance coupler is used as the disconnect device, the

disconnect device shall remain readily operable.

9. Marking plate is located at bottom enclosure of the apparatus.

Power Supply and Frequency Range

Power Source : AC230V~50 Hz, 5W

Back-up Batteries : 2 x 1.5V “AAA”size/LR03 batteries or equivalent

(not supplied)

Frequency Range : FM 87.5 –108 MHz

Power Consumption (standby mode) : <1W

Due to continuous product development, design and specifications are subject to change without notice.

Tabla de contenidos

Manuales populares de Radio reloj de otras marcas

Denver

Denver CRQ-105 Manual de usuario

Audiovox

Audiovox CE90 Manual de usuario

Sony

Sony Dream Machine ICF-C763L Manual de usuario

Sanyo

Sanyo DMP-P6 Manual de usuario

RCA

RCA RPC100 Manual de usuario

Yamaha

Yamaha ISX-80 Manual de usuario

Pyle

Pyle PLMR20W Manual de usuario

Blaupunkt

Blaupunkt CR7BK Manual de usuario

Philips

Philips AJ3180 Manual de usuario

HoMedics

HoMedics SS-5500-2EU Manual de usuario

RCA

RCA RC66i Manual de usuario

Versaudio

Versaudio Vers Manual de usuario

SOUNDMASTER

SOUNDMASTER UR8100 Manual de usuario

Audiovox

Audiovox CE90 Manual de usuario

Jensen Audio

Jensen Audio JCR-222 - AM/FM Projection Alarm Clock Radio Manual de usuario

Roberts

Roberts ChronoDAB Manual de usuario

AEG

AEG MRC 4132 BT Manual de usuario

Tokai

Tokai TC-155 Manual de usuario