HOW TO USE
•Before using the device, it's preferable to wax all the hair around the treatment
area. If you can't wax, you can shave the treatment area.
•Insert the power cable into the machine and plug it in.
•Turn on the machine using the touch power button on the left side of the LCD
screen. Press it for 2 or 3 seconds until the device turns on.
•Use the same power button to select the desired power level. Each time you
press the button, the power level will increase. If you do not feel any tingling or
discomfort at the lowest power levels, it's best to select the highest possible
power level.
•You can choose from four treatment modes using the button on the right side of
the LCD screen (work mode switch button): hair removal, hair removal with
cooling, skin rejuvenation, and skin rejuvenation with cooling.
•To switch between hair removal and skin rejuvenation modes, press the "work
mode switch button." HR indicates the hair removal mode, and SR indicates the
skin rejuvenation mode.
•To turn on/off the Ice-cool care mode, press the "work mode switch button" and
hold it down for 2/3 seconds. The snowflake icon indicates that the Ice-cool care
mode is on; otherwise, it's off.
•Place the lamp on your skin, and when the green light on the left side of the
device flashes, press the fire button on the handle of the device. You can repeat
shots in the same area 2 or 3 times for better results. To issue the next shot, wait
for the green light on the left side of the machine to flash again.
•To enable the machine to shoot automatically without pressing the shutter
button, you can enter the automatic use mode. To enter the automatic mode,
press the shutter button for two or three seconds until you hear two beeps. This
