Elite Core PMA Manual de usuario
Two direct symmetric Combo XLR / TRS Inputs
Superior sound over wireless in ear systems
Switch-over for stereo to mix-mono mode 2 x 50mW
Controls for Level and Pan
Sturdy aluminum case with 5/8”-27 internal threads at the bottom, suitable for mounting on
standard microphone stand or SA001 stand adapter
Operates with 9V Battery or included AC/DC adapter
1.
2.
3.
4.
5.
6.
Using this amplifier at too high sound levels may cause permanent hearing loss.
Adjust the volume to a comfortable level. Ringing in the ears can indicate that
the hearing level is too high. Using earbuds with the proper fit will help suppress
the ambient noise and allow the user to adjust the volume to a lower level.
By means of the Pan control the ratio between both channels can
be adjusted.
Adjusts the balance between the L and R channels.
Adjusts the ratio between L and R channels when independent
signals (not stereo) are sent to the two input channels.
The green LED will be lit when the battery is at full power. When both red and green LED’s are
lit it indicates that the battery is close to running down. When just the red LED is lit it indicates
that it is time to change the battery.
Switches the unit on and off.
These combination XLR/TRS balanced jacks connect to the input signal source.
Please use the included AC/DC adapter or equivalent. Plugging in the adapter disengages the
battery.
9V, 100mAH, -PIN +RING
To operate in MONO mode connect your input source to either R or L input, adjust the Pan to
center position, and switch the MODE switch to MIX-MONO.
Otros manuales de Amplificador de Elite Core
