B. SPECIFICATIONS (FIG. l.B)
MODEL
NO."s
Nominal Capacity (KW)
Electrical Rating
FL Amps
(Comp/Motor)
LR Amps
(Comp/Motor)
Power (KW)
Min. Wire Size
Circuit Protection
CAL
CAL
ELECTRIC
136.206 61.206
HEATER
3.7 2.1
1.6
220-240V,
50 Hz.,
Ph. 1
7.0/1.6
4.0/1.6
6.3/1
.6
31.0/4.4
20.0/4.4
14.4
1.7 1.1
1.9
Up to 6 meters, use 1.5
mm2Copper
10 Amp Time Delay Fuse or
10 Amp Circuit Breaker
FIG. l.B
DISC CONDITIONER
A
RATING PLATE %
SERIAL NUMBER
NEOPRENE RUBBER
l * Normal Min.
Generator Size
**
The Manufacturer gives only general guidelines for
Generator-requirements. These Generator require-
ments come from experiences consumers have with
our equipment in field applications. When sizing
Generators, the total electrical power consumption of
the Caravan must be considered. Keep in mind that
Generators lose power because of altitude increases
above sea level, high outside temperatures, and lack
of maintenance.
This air conditioner is prewired for Optional Elec-
tric Heater Package.
NOTE: Some authorities require that this
appliance be Installed only by an authorized
electrician.
2. PRECAUTIONS FOR SAFE
INSTALLATION
A. Read these installation and operating instructions
thoroughly and carefully before attempting installation
of Air Conditioner.
IMPROPER INSTALLATION MAY DAMAGE EQUIP-
MENT, COULD ENDANGER LIFE, CAUSE SERIOUS
INJURY AND/OR PROPERTY DAMAGE.
B.
C.
D.
E.
3.
The Manufacturer will not be liable for any damages or
injury due to failure to follow these installation and
operating instructions.
Installation must comply with all applicable codes and/
or regulations.
DO NOT add any devices or accessories to this
equipment.
This equipment must be serviced only by qualified
service personnel. Some areas require installation
and service personnel to be licensed.
LOCATION
This air conditioner is designed for installation and use on
the roof of a Caravan. One or more units may be used on
the vehicle. Consider the van’s size, roof structure, and
cooling requirements when determining your needs.
A. DESIGN RECOMMENDATIONS
For one unit installation: The air conditioner should be
mounted slightly forward of center (front-to-back) and
centered from side-to-side on the van. (FIG.
3.A.1)
For two
un
it
installation. Install one air conditioner
1/3
and one air conditioner 2/3’s back
from
front of van
and centered from side-to-side. (FIG. 3.A.2)
FIG.3.A.1
LENGTH
FIG. 3.A.2
3
