Electro-Voice RE97S Manual de usuario

Key Features:

• Ultra-Low Profile for Inconspicuous Use

• Lightweight, Durable

• Interchangable for Left or Right Ear

• Omnidirectional Polar Pattern Provides

Clean Sound and Uniform Response

General Description:

The Electro-Voice®RE97S is an Ultra-low profile,

omnidirectional, back-electret condensor headworn

microphone designed for use with standard Shure TA4M

belt packs. The RE97S is intended for spoken word use

such as Houses of Worship, Corporate AV, Theatre, Fixed

Install, and other venues where a full-range, natural, well-

balanced sound is required. The omnidirectional polar

pattern of the RE97S provides a clean and accurate sonic

quality and uniform output regardless of the microphone’s

position relative to the sound source.

The RE97S is designed to be extremely flexible and easily

formed to fit over the ear of any user. The malleable boom

and earhook can be shaped to match virtually any contour.

The TA4F terminated cable is discretely routed behind the

user and attaches to the shirt collar with the elegant clothing

clipincluded,keepingthecableoutofthewayandpreventing

the microphone from being pulled off the user’s ear. The

supplied windscreen can be used in windy environments

and to reduce breath noise.

The RE97S comes with a shielded 4ft cable terminated in a

high quality TA4F connector. It is wired for use with standard

TA4M Shure belt packs, and operates from a 5VDC supply.

Technical Specifications:

RE97S

Micro-Headworn

Condenser Microphone

withTA4F Connector

:tnemelEgnitareneGtertcelekcab,resnednoC

:esnopseRycneuqerFzHk51–05

:nrettaPraloPlanoitceridinmO

zHk1,ytivitisneS :)tiucriCnepO( lacsaP/Vm0.4

:leveLgnippilCLPSBd521>

:esioNtnelaviuqEABd23

:egnaRcimanyDBd39

,ecnadepmItuptuO :zHk1 smho0003

:stnemeriuqeRrewoPCDV5

:noitpmusnoCtnerruCAu013

:ytiraloPmarhpaidnoerusserpevitisoP .2nipnoegatlovevitisopasecudorp

snoisnemiD.ni4.3:)deppihssa(htgnelmooB )mm4.68( )mm00.2(.ni080.0:retemaidmooB )mm50.3(.ni021.0:retemaideluspaC )mm03.2(.ni090.0:retemaidkoohraE

:elbaC)mm59.1(.ni770.0,gnol)m22.1(tf4 retemaid

:gniriWrotcennoCdleihS,dnuorG–1#niP egatloVsaiB–2#niP oiduA–3#niP C/N–4#niP

:dehsinruFseirosseccAneercsdniW pilCgnihtolC gaBgiG

:roloCkcalB,nworB,egieB

:thgieWteN)g71(.zo6.0 )g7.5(.zo2.0:ylnociM

Figures 1 through 3 show the ideal position of the microphone in use. The end of the boom should be located

approximately ½” (13mm) back from the corner of the mouth and as close to the face as possible. This position

will optimize the signal to noise ratio and minimize the acoustic effects of breath noise.

Themicrophonecableisrouted

behind the neck of the user and

secured in place with the supplied

clothing clip as shown in Figure 4

and 5. Allow some slack in the cable

toenabletheuser’shead complete

range of motion in both directions

without pulling the cable from the

clothing clip.

Application Notes:

Figure 1 Figure 2 Figure 3

Figure 4 Figure 5

Figure 6 Figure 7

Fitting:

1.Shape the boom: Figure 6 shows the microphone boom as received. Before placing the microphone over the

user’s ear, apply a slight bend to the boom, starting at the middle of the earhook, to aid the microphone boom in

forming to the user’s face.

The boom can be easily straighten by pinching between the thumb and forefinger, and applying pressure as

your fingers slide away from the earhook. The boom can be reshaped countless times without ill effect on the

performanceofthemicrophoneordegradation of the mechanical structure.

2. Fit to ear: Place the microphone over the ear. Press on the earhook from all sides to form it to the contour of

the ear. The shape of the earhook, as shipped, is designed to comfortably fit many users without adjustment.

To make the fit to the ear more secure, press on the top and bottom of the earhook using thumb and forefinger.

3.Adjust boom length:

If the microphone is positioned too close or too far away from the corner of the mouth (See Figures 1-3 for ideal

position), the boom length can be easily changed by reshaping the bend at the earhook. Figure 9 shows the

microphone as received. To bring the microphone closer to the mouth (i.e. lengthen the boom), simply straighten

out the bend at the earhook (Figure 10), and reapply the bend further up the earhook (Figure 11). To move the

microphone further away from the mouth (i.e. shorten the boom), follow the same procedure, but reapply the

bend further down the length of the boom. Changing the length of the boom will likely require re-shaping of the

microphone to the ear for optimum comfort.

Figure 8

Figure 10

Figure 9

Figure 11

Frequency Response:

12000 Portland Avenue South, Burnsville, MN 55337

Phone:952/884-4051, Fax:952/884-0043

www.electrovoice.com

PartNumber38110-499 RevB

U.S.A. and Canada only. For customer orders, contact Customer Service at:

800/392-3497 Fax: 800/955-6831

Europe, Africa, and Middle East only. For customer orders, contact Customer Service at:

+ 49 9421-706 0 Fax: + 49 9421-706 265

Other International locations. For customer orders, contact Customer Service at:

+ 1 952 884-4051 Fax: + 1 952 736-4212

For warranty repair or service information, contact the Service Repair department at:

800/553-5992 or 402/467-5321

For technical assistance, contact Technical Support at: 800/392-3497 or 952/736-4656

Specifications subject to change without notice.

Polar Response:

Dimensions:

Windscreen Assembly:

Windscreen is supplied with the molded plastic adaptor

alreadyinstalled.

Hold windscreen on the sides at the “A” locations.

Firmly press microphone into adaptor until it stops.

RE97S Mic

Windscreen Adaptor

Otros manuales de Micrófono de Electro-Voice

Electro-Voice

Electro-Voice CO2E Manual de usuario

Electro-Voice

Electro-Voice 664A Manual de usuario

Electro-Voice

Electro-Voice N/D457 Manual de usuario

Electro-Voice

Electro-Voice N/D367s Manual de usuario

Electro-Voice

Electro-Voice N/D767A Manual de usuario

Electro-Voice

Electro-Voice PL88 Manual de usuario

Electro-Voice

Electro-Voice D468 Manual de usuario

Electro-Voice

Electro-Voice RE20 Manual de usuario

Electro-Voice

Electro-Voice RE920Tx Manual de usuario

Electro-Voice

Electro-Voice RE92L Manual de usuario

Electro-Voice

Electro-Voice PL84 Manual de usuario

Electro-Voice

Electro-Voice 205CRA Guía de dimensiones

Electro-Voice

Electro-Voice N468 Manual de usuario

Electro-Voice

Electro-Voice Aviation 903E Manual de usuario

Electro-Voice

Electro-Voice PC-12/FL Manual de usuario

Electro-Voice

Electro-Voice PL5 Manual de usuario

Electro-Voice

Electro-Voice RE200 Manual de usuario

Electro-Voice

Electro-Voice PL92A Manual de usuario

Electro-Voice

Electro-Voice 951 Guía de dimensiones

Electro-Voice

Electro-Voice 927 Manual de usuario

Electro-Voice

Electro-Voice RE1000 Manual de usuario

Electro-Voice

Electro-Voice 667A Manual de usuario

Electro-Voice

Electro-Voice PC Boundary Manual de usuario

Electro-Voice

Electro-Voice N/D967 Manual de usuario

Manuales populares de Micrófono de otras marcas

IK Multimedia

IK Multimedia iRig Stream MIC PRO Manual de usuario

DAPAudio

DAPAudio RM-101 Manual de usuario

AKG

AKG CHM 21 Manual de usuario

Sennheiser

Sennheiser evolution wireless series EM 100 Manual de usuario

Sony

Sony C-48 Manual de usuario

GIGAMEDIA

GIGAMEDIA GGM PAMICUHFG Manual de usuario

Shure

Shure WH30TQG Manual de usuario

auna PRO

auna PRO MIC-900 Manual de usuario

AKG

AKG D 3800 Manual de usuario

Shure

Shure KSM141 Manual de usuario

MAIIN SOUND

MAIIN SOUND IIN style Manual de usuario

Earthworks

Earthworks TC25 Manual de usuario

Sennheiser

Sennheiser evolution D1 Manual de usuario

Alesis

Alesis MicLink Wireless Manual de usuario

DSPPA

DSPPA D6234 Manual de usuario

Monacor

Monacor IMG STAGELINE ECM-300B Manual de usuario

Ansr Audio

Ansr Audio Scan16 Manual de usuario

Shure

Shure MXA710 Series Manual de usuario