3
Programming is carried out by the light emitting diode (LED) and the touch button located on the plate, in the field
marked with a circle and a dot, and the symbol CH1/2.
Transmitter button for CH1.
Press and release the touch button (for less than 3 sec.), the LED will begin to flash. The LED will flash for 5 sec. At this time
press the selected button you want to program for the device on the remote control. If the remote control has been
programmed properly the LED will flash 3 times. The receiver will remain in the remote control programming mode, which will
be indicated by LED flashing. To program another remote control, push the selected key on it. The LED will again flash 3
times, etc. When the LED flashes 2 times, it means that the memory is already full, whereas 1 flash means that the receiver
has left the remote control programming mode and returned to its normal operation. After programming all remote controls
you can exit the programming by briefly pressing the touch button, or the receiver will automatically exit the programming
mode after 5 seconds, which will be confirmed by 1 flash of the LED.
Transmitter button for CH2.
Press and hold the CH1/2 button, the LED will light up, then go out, which indicates that the CH1/2 button should be released.
When you release the button, the LED will begin to flash. The LED will flash for 5 sec. At this time press the selected button
you want to program for the device on the remote control. If the remote control has been programmed properly the LED will
flash 3 times. The receiver will remain in the remote control programming mode, which will be indicated by LED flashing. To
program another remote control, push the selected key on it. The LED will again flash 3 times, etc. When the LED flashes 2
times, it means that the memory is already full, whereas 1 flash means that the receiver has left the remote control
programming mode and returned to its normal operation. After programming all remote controls you can exit the programming
by briefly pressing the touch button, or the receiver will automatically exit the programming mode after 5 seconds, which will
be confirmed by 1 flash of the LED.
Deleting all transmitters from the receiver memory.
Press and hold the CH1/2 button. At this time the LED should light up, go out, then flash 3 times. Release the CH1/2 while the
LED is flashing, it will light up again. Now you need to press and hold the CH1/2 button within 3 seconds until the LED flashes
3 times again and goes out. All transmitters have been removed from the receiver memory.
NOTE.
It is possible to change the control keys of a pre-programmed remote control by re-programming other key on the remote
control. When you are programming changes remember that the unprogrammed key will replace the previously programmed
key. After reprogramming, the key previously programmed on one channel will begin to work in other mode. You can also
delete all the keys from one of the selected channels. You must enter one of the three remote control button modes; when the
LED is flashing press and hold the CH1/CH2 touch button again until the LED lights up and blinks 3 times, then release the
button. All the keys in the selected feature have been deleted.
