ACST-101-BK Speaker Stand Assembly Diagram
Please use the diagram below to assemble the Adante Center Speaker stand. The included spikes improve stability on une-
ven surfaces and thickly carpeted floors. Please use caution when dealing with the spikes
as
they are sharp. A phillips head
screw driveris necessary for installation.
IMPORTANT: When using these spikes on hard surfaces such
as
wood
or
tile floors be sure
to
use the provided floor discs
to protect your floor from damage.
1
2
3
4
5
6
IMPORTANT: The parts
of
this speaker stand are heavy. Please use caution when assem-
bling this stand. Begin by assembling the center posts to the steel bottom plate using the
supplied screws (All
of
the screws are the same). The center post with the wire run hole
should
be
facing the rear with the hole on the top.
Once both center posts have been
mounted
to
the bottom plate attach
the
top
plate with the supplied
screws as shown in step 2.
Attach
the
spikes and top caps
to
the
bottom steel plate as shown in the
diagram
to
the right. Please be care-
ful when picking up the speaker
stand. It is very HEAVY!.
Place the center spe
ak
er levelers
(Included with the Adante Center
Speaker) on the top plates so that
theyare aligned with the speaker
mounting holes.
Next place the Adante Center
speaker on the top plate (with speak-
er
leveler
s)
and securely attach the
speaker
to
thestand using the sup-
plied screws (Longer Screws provid-
ed.
Do
not
over
tighten!).We highly
recommend
us
ing a second person
forthis step
to
ensure thatthe
speaker
do
es notfall.
Once the speaker has been moved
to the final location,adjust the spikes
until the speaker
is
level. To adju
st
the spikes, loosen the
top
cap and
lower
lo
cking disc. Turn the spikes
until the stand is both level and does
not rock. Finally lock the spikes in
position
by
tightening the lower lock-
ing disc and upper t
op
cap.
ll
Step 4
8
Step 3
EL
AC Ada
nt
e Spe
ak
er Stands I
www
.elac.com I
Pa
ge 5
Step 4
n
Step 1
8
