Ekwb EK-Vector Radeon VII Backplate Manual de usuario

INSTALLATION MANUAL

EK-Vector Radeon VII Backplate

BACKPLATE

- 2 -

This product is intended for installation only by expert users. Please

consult with a qualiﬁed technician for installation. Improper installation

may result in damage to your equipment. EK Water Blocks assumes no

liability whatsoever, expressed or implied, for the use of these products,

nor their installation. The following instructions are subject to change

without notice. Please visit our web site at www.ekwb.com for updates.

Before installation of this product please read important notice,

disclosure and warranty conditions printed on the back of the box.

Before you start using this product please follow these basic

guidelines:

Please carefully read the manual thoroughly before beginning

with the installation process!

Please remove your graphics card from the computer to assure

safest mounting process in order to prevent any possible

damages to your GPU and/or graphics card circuit board (PCB).

This product is anticipated to be used exclusively with EK-

Vector Radeon VII GPU blocks and has not been tested with

any factory or aftermarket heatsinks and water blocks. EK does

not provide any assistance or support in the latter application.

- 3 -

TABLE OF CONTENT

INSTALLING THE BACKPLATE 4

IMPORTANT DISCLOSURES 6

REQUIRED TOOLS 6

SUPPORT AND SERVICE 7

SOCIAL MEDIA 7

- 4 -

INSTALLING THE BACKPLATE

STEP 1

PREPARING YOUR GRAPHICS CARD

EK-Vector Radeon VII Backplate is very simple to install, ﬁrst complete

the installation of your EK-Vector Radeon VII Water Block according

to its installation manual. Using a Phillips head screwdriver remove

the 7 screws and their PVC washers which are marked below.

STEP 1

STEP 2

CUTTING THERMAL PADS

Your backplate is supplied with thermals pads that need to be cut into

smaller pieces in order to cover all VRM components. PLEASE REMOVE

THE PROTECTIVE STICKER FROM BOTH SIDES OF THE TERMINAL

PADS PRIOR TO INSTALLATION.

Replacement thermal pads:

1. Thermal PAD F 1.0mm - (120x16mm) - (EAN: 3830046996732)

2. Thermal PAD F 1.5mm - (120x16mm) - (EAN: 3830046996749)

STEP 2

- 5 -

STEP 3

PLACING THERMAL PADS

Once cut to size the thermal pads should be applied to the backplate as

illustrated below. EK made sure to provide customers with more than

adequate quantity of thermal pads to complete this step.

STEP 4

ATTACHING THE BACKPLATE

Place the backplate onto the PCB aligning all of the holes. Position an

M2.5x7 AX1 screw in each of the seven (7) mounting holes marked below

and then tighten them evenly using a Phillips head screwdriver. Do not use

excessive screwing force.

1+2

STEP 4

STEP 3

- 6 -

IMPORTANT DISCLOSURES

VERY IMPORTANT NOTICE

Once the installation is completed, it is a recommended practice to

test the cooling circuit for leaks prior to powering up the computer.

We recommend a 24 hour leak test prior to powering up the

computer. Do not test the water block using city water pressure. This

will rupture the top of the housing and render the block unusable

(and will void your warranty). While all efforts have been made to

provide the most comprehensive tutorial possible, EK Water Blocks

assumes no liability expressed or implied for any consequential

damage(s) occurring to your equipment as a result of using EK Water

Blocks cooling products, either due to errors or omissions on our

part in the above instructions, or due to failure or defect in the EK

Water Blocks cooling products.

WARRANTY

Our products are warranted against defects in materials or

workmanship for a period of 24 months beginning from the date of

delivery to the ﬁnal user. During this period, products will be repaired

or have parts replaced at our discretion provided that: (I) the product

is returned to the agent from whom it was purchased; (II) the product

has been purchased by an end user and has not used for commercial

purposes; (III) the product has not been misused, handled carelessly,

or used in a manner other than in accordance with the instructions

provided describing its installation and proper use. This warranty does

not confer rights other than those expressly set out above and does

not cover any claims for consequential loss or damage. This warranty

is offered as an extra beneﬁt and does not affect your statutory rights

as a consumer. This warranty is voided if the product comes in contact

with aggressive UV additives or other improper liquids. EK blocks are

sealed with warranty void circular label, which proves that the block

has withstood a pressure leak test. Removing it will void leak-free

guarantee and not the guarantee on the product itself. Any other RMA

issues can be reported to EK Support at www.ekwb.com/support for

further analysis.

REQUIRED TOOLS

Phillips-head screwdriver Scissors

For assistance please contact:

http://support.ekwb.com/

EKWB d.o.o.

Pod lipami 18

1218 Komenda

Slovenia - EU

EKWaterBlocks

@EKWaterBlocks

ekwaterblocks

EKWBofﬁcial

SUPPORT AND SERVICE

SOCIAL MEDIA

Tabla de contenidos

Otros manuales de Hardware de computadora de ekwb

ekwb

ekwb EK-XLC PREDATOR 240 Manual de usuario

ekwb

ekwb EK-Classic GPU Water BlockRTX 2080Ti D-RGB Manual de usuario

ekwb

ekwb EK-FB MSI X299 GAMING PRO CARBON RGB... Manual de usuario

ekwb

ekwb EK-FC970 GTX Manual

ekwb

ekwb EK-FB ASUS PRIME X299 Monoblock Manual de usuario

ekwb

ekwb EK-FC590 GTX Guía

ekwb

ekwb EK-FB ASUS M6E Guía

ekwb

ekwb EK-FB KIT EVGA SR-X Manual de instrucciones de instalación

ekwb

ekwb EK-FB RE2 Guía

ekwb

ekwb EK-UNI Manual

ekwb

ekwb EK-FC980 GTX Ti TF5 Series Manual

ekwb

ekwb EK-Nucleus AIO CR360 Vision D-RGB Manual de usuario

ekwb

ekwb EK-UNI RAD Manual

ekwb

ekwb EK-FC1080 GTX FTW Guía

ekwb

ekwb EK-Quantum Momentum2 ROG Strix Z690-I Gaming D-RGB -... Manual de usuario

ekwb

ekwb EK-FC680 GTX FTW Guía

ekwb

ekwb EK-FB MSI X399 GAMING RGB Monoblock Manual de usuario

ekwb

ekwb EK-FC580 DCII Guía

ekwb

ekwb EK-FB GA X470 Gaming 7 RGB Manual de usuario

ekwb

ekwb EK-QuantumX Loophole Distroplate D5 PWM Manual de usuario

ekwb

ekwb SLIM 120 Manual de usuario

ekwb

ekwb EK-FC680 GTX SOC water block Guía

ekwb

ekwb EK-Supremacy MX AMD Series Manual de usuario

ekwb

ekwb EK-FB ASUS X58 Guía

Manuales populares de Hardware de computadora de otras marcas

EMC2

EMC2 VNX Series Manual del propietario

Panasonic

Panasonic DV0PM20105 Manual de usuario

Mitsubishi Electric

Mitsubishi Electric Q81BD-J61BT11 Manual de usuario

Gigabyte

Gigabyte B660M DS3H AX DDR4 Manual de usuario

Raidon

Raidon iT2300 Manual de usuario

National Instruments

National Instruments PXI-8186 Manual de usuario

Hauppauge

Hauppauge WinTV-HVR-2250 Manual de usuario

Kontron

Kontron CP6002 Manual de usuario

Manhattan

Manhattan 702843 Manual de usuario

Aphex

Aphex 230 Manual de usuario

AMD

AMD Phenom II Manual operacional

Intel

Intel NUC 12 Pro Manual de usuario

dbx

dbx Zone Pro 1260 Manual de usuario

Galaxy

Galaxy GHDX2-2430S-24F4D Manual de usuario

Intel

Intel AXXRMFBU4 Manual de usuario

Kontron

Kontron DIMM-PC/MD Manual de usuario

ST X-NUCLEO-SAFEA1B Instrucciones de funcionamiento

STEINWAY LYNGDORF

STEINWAY LYNGDORF SP-1 Manual de usuario

ekwb EK-Vector Radeon VII Backplate Manual de usuario

Manuales populares de Hardware de computadora de otras marcas