NOTE: Letters in (parentheses) refer to the PARTS IDENTIFIER on page 1 and/or the PARTS ASSEMBLY on page 2. Use as needed for clarification.
4
7
9
11
13
SET UP - GTS: UNFOLDING (CONTINUED)
7. Hold the Padded Crossbar (U) with your right hand.
8. Hold the Tower (A) with left hand, while continuing to hold the
Padded Crossbar as shown.
9. Allow the Rails (K, N) to unfold away from the Tower until
the Rails are fully extended. IMPORTANT: Continue holding the
Tower and Padded Crossbar in place.
10. Grasp the Curved Crossbar (O2) or the Rail with your right hand
and raise Rails to Level 3 while pulling the Tower forward until the
Tower Crossbar (Z) sits securely in the Tower Level Hook (R).
11. Tilt Tower slightly backwards until the Support Strut Knob (M) pops
into position. Tighten Support Strut Knob by turning clockwise.
IMPORTANT SAFETY REQUIREMENT:SupportStrut Knob MUST be
engaged and tightened while GTS is unfolded or in use.
CAUTION: To avoid damage to your GTS, the Support Strut Knob
must be loosened and disengaged when folding.
REPOSITIONING GLIDEBOARD
12. To reposition the Glideboard (G) for use, stand or kneel beside the
Glideboard. First lift and pop one side of the metal Glideboard Wheel
Housing (L) away from the Rails. The other side of the Glideboard
should be free. NOTE: The Wheel Housing may feel tight.
13. Lift the Glideboard off the rails to reposition. Disengage the
Glideboard. Move the Glideboard about 6 inches up the Rails toward
the Tower until the metal stop on the underside of the Glideboard
rests above the rubber bumper on the Lower Rail. Lower the
Glideboard back into place.
8
10
12
Padded
Crossbar
rubber
bumper
metal stop
