Edgewater Networks EdgeMarc 4552 Manual de usuario

Page 1 of 7

EdgeMarc 4552

Networking Gateway

Quick Start Guide

Version 1.0

EWN00B-01-A001

Page 2 of 7

Before You Start

Please read this guide thoroughly as it describes the basic installation of

the device. Additional configuration needed to deploy the device in a

specific environment can be performed with the help of online help.

This guide also provides an example of a typical 4552 deployment that

can be used as a guideline for your installation.

Requirements for Installation

•A computer with a web browser such as Microsoft Internet Explorer or

Mozilla Firefox or any other browser of your choice

•At least one Ethernet cable

•Following information supplied by the Internet Service Provider:

oIP address of the WAN interface

oif T1 is being used for WAN connection then:

T1 frame format

Layer 2 protocol such as PPP, Frame Relay/DLCIs, HDLC,

etc.

Page 3 of 7

Instructions

Step 1 Connecting the Cables

1. Connect one end of an Ethernet cable to local LAN port 1 of the 4552. This port can be

seen in the area “B” of the above picture. Connect the other end of the cable to your

computer’s Ethernet port.

2. If T1 is used for the WAN connectivity then perform the following steps, otherwise go to

step 5.

3. Based on the number of functional ports, connect on end of the T1 cable(s) to the T1

port(s), located in area “D” of the above picture, and the other end of the cable(s) to the

T1 demarcation unit provided by the Service Provider.

To reduce the risk of fire, connect the T1 port to the T1 network using only 26

AWG or larger wire such as 24, 22, 20, etc.

4. Skip to step 6.

5. Connect an Ethernet cable between the Ethernet WAN port of the 4552, shown in the

above diagram as “C,” and the Ethernet port on a router or a modem.

6. Plug one end of the power adapter into an AC outlet and the other end into the power

receptacle on the 4552.

Make sure that the power and status LEDs, shown in the diagram below as “A” and “B”,

are solid green after a short while.

Page 4 of 7

Page 5 of 7

Step 2 Configuring the EdgeMarc

1. Launch a web browser on the PC and enter the following URL: http://192.168.1.1 and hit

enter.

2. The following login window should appear:

3. Enter “root” in the “User name” field and “default” in the “Password” field.

4. The “System” page should appear next. If you should see the "message of the day"

instead, just click on the System link under “Configuration Menu” to get to the “System”

page.

5. From the “Configuration Menu” on the left configure the following:

•“Network” – To configure WAN and LAN ports

•Optionally configure “DHCP Server” to suit your needs.

Page 6 of 7

Step 3 Plan Your Configuration

The EdgeMarc 4552 can be deployed as a gateway router in a network. It can also be deployed

in a network behind an existing firewall.

Note: When deploying VoIP services, all connected LAN switches or routers must support full

duplex.

Based on your deployment criteria, consult the following documents for further configuration:

•EdgeMarc 4552 Hardware Installation Guide

•VoIP Operating System (VOS) for EdgeMarc User Manual

Helpful Hints

Although not recommended, the 4552 and IP phones can be installed behind an existing

enterprise firewall. In this instance the firewall will have to be configured to allow access to and

from the 4552’s public IP address for the following ports:

Port Type Firewall Ports to Open

UDP 161 (SNMP) and 162 (SNMPTRAP)

RTP 16386 to 17286

TCP SSH TCP 22 for remote management & TCP 80 for WAN

configuration-downloads

Telnet 23

FTP TCP 21 for stateful TCP-session control from 4508T4W to

Edgewater FTP server

MGCP 2427, 2429, 2432, and 2727

NTP ¬123

SIP 5060 and 5075

IP phones normally point to a local NTP server for their time reference. The NTP port 123

needs to be opened if your network does not have an NTP server.

Please Note: Traffic shaping for this configuration is only available if the enterprise data

devices are also installed behind the 4552.

Page 7 of 7

The web page configurations for the various 4552 deployments are shown below. The two darker-

shaded rows indicate the minimum configuration required for each deployment.

4552

GUI Configuration

Page

4552 as

Gateway

Router

4552 within existing

infrastructure 4552 behind an existing

firewall

Network Yes Yes Yes

VoIP/ALG Yes Yes Yes

NAT Yes Optional Yes

Firewall Yes Optional, but

recommended Optional, but

recommended

DHCP Yes Yes (but should be

disabled if DHCP server

already exists)

Yes (but should be

disabled if DHCP server

already exists)

Traffic Shaper Yes Yes Optional (depends on

network topology)

Traffic Simulator Only for

testing Only for testing Only for testing

System As needed As needed As needed

Please visit our website at www.edgewaternetworks.com or contact the Edgewater Technical

Assistance Center at 408.351.7255 for additional information or assistance.

Edgewater Networks, Inc.

2895 Northwestern Parkway

Santa Clara, CA 95051

Phone: (408) 351-7200

[email protected]

Converged Networking. Simplified.

Tabla de contenidos

Otros manuales de Puerta de Edgewater Networks

Edgewater Networks

Edgewater Networks 4610W Manual

Edgewater Networks

Edgewater Networks EdgeMarc 6400LF2 Manual de usuario

Edgewater Networks

Edgewater Networks EdgeMarc 250W Manual de usuario

Edgewater Networks

Edgewater Networks EdgeMarc 4550 Manual

Edgewater Networks

Edgewater Networks ATT110900764 Manual de lista de piezas

Edgewater Networks

Edgewater Networks EdgeMarc 250W Manual de usuario

Edgewater Networks

Edgewater Networks 200AE1 Manual de usuario

Edgewater Networks

Edgewater Networks 200AE1 Manual de usuario

Edgewater Networks

Edgewater Networks 200AE2 Manual de usuario

Edgewater Networks

Edgewater Networks 4610W Manual de usuario

Edgewater Networks

Edgewater Networks EdgeMarc 250W Manual

Edgewater Networks

Edgewater Networks EdgeMarc 4550 Manual de usuario

Manuales populares de Puerta de otras marcas

LST

LST M500RFE-AS Manual de usuario

Kinnex

Kinnex Media Gateway Manual de usuario

2N Telekomunikace

2N Telekomunikace 2N StarGate Manual de usuario

Mitsubishi Heavy Industries

Mitsubishi Heavy Industries Superlink SC-WBGW256 Manual de usuario

ZyXEL Communications

ZyXEL Communications ZYWALL2 ET 2WE Manual de usuario

Telsey

Telsey CPVA 500 - SIP Manual de usuario

RTA

RTA 460A-NNA4 Hoja de especificaciones

Shaw

Shaw Gateway HDPVR Manual de usuario

ABB

ABB VSN900 Guía de inicio rápido

Commander

Commander Pulse Manual de usuario

2N Telekomunikace

2N Telekomunikace ATEUS EasyGate 501309E Manual de usuario

NETGEAR

NETGEAR C6300BD Manual de usuario

Amit

Amit CDW531AM Manual de usuario

HMS

HMS Netbiter EasyConnect EC150 Manual de usuario

Huawei

Huawei EchoLife HG620 Manual de usuario

AT&T

AT&T U-verse 3801 Manual de uso y cuidado

Logic IO

Logic IO RTCU MX2 turbo Manual de usuario

Suttle

Suttle MediaMAX MXM-521 Manual de usuario