Edge REVOLVER Manual de usuario
User Manual
BEFORE YOU BEGIN .................................................................................................3
LIST OF COMPONENTS ................................................................................. 3
REVOLVER INSTALLATION 95-97 Trucks .................................................................4
REVOLVER INSTALLATION 98-03 Trucks .................................................................7
SWITCH INSTALLATION ..........................................................................................12
SAFETY WARNING & CAUTION ..............................................................................14
SAFETY GUIDELINES ..............................................................................................15
LIMITED 1 YEAR WARRANTY..................................................................................16
VEHICLE WARRANTY INFO.....................................................................................18
2
TABLE OF CONTENTS
3
LIST OF COMPONENTS
REVOLVER
BEFORE YOU BEGIN
Iso-
propyl
SWITCH HARNESS
SCOTCH-BRITE PAD
ALCOHOL PREP PAD
PCM COVER STICKER
SWITCH
1 Remove the keys from the ignition and disconnect both batteries. Failure to do
so may cause damage to the PCM and Revolver.
2 Remove the driver’s side kick panel.
3 Remove the emergency brake bracket by removing the (3) 13mm nuts from the
braket and lay the entire assembly on the oor.
Required Tools
- 13mm Socket
- Screw driver
4
REVOLVER INSTALLATION 1995-1997 Trucks
4 Remove the plastic cap to expose the terminal.
5 With the provided Scotch-Brite pad clean the rubberized protective coating off
of the terminal contacts. Both sides of the terminal need to be cleaned. It is
important that the contacts are sufciently clean to avoid any connection issues.
CAUTION: Be careful when cleaning the connector to not damage the contact
with excessive force.
6 Use the Alcohol Prep pad to wipe away any debris on the terminal contacts.
5
7 Connect the Switch harness to the Revolver and slide the Revolver into the
PCM.
NOTE: Make sure the connector clips together before
installing or the harness could slide out.
8 Cover the opening with the provided PCM cover sticker.
9 Replace the Emergancy Brake and kick panel.
Continue to the Switch installation section.
6
INSTALLATION CONTINUED
7
1 Remove the keys from the ignition and disconnect both batteries. Failure to do
so may cause damage to the PCM and Revolver.
2 Locate the wiring harness on the re wall in the engine compartment that
connects to the PCM. Using a 10mm socket remove the bolt and slide the
connection out of the rewall.
Required Tools
- 10mm Socket - 5.5mm Socket
- 7mm Socket - Screw driver
REVOLVER INSTALLATION 1998-2003 Trucks
3 From inside the cab remove the (2) 7mm bolt holding the computer in place.
For manual trucks this will be a 10mm bolt holding the top and a 10mm nut on
the bottom.
4 Remove the PCM from the truck by sliding it out slowly.
8
INSTALLATION CONTINUED
5 Remove the PCM from the plastic housing and remove the plastic cap exposing
the terminal.
6 With the provided Scotch-Brite pad clean the rubberized protective coating off
of the terminal contacts. Both sides of the terminal need to be cleaned. It is
important that the contacts are sufciently clean to avoid any connection issues.
CAUTION: Be careful when cleaning the connector to not damage the contacts
with excessive force.
NOTE: For better access to clean the terminal contacts. The (6) 5.5mm bolts can be
removed and the PCM split open. This needs to be done in a clean enviroment.
7 Use the Alcohol Prep pad to wipe away any debris on the terminal contacts.
9
8 Connect the Switch harness to the Revolver and slide the Revolver into the
PCM.
NOTE: Make sure the connector clips together before
installing or the harness could slide out.
9 Cover the opening with the provided PCM cover sticker.
10 Slide the PCM back into the plastic housing with the “X” side of the PCM facing
toward the fender.
10
INSTALLATION CONTINUED
Tabla de contenidos
Otros manuales de Accesorios para automóviles de Edge
