Edelbrock 5761 Manual de usuario

EDELBROCK CAT-BACK EXHAUST SYSTEM

For 2000-2002 DODGE DURANGO

4.7L, 5.2L & 5.9L, 2 & 4 wheel drive

Catalog #5761

INSTALLATION INSTRUCTION

Please study these instructions carefully before installing your new Cat-Back Exhaust System. If you

have any questions or problems, contact ourTechnical Hotline at: 1-800-416-8628 from 7 am - 5 pm,

Monday through Friday, Pacific Standard Time or e-mail us at: [email protected].

SUGGESTED TOOLS FOR INSTALLATION:

3/8" ratchet set with SAE and metric sockets

9/16” and 15mm wrenches

Jackstands and jack

Liquid penetrant and rubber lubricant

DISASSEMBLY

1. Raise vehicle and support with proper jackstands for the weight, leaving the suspension hanging.

2. Use caution around hot exhaust systems to avoid burns.

3. Use penetrating oil on all nuts and bolts.

4. Remove the bolts and clamps from the system and lubricate the rubber hangers.

5. Use a long pry bar to pull the rubber hangers off of the pipe hangers.

6. Remove the old system. In some cases, you will find it easier to cut the overaxle pipe to remove

it.

ASSEMBLY

1. Slip the intermediate pipe onto the catalytic converter outlet pipe with the 2-1/2” clamp and just

snug them so you can adjust the pipe easily on the catalytic pipe. Engage hanger onto rubber

factory mounts.

2. Slip the muffler onto the intermediate pipe with a 3” clamp on the front. The offset of the muffler

is the (rear) outlet. Snug the clamp so you can adjust the pipes.

3. Install a 3” U-clamp hanger assembly on the front of the overaxle pipe and engage it into the

stock rubber hangers. Snug the clamps.

4. Install tail pipe hanger, engage into rubber mount. Do not tighten at this time.

Note: You will find there are two different tail pipe hanger assemblies in this system. This was

done because the Durango has two different rear frame configurations. Use whichever hanger

assembly allows you to position the tail pipe under rear bumper properly. With the correct hanger

in place, you can adjust the height of the tail pipe by sliding the hanger forward or back. Tail pipe

gets very hot and can burn plastic bumper if too close.

5. Working from the front of the system, align and tighten each pipe. Check for clearance to body,

frame, and driveline as you tighten the system from front to rear.

6. Using the 3/8 nut supplied in kit, re-install grounding strap to U-clamp of cat-back system.

7. Check for leaks and correct if any is found.

WARNING: Exhaust gas contains carbon monoxide, a deadly invisible gas. Correct any

leaks before driving!

PostScript Picture

(Edelbrock B/W Logo.eps)

KIT CONTENTS

RPM SERIES CAT-BACK EXHAUST

CATALOG #5761

Qty.Part # Description

125-3174 Intermediate Pipe

125-5506 Muffler

123-3151 Overaxle Pipe Assembly

123-4026 Hanger Assembly

123-4027 Hanger Assembly

123-4028 Hanger Assembly

146-5186 3” U-Clamp

146-5185 2-1/2” U-Clamp

Please complete and mail your warranty card. Be sure to write the mode number in the “Part #”

space.

Thank you.

WARNING: Support your vehicle with proper

jackstands or ramps rated for the total vehicle

weight. Place stands so that the rear axle is

allowed to hang free for easy system removal.

WARNING: These cat-back systems are

engineered to fit stock catalytic converters or

equivalent replacements. If your original

system has been modified, Edelbrock will not

warranty fit or performance.

Clamp Hanger Assembly

Overaxle Pipe Assembly

Clamp Hanger Assembly

Intermediate Pipe Assembly

Otros manuales de Pieza de automóvil de Edelbrock

Edelbrock

Edelbrock Russell 672500 Manual de usuario

Edelbrock

Edelbrock 66112 Manual de usuario

Edelbrock

Edelbrock 5276 Manual de usuario

Edelbrock

Edelbrock 67362 Manual de usuario

Edelbrock

Edelbrock 66182 Manual de usuario

Edelbrock

Edelbrock 66022 Manual de usuario

Edelbrock

Edelbrock 4794 Manual de usuario

Edelbrock

Edelbrock ENDURASHINE 63-0299 Manual de usuario

Edelbrock

Edelbrock Victor Glidden 18 2858 Manual de operación y mantenimiento

Edelbrock

Edelbrock 5682 Manual de usuario

Edelbrock

Edelbrock 1801 Manual de usuario

Edelbrock

Edelbrock Edelbrock Header 6525 Manual de usuario

Edelbrock

Edelbrock 1100 Manual de usuario

Edelbrock

Edelbrock 2281 Manual de usuario

Edelbrock

Edelbrock Russell R09392S Manual de usuario

Edelbrock

Edelbrock 6876 Manual de usuario

Edelbrock

Edelbrock 29565 Manual de usuario

Edelbrock

Edelbrock 2980 Manual de usuario

Edelbrock

Edelbrock 66092 Manual de usuario

Edelbrock

Edelbrock 1799 Manual de usuario

Edelbrock

Edelbrock Performer 1403 Manual de usuario

Edelbrock

Edelbrock 1478 Manual de usuario

Edelbrock

Edelbrock 71900 Manual de usuario

Edelbrock

Edelbrock 3862 Manual de usuario

Manuales populares de Pieza de automóvil de otras marcas

Dakota Digital

Dakota Digital 650277 Manual de usuario

bosal

bosal 037031 Manual de usuario

Vintage Air

Vintage Air 571063 Manual de usuario

GFB

GFB EX38 Manual de usuario

bosal

bosal 028091 Manual de usuario

Dodge

Dodge 8W-43 Guía de inicio rápido

ICI

ICI Magnum FBM10DGN Manual de usuario

Volant Perfomance

Volant Perfomance 19435 Manual de usuario

BENDIX

BENDIX GEN 4 GEN 5 ABS Manual de usuario

Vintage Air

Vintage Air 571065 Manual de usuario

Rugged Ridge

Rugged Ridge 11503.13 Manual de usuario

BENDIX

BENDIX CYCLONE DURADRAIN TRAILER WATER Manual de usuario

Porsche

Porsche 968 - ASSEMBLY INSPECTION PROCEDURE AND MAINTENANCE... Guía

Sumitomo

Sumitomo FINE CYCLO FC-A 15 G Manual de usuario

Toshiba

Toshiba 48-1250 A Manual de usuario

aldes

aldes EHT2 Manual de usuario

Go Rhino

Go Rhino 24371T Manual de usuario

BBK

BBK 18950 Manual de usuario