Edelbrock 5276 Manual de usuario

Page

1 of 2

Brochure No. 63-0454

Catalog #5276

Rev. 9/07 - DA/mc

EDELBROCK LOWER TRAILING ARMS

for 2005-2008 Ford Mustang

Catalog #5276

INSTALLATION INSTRUCTIONS

Please study these instructions carefully before installing your new Trailing Arms. If you have any questions, please

contact our Technical Hotline at: 1-800-416-8628, 7:00 am to 5:00 pm, Monday through Friday, Pacific Standard Time

or e-mail us at [email protected].

Application: Designed for 2005-2008 Ford Mustang vehicles. These trailing arms are designed to stabilize the rear

suspension, while improving suspension articulation.

Suggested Tools for Installation:

❑Jack and proper load rated jackstands ❑Blue Locktite

❑Tire chocks ❑Torque wrench

❑Lug wrench ❑Grease gun

❑18mm socket and combination wrench

1. Place vehicle on level surface and place tire chocks

in front of and behind front tires.

2. Support rear of the vehicle on the jackstands and

remove the rear wheels

(See Figure 1)

3. Place a floorjack under the differential and lift up

slightly to remove tension from the trailing arm

bolts. Make sure not to lift the vehicle off the

jackstands

(See Figure 1).

NOTE: Keep floorjack under vehicle during

the complete removal and installation

procedure.

REMOVAL OF STOCK TRAILING ARMS

Fig. 1

CAUTION: Do not remove both trailing arms

at the same time or the axle will rotate and

the trailing arm installation will be much

more difficult.

4. With parking brake released, remove clip from

parking brake cable at brake caliper. Slip cable

out of brake caliper and off of parking brake

arm. Thread cable back through trailing arm

(See Figure 2).

5. Remove trailing arm bolts and trailing arms

(See Figure 3).

6. Clean attachment points with a wire brush.

Fig. 2

IMPORTANT NOTE:

Proper installation is the responsibility of the installer. Improper installation will void warranty and may

result in poor performance and engine or vehicle damage.

Brochure No. 63-0454

Catalog #5276

Rev. 9/07 - DA/mc

Page

2 of 2

Edelbrock Corporation, 2700 California Street, Torrance, CA 90503

Toll-Free Tech Line: 1-800-416-8628

Tech E-Mail: [email protected]

NOTE: Edelbrock trailing arms are fully assembled,

greased, and ready to install. Install new

trailing arms with the grease fittings facing

down.

1. Install the new trailing arm by locating the front

bolt first. NOTE: Spherical ball assembly goes

toward the rear of the vehicle. Use supplied

grease on urethane bushing where bushing

contacts vehicle.

2. Place one drop of blue Loctite on clean threads

and torque the nut to 70 ft./lbs.

3. The trailing arm should then pivot smoothly on

the chassis.

4. Install OEM 14mm rear bolt at the rear of the

arm.

5. Place one drop of blue Loctite on clean threads

and torque the nut to 70 ft./lbs.

(See Figure 3).

INSTALLATION OF EDELBROCK TRAILING ARMS

6. Loop parking brake cable over Edelbrock trailing

arm. Re-attach to parking brake level and clip

to caliper bracket.

7. Although Edelbrock Trailing Arms are pre-lubed,

you may want to finish your installation by

lubing the front and rear bushings with a grease

gun. Be sure to replace the dust caps on the

zerk fittings to prevent dirt and corrosion from

damaging the fitting. Teflon grease is

recommended to lube polyurethane bushings

and a high pressure rated chassis lube works

good for the special ball end of the arm.

Re-check all nut and bolt tightness after first

10 miles.

NOTE: To further upgrade your suspension,

use other Edelbrock suspension

products such as springs, shocks,

panhard rod, sub-frame connectors,

strut tower brace.

Kit Contents

Qty.Description

❑2 Trailing Arm Assembly (#25-4078)

Fig. 3

Tabla de contenidos

Otros manuales de Pieza de automóvil de Edelbrock

Edelbrock

Edelbrock 9629 Manual de usuario

Edelbrock

Edelbrock 2994 Manual de usuario

Edelbrock

Edelbrock 2263 Manual de usuario

Edelbrock

Edelbrock 72285 Manual de usuario

Edelbrock

Edelbrock 5420 Manual de usuario

Edelbrock

Edelbrock 2832 Manual de usuario

Edelbrock

Edelbrock 15015 Manual de usuario

Edelbrock

Edelbrock 3628 Manual de usuario

Edelbrock

Edelbrock 71900 Manual de usuario

Edelbrock

Edelbrock 67112 Manual de usuario

Edelbrock

Edelbrock 41000 Series Manual de usuario

Edelbrock

Edelbrock 70404 Manual de usuario

Edelbrock

Edelbrock Russell R09320 Manual de usuario

Edelbrock

Edelbrock 2162 Manual de instrucciones

Edelbrock

Edelbrock 70027 Manual de usuario

Edelbrock

Edelbrock 1803 Manual de usuario

Edelbrock

Edelbrock 2010 Manual de usuario

Edelbrock

Edelbrock 2828 Manual de usuario

Edelbrock

Edelbrock 97383 Manual de usuario

Edelbrock

Edelbrock Pro-Flo 3 Manual de usuario

Edelbrock

Edelbrock 5721 Manual de usuario

Edelbrock

Edelbrock 65102 Manual de usuario

Edelbrock

Edelbrock 5272 Manual de usuario

Edelbrock

Edelbrock Russell 672500 Manual de usuario

Manuales populares de Pieza de automóvil de otras marcas

Dakota Digital

Dakota Digital 650277 Manual de usuario

bosal

bosal 037031 Manual de usuario

Vintage Air

Vintage Air 571063 Manual de usuario

GFB

GFB EX38 Manual de usuario

bosal

bosal 028091 Manual de usuario

Dodge

Dodge 8W-43 Guía de inicio rápido

ICI

ICI Magnum FBM10DGN Manual de usuario

Volant Perfomance

Volant Perfomance 19435 Manual de usuario

BENDIX

BENDIX GEN 4 GEN 5 ABS Manual de usuario

Vintage Air

Vintage Air 571065 Manual de usuario

Rugged Ridge

Rugged Ridge 11503.13 Manual de usuario

BENDIX

BENDIX CYCLONE DURADRAIN TRAILER WATER Manual de usuario

Porsche

Porsche 968 - ASSEMBLY INSPECTION PROCEDURE AND MAINTENANCE... Guía

Sumitomo

Sumitomo FINE CYCLO FC-A 15 G Manual de usuario

Toshiba

Toshiba 48-1250 A Manual de usuario

aldes

aldes EHT2 Manual de usuario

Go Rhino

Go Rhino 24371T Manual de usuario

BBK

BBK 18950 Manual de usuario