MT-206/MT-207 TrolleyAssembly Instruction
- 8 -
2 Lift the monitor and slide the link board
into the groove of the top splint sideways.
When the board goes halfway, pull down
the pin on the back of the top splint to
allow the board to go through. Keep
pushing the board in until the pin
rebounds and clicks into the hole. The
edges of the Link board and the top splint
should match perfectly at this moment.
Adjusting the height of the Trolley:
WARNING:
For your safety, you’d better take off the
monitor and link board before adjusting
the height of Trolley. Then hold the lifter
rod steadily to avoid hurting yourself.
1 Hold the lifter rod steadily, anticlockwise
rotate the height adjustment handle to
loosen the rod, then adjust the height.
2 After adjusting, clockwise rotate the
handle to tighten the lifter rod.
Adjusting the angle of the top splint:
1 Hold the top splint steadily, anticlockwise
rotate the L-Shape angle adjustment
handle to loosen it. If the handle can not
be rotated for being obstructed by the top
splint, pull it out for about 2mm and
anticlockwise rotate it again. Then adjust
the top splint to a proper angle.
2 After adjusting, clockwise rotate the
handle to tighten it.
Loosen it
Tighten it
Pin
Angle Adjustment
Height Adjustment
Handle
Tighten it
Loosen it
