JS10/2
inspect the power cord before installation.
7. If the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or a similarly qualified person in
order to avoid a hazard.
8. Never use an extension cord as this may overheat and may
cause a fire.
9. Use the heater in a well-ventilated area. Use the heater on flat,
dry surfaces only.
10.Do not place this heater near flammable materials, surfaces or
substances, as there may be a risk of fire. Keep the above
flammable materials, surfaces or substances at least 300mm
from the front of the product and keep them away from the sides
and rear.
11.Do not use the heater in any areas where petrol, paint or other
flammable liquids are stored e.g. Garages or workshops.
12.Don’t use this heater in the immediate surroundings of a bath, a
shower or a swimming pool. Always seek advice in locating a
suitable position for such areas. The heater should be installed
so that cannot be touched by a person using a bath or shower.
13.This heater is hot when in use. To avoid burns and personal
injury, avoid contact for long periods with the heater.
14.Before moving the heater, unplug it and let it cool down for 45
minutes. If provided, use handles when moving the product.
15.Be sure that no other appliances are in use on the same
electrical circuit as your product as an overload can occur. Seek
professional advice from an electrician before installing the
product
16.This appliance is not intended for use by persons (including
children) with reduced physical, sensory or mental capabilities,
or lack of experience and knowledge, unless they have been
given supervision or instruction concerning use of the appliance
