Kit Assembly Instructions
1. Choose appropriate Spacer configuration
1
2a
3.
Insert X-Bracket assembly into the
end of the Sliding Rail and tighten
down screws
4.
Mount RMS assembly to tank
5. Attach Radion to X-Bracket
6. Guide Sliding Rail onto Formed Arm over the locking nut and tighten
screw in desired position
2b
2. Choose appropriate Sliding Rail
for desired front to back position
WARNING: Do not over tighten clamp, over-tightening
may result in damage to your tank or RMS assembly.
1
2a. If using the RMS on a rimmed
tank; leave the included spacer
on the clamp chop.
2b. If using the RMS on a rimless
tank; slide the included spacer off
of the clamp chop.
(XR15)
(XR15) (XR30)
(XR30)
EcoTech Marine, RMS and all slogans are trademarks or registered trademarks of EcoTech Marine LLC. ©2003-2014 by EcoTech Marine LLC All rights reserved.
1
22
2
2
1
1
(XR30)
(XR15)
*XR15 Kit only includes two Sliding Rails.
