www.ecolawnapplicator.com Turf Pros #1 Top dresser P a g e 7 | 16
Using the Ecolawn Applicator for the First Time
Before using the spreader for the first time, make sure the tow bar is extended out far enough to operate
the activation lever. While the spreader has been factory adjusted for immediate use, some minor
adjustments may be necessary. We recommend the following startup procedure to ensure that the machine
is properly adjusted before use.
Step 1. The spreader's belts are new, so they may not adhere perfectly to the pulleys; they may slip a little
when the machine is used for the first time. Before loading the spreader with substrate, run it around empty
for about 10 minutes to allow the belts to become seated properly on the pulleys.
Step 2. Fill the hopper to 1/3 capacity (see Page 8, Step 1), then run the spreader until empty and refill to
this level for the first 3 or 4 loads.
Step 3. Fill the hopper to its maximum capacity (440lbs/200 kg) and begin using the spreader normally.
Step 4. After one hour of use, visually inspect the spreader. Vibrations combined with a heavy load may
occasionally cause nuts and bolts to loosen. Tighten these when necessary.
Step 5. After 8 hours of use, inspect the nuts and bolts again and tighten if necessary.
If some pulleys do not run correctly after these trials, please refer to Ecolawn Application: Troubleshooting
and Adjustments.
