Page 2 of 6
Notes:
1. Larger wires and tight connections will provide longer service life for components. For high current wires it is
recommended that terminal blocks or soldered connections be used with shrink tubing to protect the connections. Do
not use insulation displacement connectors (e.g., 3M Scotchlock type connectors)
2. Route wiring using grommets and sealant when passing through compartment walls. Minimize the number of splices
to reduce voltage drop. High ambient temperatures (e.g., under-hood) will signicantly reduce the current carrying
capacity of wires, fuses, and circuit breakers. All wiring should conform to the minimum wire size and other
recommendations of the manufacturer and be protected from moving parts and hot surfaces. Looms, grommets,
cable ties, and similar installation hardware should be used to anchor and protect all wiring.
3. Fuses or circuit breakers should be located as close to the power takeo points as possible and properly sized to
protect the wiring and devices.
4. Particular attention should be paid to the location and method of making electrical connections and splices to protect
these points from corrosion and loss of conductivity.
5. Ground termination should be only be made to substantial chassis components, preferably directly to the vehicle
battery.
6. Circuit breakers are very sensitive to high temperatures and will “false trip” when mounted in hot enviroments or
operated close to their capacity.
When drilling into any vehicle surface, make sure that the area is free from any electrical wires, fuel lines, vehicle
upholstery, etc. that could be damaged.
Caution!
MONITOR EC7000B-WM
Screen Size 7” (4:3) and (16:9)
Controller 4 Camera
Voltage 12-32 VDC
Power Approximate: 7W
Mirror Imaging Yes (via Camera and Monitor Switch)
Resolution 800 (W) x RGB x 480 (H)
System PAL/NTSC
Viewing Angle L/R/U/D: 60º/60º/45º/60º
Visible Area 154X86mm
Contrast 400:1
Split Screen Feature Quad View Split Screen
AV Compatible No
DVR Compatible No
Audio No
Brightness 400cd/m2
Light Sensor Auto Dim
Camera Selection 1-4 Via Trigger Wires
Connection: CAM DC plug/2 wire
Connection (Monitor Pigtail) Male 6pin/5 wire
Housing Plastic
Mounting Pedestal
Mech. Vibration Pedestal Bracket - 3G
Weight 1.50 lbs / 0.67kg
Dimensions (WxHxD) 176(W) x 123(H) x 27(D)mm
Operating Temp -4°F to 158°F / -20 to +70 oC
Remote Control Yes
Approvals FCC,CE,RoHS
Trigger voltage 12 - 32V
Distance 30 - 100 meters
CAMERA EC2028-WC
Image 1/3 CCD
Voltage Requirement 12-32V
Eective Pixels 628(H) x 582(V)
Power Consumption 5W
Lens Size 1/4”
Lens Angle 120°Horizontal/90 Vertical
Audio No
Light Sensor Auto Switch B&W
Infrared LEDs 18
Housing Aluminum Alloy
Mech. Vibration 8g
Mounting Rear/Front
Weight 1.20 lbs / 0.54kg
Dimensions (WxHxD) (L) 90x (W) 60.5x (T) 56.5 mm
Operating Temp. -4°F to 158°F / -20 to +70 oC
IP Rating IP66
Approvals FCC,CE,RoHS
Current Consumption 500mA Max
Video Delay 150ms
Frame Rate 25fps
System PAL
