EBN Technology X-PPC 710 Manual de usuario

User’s Manual

X-PPC 710

Copyrights

document is subject to change without prior notice in

order to improve reliability, design and function and does

not represent a commitment on the part of the

manufacturer.

This document contains proprietary information

protected by copyright. All rights are reserved. No

part of this manual may be reproduced by any

mechanical, electronic, or other means in any form

without prior written permission of the manufacturer.

All trademarks are property of their respective

owners

Liability Disclaimer

In no event will the manufacturer be liable for direct,

indirect, special, incidental, or consequential

damages arising out of the use or inability to use the

product or documentation, even if advised of the

possibility of such damages.

Regulatory Information

FCC Notices

This equipment has been tested and found to comply

with the limits for a Class A digital device, pursuant to

Part 15 of the Federal Communications Commission

(FCC) Rules. These limits are designed to provide

reasonable protection against harmful interference in

a residential installation. This equipment generates,

uses, and can radiate radio frequency energy and, if

not installed and used in accordance with the

instructions, may cause harmful interference to radio

communications. However, there is no guarantee

that interference will not occur in a particular

installation. If this equipment does cause harmful

interference to radio or television reception, which

can be determined by turning the equipment off and

on, the user is encouraged to try to correct the

interference by one or more of the following

measures:

• Increase the separation between the equipment

and the receiver.

• Connect the equipment into an outlet on a circuit

different from that to which the receiver is connected.

• Consult the dealer or an experienced radio or

television technician for help.

This device complies with Part 15 (A) of the FCC

Rules. Operation is subject to the following two

conditions:

1) this device may not cause harmful interference

and

2) this device must accept any interference received,

including interference that may cause undesired

operation.

NOTE: THE MANUFACTURER IS NOT

RESPONSIBLE FOR ANY RADIO OR TV

INTERFERENCE CAUSED BY UNAUTHORIZED

MODIFICATIONS TO THIS DEVICE. SUCH

MODIFICATIONS COULD VOID THE USER'S

AUTHORITY TO OPERATE THE DEVICE.

CE Notice

This device complies with EMC Directive

2004/108/EC issued by the Commission of the

European Community.

Copyrights

WEEE Notice

The WEEE mark applies only to countries within the

European Union (EU) and Norway.

This appliance is labeled in accordance with

European Directive 2002/96/EC concerning waste

electrical and electronic equipment (WEEE). The

Directive determines the framework for the return

and recycling of used appliances as applicable

throughout the European Union. This label is applied

to various products to indicate that the product is not

to be thrown away, but rather reclaimed upon end of

life per this Directive.

RoHS Notice

This device is full compliance with EU Directive

2002/95/EC (the RoHS Directive) that restricts the

use of the hazardous substances listed below in

electrical and electronic equipment.

Safety Statement for Lithium Battery

ii Copyrights

Contents

Copyrights .................................................................................................i

Liability Disclaimer ...................................................................................i

Regulatory Information.............................................................................i

FCC Notices.......................................................................................................... i

CE Notice .............................................................................................................. i

WEEE Notice........................................................................................................ ii

RoHS Notice ........................................................................................................ ii

Safety Statement for Lithium Battery ................................................................ ii

Contents...................................................................................................iii

1. Hardware Setup....................................................................................4

1.1. Quick Tour .................................................................................................... 4

Front View and Side View .............................................................................. 4

Back Panel I/O ............................................................................................... 5

1.2. Basic Peripherals Installation ..................................................................... 5

Power Adapter ............................................................................................... 5

USB Mouse, USB Keyboard and USB ODD .................................................. 5

LAN Cable...................................................................................................... 6

Cash Drawer .................................................................................................. 6

Customer Display........................................................................................... 6

WiFi Module ................................................................................................... 7

1.4. VESA Wall-mount Kit Installation.............................................................. 10

1.5. Turn on the device.......................................................................................11

2. Basic Driver Installation ....................................................................12

2.1. Before the installation................................................................................ 12

2.2. Chipset Software Installation .................................................................... 12

2.3. VGA Driver Installation .............................................................................. 13

2.4. Touch Screen Driver and Software Utility installation ............................ 15

2.5. LAN Driver Installation............................................................................... 18

3. eGalaxy Touch Control Utility Quick Guide .....................................22

3.1. Launch eGalaxy Touch Control Utility...................................................... 22

3.2. General........................................................................................................ 22

3.3. Settings....................................................................................................... 24

3.4. Tools............................................................................................................ 27

3.5. Edge Compensation .................................................................................. 28

4. I/O Definition.......................................................................................31

5.1. Power Connector ....................................................................................... 31

5.2. Serial Port ................................................................................................... 31

5.3. Cash Drawer ............................................................................................... 31

iii

5 Specification........................................................................................33

Contents

1. Hardware Setup

1.1. Quick Tour

Front View and Side View

LED Indicator

The Power indicator will:

1. glow green when the power is on

2. glow red when the HDD is accessed.

Chapter 1 4

Back Panel I/O

1.2. Basic Peripherals Installation

Remove the rear I/O board cover from the device.

Power Adapter

Connect the DC cable to the DC in jack.

USB Mouse, USB Keyboard and USB ODD

Connect your Mouse and Keyboard to the mouse/keyboard port, and USB ODD

to the USB ports on the back panel of the device.

Chapter 1 5

LAN Cable

Connect one end of RJ-45 LAN cable to the LAN port on the back panel of the

device, another end to your internet device.

Cash Drawer

Connect one end of RJ-11 cable to the Cash Drawer port on the back panel of the

device, another end to your cash drawer.

Install the rear I/O board cover onto the device.

Customer Display

A. Hardware Installation

1. Remove the two screws fixing the customer display cover, and then remover

the VFD mounting hole cove from the device and pull out the connector from the

device.

Chapter 1 6

3. Adjust the hinge of the VFD, and then connect to the device as shown below.

4. Mount the VFD to the device and tighten the two M3 screws as shown below.

5. Finished.

WiFi Module

1. Remove the IO panel cover (if installed) form the device.

Chapter 1 7

2. Un-tighten four screws.

3. Open the device, and you’ll see the two antenna cable fixed by black acetate

tape.

4. Below is the layout of the Wi-Fi module.

Chapter 1 8

6. Assemble the WiFi module, antenna and WiFi module cable as shown.

8. Connect the another end of the WiFi module cable to the 4 pin USB header

(USB 4) on the main board. For the location of the USB4 on the main board,

please refer to the figure below.

9. Reassembly the device.

Chapter 1 9

Otros manuales para X-PPC 710

Tabla de contenidos

Otros manuales de Terminal táctil de EBN Technology

EBN Technology

EBN Technology TM-550 Manual de usuario

EBN Technology

EBN Technology XPOS75-5B-2930 Manual de usuario

EBN Technology

EBN Technology X-PPC 710 Manual de usuario

EBN Technology

EBN Technology XPOS75A-2B-2930 Manual de usuario

EBN Technology

EBN Technology TM-70 Manual de usuario

EBN Technology

EBN Technology XPOS72-2B-2930 Manual de usuario

EBN Technology

EBN Technology X-POS950 Manual de usuario

EBN Technology

EBN Technology EZPPC70-2B-C1G Manual de usuario

EBN Technology

EBN Technology SPOS50-7W-LX800 Manual de usuario

EBN Technology

EBN Technology XPOS72-8B-A16G Manual de usuario

EBN Technology

EBN Technology XPOS85-5W-D525 Manual de usuario

EBN Technology

EBN Technology TM50A-5B-VR Manual de usuario

EBN Technology

EBN Technology POS50A-5B-LX800 Manual de usuario

EBN Technology

EBN Technology XPOS85-5W-D525 Manual de usuario

EBN Technology

EBN Technology TM50-5B-VU Manual de usuario

EBN Technology

EBN Technology PPC-815 Manual de usuario

EBN Technology

EBN Technology XPOS72-2B-A16G Manual de usuario

EBN Technology

EBN Technology POS60-5B-C1G Manual de usuario

EBN Technology

EBN Technology POS70-2EB-370 Manual de usuario

EBN Technology

EBN Technology X-POS855A Manual de usuario

Manuales populares de Terminal táctil de otras marcas

Wincor Nixdorf

Wincor Nixdorf iPOS plus Advanced Manual de usuario

Ingenico

Ingenico AXIUM EX4000 Manual de usuario

Heisei Electronics

Heisei Electronics Q-POS 815 Manual de usuario

Amano

Amano MTX-15 Manual de usuario

FLOWBIRD

FLOWBIRD CWT Compact Touch Manual de usuario

Demco

Demco SP7 Manual de usuario

Lathem

Lathem PC600 Series Manual de usuario

Partner

Partner MF-2352 Manual de usuario

NCR

NCR RealPOS 7460-2 Manual

Simrad

Simrad MS50 Instrucciones de montaje

Unitech

Unitech MR350 MKII Guía de inicio rápido

Jungheinrich

Jungheinrich WMT 210 Manual de usuario

Motorola

Motorola MTP850 Manual de usuario

YASKAWA

YASKAWA 62H-MDC0 Manual de usuario

MVG industries

MVG industries NeptuLink Manual de usuario

Price Industries Limited

Price Industries Limited FDC Manual de instrucciones

Honeywell

Honeywell TemaKey Manual de usuario

EBN

EBN BPC65-B-A16G Manual de usuario