Eaton Power Xpert 9395P Manual de usuario
®
Eaton Power Xpert™9395 High Performance* Field Installed UPM
Mechanical Installation Manual
*Referenced throughout as 9395P
®
Eaton Power Xpert™9395 High Performance* Field Installed UPM
Mechanical Installation Manual
*Referenced throughout as 9395P
IMPORTANT SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTIONS
This manual contains important instructions that you should follow during installation and maintenance of the UPS and batteries. Please
read all instructions before operating the equipment and save this manual for future reference.
CONSIGNES DE SÉCURITÉ IMPORTANTES
CONSERVER CES INSTRUCTIONS
Ce manuel comporte des instructions importantes que vous êtes invité à suivre lors de toute procédure d'installation et de maintenance
des batteries et de l'onduleur. Veuillez consulter entièrement ces instructions avant de faire fonctionner l'équipement et conserver ce
manuel afin de pouvoir vous y reporter ultérieurement.
WARNING
This is a product for restricted sales distribution to informed partners (EN/IEC 62040-2). Installation restrictions or additional measures
may be needed to prevent electromagnetic disturbances.
AVERTISSMENT
Les ventes et la distribution de ce produit sont limitées aux partenaires avisés (EN/CEI 62040-2). Des restrictions en matière d’installation
ou des mesures supplémentaires sont parfois nécessaires pour éviter les perturbations électromagnétiques.
Eaton is a registered trademark of Eaton Corporation or its subsidiaries and affiliates.
ECopyright 2015 Eaton Corporation, Raleigh, NC, USA. All rights reserved. No part of this document may be reproduced in any way without the
express written approval of Eaton Corporation.
Power Xpert 9395P Field Installed UPM Mechanical Installation Manual SP-164000503 Rev 1 i
Table of Contents
1 Introduction 1-1............................................................................
1.1 Using This Manual 1-1....................................................................................
1.2 Conventions Used in This Manual 1-1..........................................................................
1.3 Symbols, Controls, and Indicators 1-3..........................................................................
1.4 For More Information 1-3...................................................................................
1.5 Getting Help 1-4.........................................................................................
2 Safety Warnings 2-1........................................................................
3 Field Installed UPM Installation Plan and Unpacking 3-1...........................................
3.1 Creating an Installation Plan 3-1.............................................................................
3.2 Preparing the Site 3-1.....................................................................................
3.3 Inspecting and Unpacking the FI-UPM Cabinet 3-6.................................................................
4 Field Installed UPM Installation 4-1............................................................
4.1 Preliminary Installation Information 4-1........................................................................
4.2 Unloading the FI-UPM Cabinet from the Pallet 4-1.................................................................
4.3 Mechanical Installation 4-3.................................................................................
4.4 Electrical Installation 4-5...................................................................................
4.5 Initial Startup 4-5........................................................................................
4.6 Completing the Installation Checklist 4-5.......................................................................
5 Warranty W-1..............................................................................
TABLE OF CONTENTS
Power Xpert 9395P Field Installed UPM Mechanical Installation Manual SP-164000503 Rev 1
ii
List of Figures
Figure 1-1. Power Xpert 9395P Field Installed UPM 1-2.............................................................
Figure 3‐1. FI-UPM Cabinet Dimensions (Front View) 3-3............................................................
Figure 3‐2. FI-UPM Cabinet Dimensions (Right Side View) 3-4........................................................
Figure 3‐3. FI-UPM Cabinet Dimensions (Top View) 3-4.............................................................
Figure 3‐4. FI-UPM Cabinet Dimensions (Bottom View) 3-5..........................................................
Figure 3‐5. FI-UPM Cabinet Dimensions (Bottom View with Mounting Brackets) 3-5........................................
Figure 3‐6. FI-UPM Cabinet Center of Gravity 3-6.................................................................
Figure 3‐7. Power Xpert 9395P FI-UPM Cabinet as Shipped on Pallet 3-8................................................
Figure 4-1. Removing the Left Side Shipping Bracket 4-2............................................................
Figure 4-2. Removing the Right Side Shipping Bracket 4-3...........................................................
Figure 4-3. UPS Cabinet Wire Entry Plate and Knockout Locations 4-4..................................................
Power Xpert 9395P Field Installed UPM Mechanical Installation Manual SP-164000503 Rev 1 1-1
Chapter 1 Introduction
The Power Xpert®9395P Field Installed UPM (FI-UPM) provides increased capacity or
N+1 redundancy for Power Xpert 9395P UPS systems. Capacity increase depends on
the capabilities of the originally installed system. The FI-UPM may be installed at any
time when power needs change. The module cabinet installs on the left side of the
UPS cabinet and wires directly to the UPS. No input or output wiring changes are
needed for a capacity increase if the original installation was wired with increased
capacity in mind. Operation remains the same as the original UPS.
The FI-UPM is housed in a single, free‐standing cabinet with safety shields behind the
front panel for hazardous voltage protection. The cabinet matches the UPS cabinet in
style and color. Figure 1‐1 shows the Power Xpert 9395P FI-UPM.
NOTE Wiring, startup, and operational checks must be performed by an authorized Eaton Customer Service
Engineer, or the warranty terms specified on page W-1 become void. This service is offered as part of the
sales contract for the FI-UPM. Contact an Eaton service representative in advance (usually a two-week notice
is required) to request service.
1.1 Using This Manual
This manual describes how to mechanically install the Power Xpert 9395P FI-UPM
cabinet. Electrical installation will be performed by an Eaton Customer Service
Engineer. Read and understand the procedures described in this manual to ensure
trouble-free installation.
1.2 Conventions Used in This Manual
This manual uses these type conventions:
SBold type highlights important concepts in discussions, key terms in procedures,
and menu options, or represents a command or option that you type or enter at a
prompt.
SItalic type highlights notes and new terms where they are defined.
SScreen type represents information that appears on the screen or LCD.
Icon Description
Information notes call attention to important features or instructions.
[Keys] Brackets are used when referring to a specific key, such as [Enter] or [Ctrl].
In this manual, the term UPS refers only to the UPS cabinet and its internal elements.
The term UPS system refers to the entire power protection system – the UPS
cabinet, the battery cabinet, and options or accessories installed.
Figure
INTRODUCTION
Power Xpert 9395P Field Installed UPM Mechanical Installation Manual SP-164000503 Rev 1
1-2
Figure 1‐1. Power Xpert 9395P Field Installed UPM
INTRODUCTION
Power Xpert 9395P Field Installed UPM Mechanical Installation Manual SP-164000503 Rev 1 1-3
1.3 Symbols, Controls, and Indicators
The following are examples of symbols used on the UPS or accessories to alert you
to important information:
RISK OF ELECTRIC SHOCK - Observe the warning associated with the risk of electric
shock symbol.
CAUTION: REFER TO OPERATOR'S MANUAL - Refer to your operator's manual for
additional information, such as important operating and maintenance instructions.
This symbol indicates that you should not discard the UPS or the UPS batteries in the
trash. This product contains sealed, lead‐acid batteries and must be disposed of
properly. For more information, contact your local recycling/reuse or hazardous waste
center.
This symbol indicates that you should not discard waste electrical or electronic
equipment (WEEE) in the trash. For proper disposal, contact your local recycling/reuse
or hazardous waste center.
1.4 For More Information
Refer to the following manuals for additional information:
SEaton Power Xpert 9395P UPS (650 900 kVA) Installation and Operation Manual
SEaton Power Xpert 9395P UPS (1000-1200 kVA) Installation and Operation Manual
These manuals describe:
SUPS cabinet, optional components, and accessory installation instructions,
including site preparation, planning for installation, and wiring and safety
information. Detailed illustrations of cabinets and optional accessories with
dimensional and connection point drawings are provided.
SUPS operation, including UPS cabinet controls, functions of the UPS, standard
features and optional accessories, procedures for starting and stopping the UPS,
and information about maintenance and responding to system events.
SCommunication capabilities of the UPS system.
Visit www.eaton.com/powerquality or contact Eaton service representative for
information on how to obtain copies of these manuals.
INTRODUCTION
Power Xpert 9395P Field Installed UPM Mechanical Installation Manual SP-164000503 Rev 1
1-4
1.5 Getting Help
If help is needed with any of the following:
SScheduling initial startup
SRegional locations and telephone numbers
SA question about any of the information in this manual
SA question this manual does not answer
Please call the Eaton Help Desk at:
United States: 1-800-843-9433 or 1-919-870-3028
Canada: 1-800-461-9166 ext 260
All other countries: Call your local service representative
Otros manuales para Power Xpert 9395P
2
Tabla de contenidos
Otros manuales de Unión Postal Universal de Eaton
Eaton
Eaton 5E650i Manual de usuario
Eaton
Eaton 3S550IEC Manual de usuario
Eaton
Eaton DX 1000 LAN Manual de usuario
Eaton
Eaton Ellipse PRO 650 Manual de usuario
Eaton
Eaton BladeUPS none Manual de usuario
Eaton
Eaton 5SC 1000i Rack2U Manual de usuario
Eaton
Eaton BladeUPS none Manual de usuario
Eaton
Eaton 5A1200I-UNI Manual de usuario
Eaton
Eaton Ferrups FX Manual de usuario
Eaton
Eaton Power Xpert 9395 Manual de usuario
Eaton
Eaton 9395XC Manual de usuario
Eaton
Eaton Powerware 5115 Manual de usuario
Eaton
Eaton 350 VA Manual de usuario
Eaton
Eaton Powerware 9170+ UPS 3-18 kVA Manual de usuario
Eaton
Eaton Single EBC Manual de usuario
Eaton
Eaton 5P 1500 RT Manual de usuario
Eaton
Eaton 93P Manual
Eaton
Eaton Powerware 9120 Manual de usuario
Eaton
Eaton Powerware 9390 Manual de usuario
Eaton
Eaton Powerware 9355 Manual de usuario
Manuales populares de Unión Postal Universal de otras marcas
Pylontech
Pylontech Victron & Pylontech US5000 Manual de usuario
Tecnoware
Tecnoware EVO DSP PLUS MM 6.8 Manual de usuario
Mecer
Mecer ME-1000-WTU Manual de usuario
Mustek
Mustek PowerMust 530(B) Plus Manual de instalación y operación
Emerson
Emerson Liebert NXL series Manual de usuario
MAKELSAN
MAKELSAN BOXER SERIES Manual de usuario
