Eaton Powerware Series Manual de usuario

Powerware Security Detector

User’s Guide

®

Powerware is a registered trademark of Eaton Electrical Inc.

ECopyright 2007 Eaton Corporation, Raleigh, NC, USA. All rights reserved. No part of this document may be

reproduced in any way without the express written approval of Eaton Corporation.

EATON Powerware®Security Detector User’s Guide S164201679 Rev 1 3

Security Detector

IMPORTANT SAFETY INSTRUCTIONS

SAVE THESE INSTRUCTIONS

This manual contains important instructions that you should follow during installation and

maintenance of the security detector. Please read all instructions before operating the

equipment and save this manual for future reference.

The security detector is a device that works with the Eaton Powerware

Environmental Rack Monitor (ERM) and connects to the TH-Module.

Through the ERM, the user can monitor if a door or window is open.

Security detectors are commonly used in burglar alarm systems as

door/window open sensors; however they can be disabled if they are in

a strong, external magnetic field. If a security detector is dropped onto a

hard surface from more than 30 cm (11.8”) or subject to shock of more

than 30G, it is possible to cause the characteristics to change (Pull-in,

Drop-out, etc.).

It is recommended to place security detectors in doors or windows.

Installation

To install the security detector:

1. Loosen the screws on the TH-Module (see Figure 1).

Alarm 1 Alarm 2

Figure 1. Adjusting TH-Module Screws

SECURITY DETECTOR

EATON Powerware®Security Detector User’s Guide S164201679 Rev 1

4

2. Connect the security detector wires to the TH-Module alarm 1 or

alarm 2 connectors, and then tighten the screws on the TH-Module

(see Figure 2).

Figure 2. TH-Module with Security Detector

3. Remove the backing from the security detector sensors and stick

the sensors to the door and doorframe or the window and

windowframe.

4. If you are installing additional security detectors, repeat Steps 1

through 3.

5. Connect the RJ-45 network cable to the TH-Module port labeled

“010101“ (see Figure 3).

Figure 3. Connecting the RJ-45 Network Cable

SECURITY DETECTOR

EATON Powerware®Security Detector User’s Guide S164201679 Rev 1 5

6. Connect the other end of the RJ-45 network cable to the ERM (see

Figure 4).

TH-Module

12

TH-Module-1 TH-Module-2NETWORK RESET 12 VDC

To LAN port To Power Outlet

ERM

Figure 4. ERM and TH-Module

7. Verify that the ERM is connected to the network. Open the ERM

Web page and select Monitoring, then TH-Module-1 Setup or TH-Module-2

Setup. The setup screen displays (see Figure 5).

8. Change the status of the TH-Module from “Disable” to “Auto” on

the Device Name line. Verify that the TH-Module LED

(Power/Status) is flashing.

9. Set the status of alarm 1 and/or alarm 2 to “Normal Close” and

select “Door Contact.”

10. Select Set Value to confirm the security detector setup.

SECURITY DETECTOR

EATON Powerware®Security Detector User’s Guide S164201679 Rev 1

6

Figure 5. Security Detector Settings

11. When the sensor detects the door or window open, the ERM Web

page displays the alarm. The Web page for the alarm table and

sensor events also records the alarm.

Figure 6. Comprehensive View Screen

Figure 7. Events Log Data

Figure 8. Alarm Table

NOTE For more detailed information that is not included in this manual, first register your

product at warranty.powerware.com, then visit our Web site:

www.powerware.com/rackmonitor. You can also download firmware upgrades, the latest

manuals, and other documentation.

*1642016791*

164201679 1

Otros manuales para Powerware Series

12

Tabla de contenidos

Otros manuales de Sensor de seguridad de Eaton

Eaton

Eaton PPD-C-230V Manual de usuario

Eaton

Eaton COOPER POWER SERIES Manual de usuario

Eaton

Eaton URTDII Manual

Eaton

Eaton CEAG GuideLed Cinema 11011 CG-S Manual de servicio

Eaton

Eaton CWGA-0 Series Manual

Eaton

Eaton EF-CBD130 Manual de usuario

Eaton

Eaton CEAG 6811 LED CGLine+ Manual de servicio

Eaton

Eaton CEAG EURO X LED Manual de servicio

Eaton

Eaton DET-REXT-PIR30 Manual de usuario

Eaton

Eaton NexiTech Series Manual de usuario

Eaton

Eaton CEAG Style 22011 CG-S Manual de servicio

Eaton

Eaton Crouse-hinds series Manual de usuario

Eaton

Eaton MAP820 Manual de instrucciones

Eaton

Eaton HaloHome MST20C18W Manual de usuario

Eaton

Eaton All-Pro MS245RW Manual de usuario

Eaton

Eaton 1450-CSA Manual

Eaton

Eaton Xanura BSX1 Manual de usuario

Eaton

Eaton All-Pro MS180 Manual de usuario

Eaton

Eaton HALO MS180 Manual de usuario

Eaton

Eaton 2450 Series Manual de usuario

Eaton

Eaton Sure-Lites UX6 Manual de usuario

Eaton

Eaton xComfort CBMA-02/01 Manual

Eaton

Eaton All-Pro MS180BT Manual de usuario

Eaton

Eaton xComfort CSEZ-01/06 Manual de usuario

Manuales populares de Sensor de seguridad de otras marcas

THORLABS

THORLABS PDA10JT Manual de usuario

Waeco

Waeco UV-DETECT Manual de usuario

Intermatic

Intermatic IOS-DSIMF Manual de usuario

urmet domus

urmet domus 1083 Manual de usuario

Siemens

Siemens AZL66 Series Manual de usuario

BTI

BTI Profiline Multi Finder Manual de usuario

Challenger

Challenger SL01 Manual de usuario

DMP Electronics

DMP Electronics 1122INT Manual de usuario

Rielta

Rielta Ladoga MK-RK Manual de usuario

Mirion Technologies

Mirion Technologies ACCURAD PRD Manual de usuario

Bosch

Bosch DS835 Manual de usuario

DBI SALA

DBI SALA EZ Stop Manual del operador

Lamptime

Lamptime ST05C Manual de usuario

Ubiquiti

Ubiquiti MFI-MSC Manual de usuario

Subsite

Subsite 910R Instrucciones de instalación

Satel

Satel OPAL Pro Manual de usuario

Aleph

Aleph XC-1XTEU Manual de usuario

Pima

Pima LARIS QUAD Manual de usuario