E-Lux Tahoe Manual de usuario
"Tahoe"
E-Lux Fat Tire Electric Beach Cruiser
Owner’s Manual
1760 Monrovia, Ste. A11
Costa Mesa, CA 92627
www.EluxBikes.com
2|Page
Thanks so much for purchasing your new E-Lux Fat Tire Electric Beach
Cruiser and welcome to a world of new possibilities!
With your new electric bike you will be able ride further, faster, and easier
than ever before on a bicycle which equates to Fun, Fun, and more Fun! All
while travelling for less than half a cent a mile it’s not only good for your
wallet but it’s good for the planet!
If you have any questions, suggestions, concerns, or if you just want to say
Happy Trails!
3|Page
Table of Contents
Carton Contents ………………………………..………..4
Bicycle Parts ID Chart …………………………..…..…..5
Assembly………………………………………………….6
Battery Care and Charging…………………………....20
Battery Life ……………………………………………..24
Before Your First Ride ………………………………....24
Understand the Power/Throttle Control ………..…….26
Stopping the Motor ………………………………..…...28
Brakes…………………….………………………….…..29
Gears ……………………………………………..….…..30
Tires ……………………………………………….….....32
Disconnecting Power to Rear Motor…………….….....32
Appearance and Care ….…………………………...….33
Commonly Asked Questions .…….………………........33
Technical Assistance .……………………….……....…..33
Important! Read Before Riding!………………….……34
One Year Limited Warranty ..……………………....…35
Recording Your E-Lux Bike Info .………………….....38
4|Page
Carton/Box Contents
Caution – Please us care when opening box with sharp objects to avoid cutting any bicycle
parts inside.
After opening please check the box for the following content:
1. Bicycle frame with the following attached but not assembled:
A. Front Wheel
B. Handlebar
C. Front Brake Calipers
2. Small Box Containing Battery Charger
3. Small Box Containing Manual, Spair Tool Bag, and Pedals
5|Page
Bicycle Parts ID Chart
6|Page
Assembly
E-Lux suggests taking your electric bike to a professional bike technician for assembly.
This can be done for a nominal fee at your local bike shop. If you are comfortable
assembling it on your own then please refer to the directions below.
Warning – When removing packaging and zip ties do not use box cutters or knives as you may
damage paint or tires. We suggest a pair of scissors.
1. Carefully remove the packing from around bicycle.
2. Carefully cut the zip ties holding the front wheel and handlebars to the frame.
3. Mount front tire to front forks using a 15mm wrench to tighten outside nuts.
7|Page
4. Place bike upright on wheels and kickstand.
5. Apply a small amount of grease inside of the gooseneck tube as well as the threads and
slider on stem of gooseneck.
6. Making sure that all wires and cables are facing front and not twisted; install handlebar
into handlebar stem tightening the two bolts on handlebar stem using an allen wrench.
Tighten handlebar as tight as possible.
8|Page
7. Pull the seat clamp handle out from the seat post to release pressure allowing you to
remove the seat. Remove seat post and apply a small bit of grease inside seat tube. Then
replace seat.
9|Page
8. Caution – When installing pedals there are two separate pedals for the left and right sides
of the bike. They have different thread patterns and it is important to be sure each is
installed on the correct side of the bike to avoid stripping the threads. The following
procedure is performed so that when the bike is pedaled it tightens the pedals.
9. Apply small amount of grease on pedal threads.
10.Right Pedal – Facing the bike from the chain side, place pedal with R on the end of its
bolt on chain side of bike and tighten by turning clockwise (top of wrench turning
towards the front of bike as noted in the picture below.) Tighten pedal very tight.
10|Page
11.Left Pedal – Facing the bike from the kickstand side, place pedal Place remaining pedal
on the kickstand side of bike and tighten by turning counter clockwise (top of wrench
turning towards the front of bike as noted in the picture below.) Tighten pedal very tight.
12.Slide brake calipers over the front brake disc and bolt to front fork using allen wrench.
Tabla de contenidos
Otros manuales de Scooter de E-Lux
