Dyna-Glo EG7500DGC Instrucciones de instalación y funcionamiento
Before the rst use of this heater, please read this USER’S MANUAL
very carefully. This USER’S MANUAL has been designed to instruct
you as to the proper manner in which to assemble, maintain, store,
and most importantly, how to operate the heater in a safe and efcient
manner. Please keep this manual for future reference.
CONSUMER: Retain this manual for future reference.
Questions, problems, missing parts? Before returning to your retailer, call our customer
service department at 877-447-4768 8:00 a.m. - 4:30 pm CST, Monday - Friday.
190625
Electric Garage Heater
INSTALLATION & MAINTENANCE INSTRUCTIONS
7,500W / 240V / 25,590 BTU
EG7500DGC
PET OWNERS WARNING: The health of some small pets including birds are extremely
sensitive to the fumes produced during the rst-time use of many appliances. These fumes are
not harmful to humans but we recommended that you do not use your heater around birds and
small pets during its initial use until the manufacturing corrosion coatings burn off.
When using electrical appliances, basic precautions should always be followed
to reduce the risk of re, electric shock, and injury to persons, including the
following:
1. Read all instructions before installing or using this heater.
2. This heater is hot when in use. To avoid burns, do not let bare skin touch
hot surfaces. Keep combustible materials, such as furniture, pillows,
bedding, papers, clothes, and curtains at least 3 feet (0.9 m) from the front
of the heater and keep them away from the sides and rear.
3. Extreme caution is necessary when any heater is used by or near children
or invalids and whenever the heater is left operating and unattended.
4. Always turn off the power of heater when not in use.
5. Do not operate any heater with the heater malfunctions, has been
dropped or damaged in any manner. Return heater to authorized service
facility for examination, electrical or mechanical adjustment, or repair.
6. Do not use outdoors.
7. This heater is not intended for use in bathrooms, laundry areas and
similar indoor locations. Never locate heater where it may fall into a
bathtub or other water container.
8. Do not insert or allow foreign objects to enter any ventilation or exhaust
opening as this may cause an electric shock or re, or damage the heater.
9. To prevent a possible re, do not block air intakes or exhaust in any
manner. Do not use on soft surfaces, like a bed, where openings may
become blocked.
10. A heater has hot and arcing or sparking parts inside. Do not use it in areas
where gasoline, paint, or ammable liquids are used or stored.
11. Use this heater only as described in this manual. Any other use not
recommended by the manufacturer may cause re, electric shock, or
injury to persons.
IMPORTANT INSTRUCTIONS
SAVE THESE INSTRUCTIONS
This Product can expose you to chemicals including Diisononyl phthalate (DINP) which is known
to the State of California to cause cancer and Di-isodecyl phthalates (DIDP) which is known to the
State of California to cause birth defects or other reproductive harm.
For more information go to www.p65Warnings.ca.gov
WARNING
3
ITEM PAGE #
SPECIFICATIONS........................................................................... 3
SAFETY INFORMATION................................................................. 3
LOCATING HEATER ....................................................................... 4
PRE-INSTALLATION....................................................................... 5
INSTALLATION ............................................................................... 6
OPERATING INSTRUCTIONS........................................................ 10
MAINTENANCE .............................................................................. 12
REPLACEMENT PARTS................................................................. 12
TROUBLESHOOTING .................................................................... 13
1. Use only copper wires rated for at least 60ºC.
2. Heaterairowmustbedirectedparalleltoorawayfromadjacentwall.
3. Observeallwall,oorandceilingclearancerequirements.
4. Allwiringmustbedoneaccordingtonationalandlocalelectricalcodes.The
heatermustbegroundedasaprecautionagainstpossibleelectricalshock.
Heatercircuitmustbeprotectedwithproperfuses.
5. Themountingstructureandtheanchoringhardwaremustbecapableof
supportingtheweightoftheheaterandthemountingbracket(ifused).
Rating AMPS BTU/hour
7500W II 240-1-60 31.25 25590
5000W I 240-1-60 20.9 17065
TABLE OF CONTENTS
SPECIFICATIONS
SAFETY INFORMATION
THISHEATERREQUIRESHARDWIREINSTALLATION(NOPLUG).THEINSTALLATIONOFTHIS
PRODUCT MUST BE CARRIED OUT BY A CERTIFIED ELECTRICIAN AND IN ACCORDANCE WITH
ALL LOCAL AND NATIONAL ELECTRICAL CODES.
NOTE: COMPATIBLE WITH A 240V LINE VOLTAGE DOUBLE POLE WALL THERMOSTAT. MUST BE
INSTALLED BY A CERTIFIED ELECTRICIAN.
READ AND UNDERSTAND ALL INSTALLATION & OPERATION INSTRUCTIONS PRIOR TO
OPERATING THIS UNIT. OBSERVE ALL SAFETY INSTRUCTIONS.
WARNING
4
6. Allelectricalpowermustbedisconnectedatthemainservicebox,which
mustbelockedbeforeconnecting,inspecting,cleaningorservicingthe
heater.Thisisanimportantprecautiontopreventseriouselectricshock.
7. Thisisheaterisnotsuitableforuseinhazardouslocationscontaining
explosiveliquidsorvapours.Thisheaterhashotorarcingorsparkingpads
inside.Donotuseitinareaswheregasoline,paintorammableliquidsare
usedorstored.
8. Thisheaterisnotsuitableforuseincorrosiveatmospheressuchasmarine
greenhousesorchemicalstorageareas.
9. Thisheatermustbemountedatleast8feetofftheoor.Forspecic
clearances,pleaseseenextpage.
Installheaterawayfromtrafcareas,maintainingclearancesstatedingure
2(below).Theairowdirectionshouldnotberestricted(ie.bycolumnsor
machinery).Theairowshouldwipeexposedwallsratherthanblowingdirectly
onthem.Whenmorethanoneheaterisusedinanarea,heatersshouldbe
installedsothattheairdischargeofeachheatersupportstheairowofthe
others,toprovidebestwarmaircirculationasshowningure3.
Figure 2
SAFETY INFORMATION
LOCATING HEATER
IMPROPER INSTALLATION OR FAILURE TO FOLLOW THE PROCEDURES OUTLINED IN THIS
INSTRUCTION MANUAL CAN RESULT IN SERIOUS ELECTRICAL SHOCK.
WARNING
5
Part Description Quantity
AGarageHeater 1
BMountingBracket 1
C Screw 3
DWasher 6
PRE-INSTALLATION
LOCATING HEATER
Figure 3
6
WoodCeiling WoodCeiling
MOUNTING THE BRACKET
RefertoFigures4aand4b.
1.Locateawoodstudinthewoodceilingjoist.Ifyoucannotlocateawood
stud,youhavetoinstallawoodpieceontheceilingasthisheatermustbe
securelyfastened.
2.Removethemountingbracketfromtheheatingunitbylooseningbracket
screwswithawrenchandslippingthehandleoffoverthescrewheads.
3.Placeawasheronscrewsbeforeinsertingthroughtheholesinthemounting
bracketandscrewthemsecurelyintoaceilingjoist.
NOTE:Ifyouwanttoswiveltheheatereithertotherightorleftaddingawasher
tobothsidesofthebracketisrecommended.Alongerlagboltmayberequired
toproperlysecuretheunit.SeeFigure4a.
HANGING THE HEATER
1. Attachtheheatingunittothemountingbracket.
2. Lifttheheaterupandintothemounting
bracket.
3. Alignthebracketscrewswiththekeyholeslots
inthemountingbracket.
4. Iftheheateristobetilteditmustbepositioned
inthekeyholeslots-seegure5.
5. Tightenthebracketscrewswithawrenchso
theunitissecurelysuspendedathorizontalor
verticallevel.
Figure 5
ADJUSTING AIR FLOW DIRECTION
1.Toturntheunitwhenithasbeeninstalled
withasinglelagbolt(asshowningure
4a),simplyturntheentireheaterasneeded.
Theunitcannotbeturnedhorizontallyifit
hasbeeninstalledwith2lagbolts.
2.Totilttheunitvertically,loosenthebracket
screws(seegure5).
Figure 4a. Single-Screw Mounting Figure 4b. Double-Screw Mounting
INSTALLATION
7
MULTIPLE VERTICAL ANGLES
3.Adjustlouverstothedesiredposition(seeFigure6).
NOTE: Thelouversaredesignedsotheycannot
becompletelyclosed.Donotattempttobypassthis
feature;damagetotheunitcanresult.
CEILING
90 degrees
90 degrees
seerged54seerged5.76
45 degrees
INSTALLATION
NOTE: Fortheheatertobetiltedvertically,itmustbemountedinbottomkeyhole
slotsofmountingbracketstomaintainadequateclearanceandpreventpossible
overheating.
Figure 6
TOPREVENTPOSSIBLEELECTRICSHOCK,DISCONNECTPOWERTOTHEHEATERATTHE
MAIN SERVICE BOX BEFORE ATTEMPTING TO ADJUST THE HEAT OUTPUT OF THIS UNIT.
WARNING
8
2500W
2500W
2500W
Switch
KM
KM
1
2
L1
L2
240AC or 208AC
60HZ
External
thermostat
GND
E
Selected
switch
Heater's
thermostat
2500W
2500W
2500W
Switch
KM
KM
1
2
L1
L2
240AC or 208AC
60HZ
External
thermostat
3
4
LINE
RED LOAD
BLACK
External thermostat
Terminal station
1
2
GND
E
Selected
switch
Heater's
thermostat
Selection Switch
(Heater’s thermostat, External thermostat)
Heater’s
thermostat
External
thermostat
CONNECTING THE POWER
If you will use an external temperature control (external thermostat) to control
the heater to be operated or not, please follow below attention points:
1.Makesurethattheheater'stemperaturecontrolknob(thermostatknob)isturned
fullyclockwise.
2.Connectthewireaccordingtobelowwiringdiagram.
INSTALLATION
9
CONNECTING THE POWER
3.Theexternaltemperaturecontrol(externalthermostat)shouldbein
accordancewiththerequirementofULorCSAstandard.
4.Theleadwireofexternaltemperaturecontrol(externalthermostat)cannot
belessthan14AWG.
1.Removethescrewfromthefrontoftheunittoconnectthepowertotheheater.
2.Attachthecableconnectorstotheunit(SeeFigure7)andslidethe10-gauge
wirethroughthecableconnector.
3.Connectthewiretothepowerblocklocatedinthebaseoftheheater-See
Figure7.
4.Turnonthepoweratthemainservice.
NOTE:AllwiringmustbecarriedoutbyaCertiedElectricianandmustbein
accordancetonationalandlocalelectricalcodesintheUnitedStates.Forcertain
applications,conduitmayberequired,SeeFigure7.Checklocalelectricalcodes.
Ifyourunthewiringinconduitandwishtobeabletoturntheheaterbesureto
purchaseenoughexibleconduittoallowtheheatertobeturned.
TO PROTECT THE HEATING ELEMENT
Whenstartingtheheater,turningthetemperaturecontrolclockwiseslowlytoterminal,
theunitstartsthefanrstthenstartstheheatingelement.
Whenshuttingofftheheater,turningthetemperaturecontrolcounter-clockwisetooff,
theheatingelementrstwillturnoffthenthefanwillrunashortcoolingcycleandthen
turnoff.
INSTALLATION
THIS APPLIANCE MUST BE GROUNDED!
THE APPLIANCE MUST CONNECT TO A CURRENT PROTECTION CIRCUIT OR DEVICE AT
50AMP OR LESS BEFORE BEING CONNECTED TO POWER SUPPLY!
WARNING
HIGHTEMPERATURES–RISKOFFIRE.KEEPFLAMMABLEMATERIALS,SUCHAS
FURNITURE,PILLOWS,BEDDING,PAPERS,CLOTHESANDCURTAINSATLEAST3FT.(0.9
M)FROMTHEFRONTANDTOPOFTHEHEATERANDKEEPTHEMAWAYFROMTHESIDES
ANDREAR.TOREDUCETHERISKOFFIRE,DONOTUSEITINAREASWHEREGASOLINE,
PAINT OR FLAMMABLE LIQUIDS ARE USED OR STORED.
CAUTION
10
CONNECTING THE POWER
Connectors,cable,andhardwareusedto
wiretheheater Figure 7Figura 7
Conduit
Connector
Conduit
FlexibleConduit
FlexibleNMCable FlexibleNMCableConnector
FlexibleConduitConnector
WHITE
BLACK
GREEN
(orbarecopper)
3ft
INSTALLATION
OPERATING INSTRUCTIONS
THE HEATER MUST BE PROPERLY INSTALLED BEFORE IT IS USED.
WARNING
7500W 5000W
Control Panel
Power Indicator
(Yellow)
Caution Indicator
(Red)
Thermostat Switch (5000W / 7500W)
Tabla de contenidos
Idiomas:
Otros manuales de Calentador eléctrico de Dyna-Glo
Dyna-Glo
Dyna-Glo EG5600DG Instrucciones de instalación y funcionamiento
Dyna-Glo
Dyna-Glo EG5000P Manual
Dyna-Glo
Dyna-Glo EG10000WB Instrucciones de instalación y funcionamiento
Dyna-Glo
Dyna-Glo GRAB 'N GO HA10BK Manual
Dyna-Glo
Dyna-Glo EG7500DG Manual
Dyna-Glo
Dyna-Glo EG10000DH Manual
Dyna-Glo
Dyna-Glo EG7500DGP Instrucciones de instalación y funcionamiento
Dyna-Glo
Dyna-Glo EG5000DG Manual
Dyna-Glo
Dyna-Glo EG4800DGP Instrucciones de instalación y funcionamiento
Dyna-Glo
Dyna-Glo EG4800DG Instrucciones de instalación y funcionamiento
