Draytek VigorAP 912C Manual de usuario

VigorAP 912C

802.11ac Ceiling-mount Access

Point

Quick Start Guide

Guide Version: 1.0

Region: United Kingdom & Ireland

For updates and support, visit www.draytek.co.uk

October 2019 / Firmware V1.3.0

Note: Product specification is subject to continuous evolution which may

not always be reflected in current documentation. For the formal specification

and details of the supported features of your product, please refer

only to the web site at www.draytek.co.uk

Warranty

We warrant to the original end user (purchaser) that the access point will be free from any defects in

workmanship or materials for a period of two (2) years from the date of purchase from a DrayTek authorized

dealer in the UK/Ireland. Please keep your purchase receipt in a safe place as it serves as proof of date of

purchase. During the warranty period, and upon proof of purchase, should the product have indications of failure

due to faulty workmanship and/or materials, we will, at our discretion, repair or replace the defective products

or components, without charge for either parts or labour, to whatever extent we deem necessary tore-store the

product to proper operating condition. Any replacement will consist of a new or re-manufactured functionally

equivalent product of equal value, and will be offered solely at our discretion. This warranty will not apply if the

product is modified, misused, tampered with, damaged by external factors, used with unapproved accessories or

subjected to abnormal working conditions. Warranty applies to hardware only, not software or firmware. Defects

which do not significantly affect the usability of the product will not be covered by the warranty. We reserve the

right to revise the manual and online documentation and to make changes from time to time in the contents

hereof without obligation to notify any person of such revision or changes.

iii

European Community Declarations

Manufacturer: DrayTek Corp.

Address: No. 26, Fu Shing Road, HuKou Township, HsinChu Industrial Park, Hsin-Chu, Taiwan

303

Product: VigorAP 912C

DrayTek Corp. declares that the radio equipment type VigorAP 912C is in compliance with the following

essential requirements and other relevant provisions of RED 2014/53/EU, ErP 2009/125/EC and RoHS

2015/863/EU, Electro-Magnetic Compatibility (EMC) Directive 2014/30/EU by complying with the

requirements set forth in EN55032/Class B, Low Voltage (LVD) Directive 2014/35/EU by complying with the

requirements set forth in EN62368.

Importer: SEG, 11 Capital Business Park, Borehamwood, Hertfordshire WD6 1GW.

The VigorAP 912C is designed for 2.4GHz and 5GHz WLAN network use in the UK & Ireland.

Join the UK mailing list

Users in the UK & Ireland can sign up to our mailing list which goes

out approximately 4 times per year with products news, updates,

hints & tips and offers. For details, please visit

www.draytek.co.uk/list

Firmware & Tools

Updates

Due to the continuous evolution of DrayTek technology and

emerging risks, router firmware updates may be issued.

Please consult the DrayTek web site for more information on

newest firmware, tools and documents: www.draytek.co.uk (For

UK/Ireland)

Regional and Network Compatibility

For all models, please check that you have been supplied with a device intended for your geographic region

and networks. Hardware and software varies by region, as well as local support and warranty services. To

be sure of compatibility and local support, ensure that you are buying the correct product through

authorized channels. The outside of the product’s box will state the region compatibility (e.g. “Applied

Region: UK”). If you are unsure, check with DrayTek or your supplier. The use of unofficial components (e.g.

PSUs) or adapting interfaces or the use of unauthorized software/firmware may cause malfunction,

product damage or personal danger and invalidates your warranty and access to support services.

Declaration of Conformity

Hereby, DrayTek Corporation declares that the radio equipment type VigorAP 912C is in compliance

with Directive 2014/53/EU.

The full text of the EU declaration of conformity is available at the following internet address:

http://www.draytek.com.tw/ftp/VigorAP 912C/Document/CE/

Manufacturer: DrayTek Corp.

Address: No. 26, Fu Shing Road, HuKou Township, HsinChu Industrial Park, Hsin-Chu County,

Taiwan 303

Product: VigorAP 912C

Frequency Information for Europe area:

2.4G WLAN

2412MHz - 2472 MHz, max. TX power: 19.98dBm

5G WLAN

5160MHz - 5340 MHz, max. TX power: 22 dBm ;

5480MHz - 5720 MHz, max. TX power: 27.13 dBm

 
v 
T
Ta
ab
bl
le
e
 o
of
f
 C
Co
on
nt
te
en
nt
ts
s
 
1. Package Contents ................................................................................................ 1 
2. Product Layout ..................................................................................................... 2 
3. Installation............................................................................................................. 3 
3.1 Ceiling-mount Installation........................................................................................................... 3 
3.2 Attaching VigorAP to the ceiling bracket .................................................................................... 4 
3.3 Suspended ceiling (lightweight steel frame) .............................................................................. 5 
3.4 Wall Mounting............................................................................................................................. 6 
4. Connection and Configuration............................................................................ 7 
4.1 Connecting Cables to the VigorAP............................................................................................. 7 
4.2 Connect to a Vigor Router using AP Management .................................................................... 8 
4.3 Initial Configuration..................................................................................................................... 9 
4.3.1 Connected as a Mesh Node (in Mesh Network)........................................................... 9 
4.3.2 Connected as an Access Point................................................................................... 10 
Method 1 –Web Interface........................................................................................... 11 
Method 2 –DrayTek Wireless app.............................................................................. 15 
Keep up to date with our mailing list.................................................................... 16 
Firmware Updates .................................................................................................. 16 
Getting Help & Support.......................................................................................... 16 
 

VigorAP 912C Main Unit

Ceiling mount bracket &

T-Rail Mounting Kits

(Used for suspended ceiling)

Fixings and Screws

(for ceiling mounting)

RJ-45 Cable (Ethernet)

Screw set (for wall mounting)

UK-type power adapter

Quick Start Guide

Note

⚫Keep mounting accessories away from children.

⚫You should only use the supplied power supply (as shown

above). If you have lost or damaged any components or

accessories, obtain original DrayTek replacements only as

they are safety approved/tested and should ensure that your

unit operates correctly. Contents shown may vary.

⚫Remove the protective film from the access point before use

to ensure ventilation.

⚫The maximum power consumption is 10 Watt.

LED

Status

Explanation

Blue LED

The VigorAP is starting up

Blinking

The VigorAP is ready and operating normally

Green LED

Blinking

System is in Mesh mode or Range Extender mode and

works normally

Orange LED

Blinking

The VigorAP is in TFTP or Firmware Recovery mode

Off

VigorAP is turned off or not functioning

Interface

Explanation

Ethernet Port

Connects to LAN switch or router

Supports PoE power & Gigabit (1000BaseT).

Power Jack (DC IN)

Connector for a power adapter

Hole

Explanation

Factory Reset

Restores the unit back to factory default settings.

To use, insert a small item such as an unbent

paperclip into the hole. You will feel the button

inside depress gently. Hold it for 5 seconds.

The VigorAP will restart with the factory default

configuration and the LED will blink blue.

Status

LED

Factory

Reset

Ethernet

Port

Power Jack

(DC IN)

Your VigorAP can be fitted to walls or ceilings and with the cable entry being

from behind or from the side. Due to the optimized signal pattern, we do not

recommend placing the VigorAP horizontally on a desk or shelf. Run your cables

before you fit the VigorAP or bracket to the ceiling/wall.

-m

For a wooden ceiling, you can use self-tapping screws to fix the mounting

bracket without any other fixings. The screws go through the bracket and then

directly into the wood; no ‘wall-plug’ fixing needs to be used

For ceilings made of

plasterboard, you can use the

self-tapping fixings. Hold the

bracket up to the ceiling to mark

the locations for the screw holes

with a pencil then set the

bracket aside.

Hammer the fixings lightly to

allow the sharp end to penetrate

the plaster and start the hole,

then gently screw the fixing into

the plasterboard with a manual,

not electric, screwdriver (seek

professional help if you are not

experienced with these fixings).

For solid ceilings (e.g. concrete) you will need to assess and provide appropriate

fixing hardware; this is not included with the product.

Warning: The screw set shown below is for wall mounting only. Do

not use it for ceilings as it may not provide adequate support.

With all types of fixing, during installation, always use appropriate

personal safety protection and check for visible or hidden hazards (cables,

joists, pipes) before drilling or fixing.

Consult a qualified installer if you are not experienced.

Install the supplied screws into the back of the AP. These special screws protrude

from the back of the AP, leaving a bayonet type fitting to attach to the bracket:

Lift the VigorAP up to the bracket and connect up the power and Ethernet cables.

Line up the fixing screws and gently rotate the AP in order that the bayonets

connect and ensure a comfortable fit into the slots.

(

)

You cannot screw into ceiling tiles as they are weak and not suitable for bearing

loads. Your VigorAP is supplied with mounts (T-Rail brackets) which attach

directly to the metal grid (‘T-Rail’) of your suspended ceiling.

1. Choose one set of T-Rail mounts to suit the size (gauge) of your T-rail.

2. Fix the mounts into the underside of the VigorAP with the supplied

screws:

3. If a larger gap is required between the ceiling and the VigorAP, use the

extension pieces to extend the height of the brackets.

T-Rail Bracket

Extension Piece

T-Rail Bracket

Extension Piece

Otros manuales para VigorAP 912C

Tabla de contenidos

Otros manuales de Punto de acceso inalámbrico de Draytek

Draytek

Draytek VigorAP 1062C Manual de usuario

Draytek

Draytek VigorAP 910C Manual de usuario

Draytek

Draytek VigorAP 906 Manual de usuario

Draytek

Draytek VigorAP 1000C Manual de usuario

Draytek

Draytek VigorAP 920C Manual de usuario

Draytek

Draytek VigorAP 900 Manual de usuario

Draytek

Draytek VigorAP 910C Manual de usuario

Draytek

Draytek VigorAP 903 Manual de usuario

Draytek

Draytek VigorAP 903 Manual de usuario

Draytek

Draytek VigorAP 802 Manual de usuario

Draytek

Draytek VigorAccess-A48M-2-SFP-A-1-AC Manual de usuario

Draytek

Draytek VigorAP 903 Manual de usuario

Draytek

Draytek VigorAP 800 Manual de usuario

Draytek

Draytek VigorAP 920R Series Manual de usuario

Draytek

Draytek VIGORAP 902 Manual de usuario

Draytek

Draytek VigorAP 960C Manual de usuario

Draytek

Draytek VigorAP 800 Manual de usuario

Draytek

Draytek VigorAP 700 Manual de usuario

Draytek

Draytek VigorAP 810 Manual de usuario

Draytek

Draytek VigorAP 903 Manual de usuario

Draytek

Draytek VigorAP 700 Manual de usuario

Draytek

Draytek VigorAP 700 Manual de usuario

Draytek

Draytek VigorAP 903 Manual de usuario

Draytek

Draytek VigorAP 1000C Manual de usuario

Manuales populares de Punto de acceso inalámbrico de otras marcas

D-Link

D-Link DWL-2100AP - AirPlus Xtreme G Manual de usuario

Ubiquiti

Ubiquiti NanoStation NSM2 Manual de usuario

Cisco

Cisco Aironet 1550 Series Manual de usuario

Aruba

Aruba IAP-335 Manual de usuario

Advantek Networks

Advantek Networks AWN-AP-54MR Manual de usuario

IP-COM

IP-COM AP355 Manual de usuario

Buffalo

Buffalo AirStation WLA-L11G Manual de usuario

EnGenius

EnGenius EnStationACv2 Manual de usuario

D-Link

D-Link DAP-3662 Manual de usuario

xG Technology

xG Technology xMax CN1300 Manual de usuario

Widelink

Widelink ezWave WAP-1100 Series Manual de usuario

Edimax

Edimax CAP1200 Manual de usuario

Ubiquiti

Ubiquiti LBE-5AC-Gen2 Manual de usuario

Aruba

Aruba AP-203R Manual de usuario

LuXout Shades

LuXout Shades LUXSHADE MOTION Manual de usuario

CreatComm

CreatComm TB5F Manual de usuario

SineDigital

SineDigital MW-1500AP(H) Manual de usuario

TP-Link

TP-Link AP9650 V1 Manual de usuario