8. Operation and Use
– 7 –
TO ADD RESULTS: (without using the memory)
• Press button (D) to take the measurement.
• Press button (E) to enter the addition mode.
• The ‘+’ is displayed on the LCD.
• Press button (D) again to take the next reading.
• Press button (E) to display the result.
TO ADD RESULTS: (using the memory)
• Press button (D) to take the measurement.
• Press button (F) to save the current measurement.
• Press button (D) to to take the next reading.
• Press button (E) to enter the addition mode.
• The ‘+’ is displayed on the LCD.
• Press button (G) to recall the previous measurement.
• Press button (E) to display the result.
TO TAKE AREA MEASUREMENTS:
• Press button (H) to enter area mode.
• The symbol will appear on the LCD with the ‘L’
ashing.
• Press button (D) to take the length measurement.
• If the measurement was successful the ‘W’ will begin
ashing.
• Press button (D) to take the width measurement.
• If successful the result in Ft2/M2 will be displayed
under the individual measurement button (D) to cycle
through the two individual measurements or press
button (H) to begin a new area measurement.
• Alternatively, press and hold button (D) for two
seconds to exit the area mode.
Important: It is possible to store an area result in the
memory, take a fresh area measurement and add them
together using button (E).
TO TAKE VOLUME MEASUREMENTS:
• Press button (I) to enter volume mode.
• The symbol will appear on the LCD with the ‘L’
ashing.
• Press button (D) to take the length measurement.
• If the measurement was successful the ‘W’ will begin
ashing. Press button (D) to take the width
measurement.
• If successful the ‘H’ will begin ashing.
• Press button (D) to take the height measurement.
• If successful the result in Ft3/M3 will be displayed
under the individual measurement.
• Press button (D) to cycle through the three individual
measurements or press button (I) to begin a new
volume measurement.
• Alternatively, press and hold button (D) for two
seconds to exit the area mode.
Important: All length, width and height measurements
must be complete to exit the volume mode.
Important: It is possible to store a volume result in the
memory, take a fresh volume measurement and add them
together using button (E).
