DRAGONFIRE 11-0805 Manual de usuario
DragonFire
DragonFire Racing
3191 N. Washington St. Suite 2
Chandler, AZ 85225
1 (800) 708-9803
WWW.DRAGONFIRERACING.COM
Universal Rock Light Kit
Part # 11-0805 Universal Rock light kit 4 pc RGB
Congratulations on your purchase of the DragonFire Rock Light Kit. When it comes to driving off road, rock lights are a great
way to light up the night. This kit offers a convenient way to light up your vehicle with multiple colors that can ash to the beat of
music using bluetooth or a handy key chain remote for your convenience. Be sure to check out the full line of DragonFire Acces-
sories for your vehicle at your local authorized dealer or online at http://www.DragonFireRacing.com
Disclaimer
Off road activities can be hazardous and could lead to injury, dismemberment, paralysis and death. No warranty
of representation is made as to the products ability to protect the user from any injury or death. The user assumes
that risk. The acceptance and /or use of this merchandise purchased from DragonFire by the customer hereby
shall release DragonFire from any and all liability pertaining to the use of such merchandise.
• Read and understand these instructions before installing product
• Regularly inspect
• Do not use product if there are any signs of damage
P3
P2
Part & Hardware List
ITEM QTY Description STEP USED
P1 1 Blue tooth control See attached
directions
P2 1 Remote See attached
directions
P3 4 Rock light step 2 and 3
P4 8 screw step 5
P5 8 nut step 5
P1
Tools Required
Electric Drill
6 mm drill bit
10 mm wrench
DragonFire
Step 4: Install the bluetooth box and route the wiring to the locations for mounting your lights. (Figure B). Make sure to hook up the red wire
(+) and the black wire (-) ground to the correct power bar connection. The blue wire is the antenna for the remote (Do not hook up to power).
Step 5: Drill a hole for each light using .68” bit for the light, screw in place. Rotate the light the direction you want and screw in place with the
screws and nuts provided. Do not over tighten. Over tightening will cause the screws to strip. Recommend putting thread locker on the screw
to keep it from backing off. (Figure B).
Bluetooth and remote control instruction will be included on a sperate instruction form.
This completes installation. Time to ride and enjoy!
Step 1: Place vehicle on a at and level surface. Place gear selector in “Park” and remove keys from the ignition.
Step 2: (Not needed) but, if wiring a rocker switch, extra wire will be needed to run power to the bluetooth / remote control box if desired.
Locate power source, connect (P1) wires to source, and connect to wire harness (P1). (Figure A).
Step 3: Locate desired location for wire harness
Note:
ProTip: Periodically check all hardware and re-tighten if needed.
For further assistance please contact us at customerservice@dragonreracing.com or 1-800-708-9803.
P4
P5
Tabla de contenidos
Otros manuales de Accesorios para automóviles de DRAGONFIRE
DRAGONFIRE
DRAGONFIRE 15-1111 Manual de usuario
DRAGONFIRE
DRAGONFIRE 18-2102 Manual de usuario
DRAGONFIRE
DRAGONFIRE 18-1002 Manual de usuario
DRAGONFIRE
DRAGONFIRE 16-1805 Manual de usuario
DRAGONFIRE
DRAGONFIRE 07-1900 Manual de usuario
DRAGONFIRE
DRAGONFIRE DFR-5TMWM-B Manual de usuario
DRAGONFIRE
DRAGONFIRE 04-0045 Manual de usuario
DRAGONFIRE
DRAGONFIRE RacePace 01-3801 Manual de usuario
DRAGONFIRE
DRAGONFIRE 04-0820 Manual de usuario
DRAGONFIRE
DRAGONFIRE 01-2924 Manual de usuario
