uninstructed metal framing and on Metro wire shelving. Place a lock
washer and flat washer on the lock knobs and secure the device
using center holes on mounting tab. Be sure to install fiber washer.
The hooks provide for chain mounting or mounting on wire shelving.
Install overhead blower by using outer holes on mounting tabs.
Chains and mounting hardware (not supplied) must have a
minimum safe working load of 15kg.
4.2 Electrical
The SCHNEIDER DC-003 requires 220V/110V for proper operation.
The device must be grounded for safe operation. The device comes
with line cord, without plug. A plug must be installed on the line
cord for operation. Installation of the plug must be performed by
qualified personnel. The color cord for wiring the plug is as follows:
Red-line; Blue-Neutral; Green/Yellow-Ground.
5. OPERATION
Activate the DC-003 Overhead Ionizing Air Blower by turning
ON/OFF switch. Set airflow as desired by adjusting FAN SPEED knob.
To clean ion emitter points, take off the air outlet panel and clean it
with a brush carefully.
The time required to neutralize a static charge on an item in the air
stream depends on fan speed. Setting a higher fan speed reduces
time required to neutralize a static charge.
When the DC-003 blower is used in an electronic assembly area, the
ionized air stream should cover as much of the working area as
possible. The constant flow of ionized air will prevent items such
as work surfaces, tools, materials and components from developing
a static charge. Charged items introduced into a work area will be
