Doro Magna 4000 Manual de usuario

English

Doro Magna 4000

A B

60dB

8765

English

1. Handset volume control

2. Speaker

3. Service access keys

4. Hanging peg for handset

5. Clear

6. OK

7. Speed dial keys

8. Caller ID (access received

numbers)

9. New call indicator

10. Up/Down

11. Phonebook

12. Menu

13. Recall

14. Redial

15. Extra amplification (boost)

16. Amplifier on/ringer indicator

17. Speaker on

English

Installation

This device is intended for the analogue telephone network lines in AT,

BE, BG, CH, CY, CZ, DE, DK, EE, ES, FI, FR, GB, GR, HU, IE, IS, IT, LV, LT,

LU, MT, NL, NO, PL, PT, RO, SI, SK, SE.

Connection

1. Connect the curly cord to the handset and to the socket marked

Qon the unit.

2. Connect the mains adapter to an electrical wall socket and then to

the socket marked DC 12V on the unit.

3. Connect the telephone line cord to a network wall socket and then

to the socket marked Ton the unit.

4. Lift the handset and listen for the dial tone.

Note! Use supplied telephone line cord, an existing cord from a previous

phone may not be compatible.

Setup

The setup menu is opened directly after plugged into the mains. The

phone will return to standby mode after 60 seconds of inactivity or when

pressing b. Confirm with 0and the next setting is displayed. Scroll with

v/V. Access the setup menu at any time with .

1. Press .

2. ENGLISH is displayed.

3. Select desired language using v/V. Press 0.

4. Select desired contrast setting (LCD CONTRAST, 2=normal) using

v/V. Press 0.

5. Select desired hour (00-23) using v/V. Press 0.

6. Select desired minute using v/V. Press 0.

7. Select desired day using v/V. Press 0.

8. Select desired month using v/V. Press 0.

9. Select TONE or PULSE using v/V. Press 0.

Note! If unsure of which mode to use, select TONE as this works in

most locations.

10. Select FLASH TIME using v/V(100 for EU/GB/AUS, 270 France/

Portugal and 600 New Zealand). Press 0.

English

11. NEW CALL IND. is displayed, press 0. Enable/disable the LED indi-

cator for new calls. Select ON/OFF, and confirm with 0.

12. Buttons 1and 2can be programmed with service access num-

bers. SERVICE ACCESS is displayed, press 0. Use v/Vto select

KEY 1 or KEY 2, and then press 0. Use the keypad to edit/enter

the access number. Press 0. Enter the name for the service. Press

Changing the clock, language or contrast

If you wish to change the settings for time or language etc. later on, re-

peat steps as above.

Batteries

4 x AA alkaline batteries are needed for the display operation (no back-

light) in the event of a power cut. Extra amplification (boost) and speaker-

phone will not work in the event of a power cut.

When is displayed, replace all 4 batteries. Use only good quality

batteries.

1. Unplug the telephone cord and remove the battery cover.

2. Insert the batteries (4 x AA) ensuring that the correct battery polarity

is observed.

3. Replace the battery cover and connect the telephone cord.

Wall mounting

The telephone can be wall mounted by using the included wall mount

bracket and two screws.

WARNING

Make sure that no cables, water pipes or gas pipes are located inside

the wall before drilling into it.

1. Drill two holes in the wall, vertically 83 mm apart.

2. Insert the screws, allowing them to project ~5 mm out from the wall.

3. Unplug and remove the handset.

4. Fit the guide tabs (A) on the bracket into the slots (B) on the back of

the telephone, then slide the bracket upwards until it snaps into

place.

English

5. Position the phone so that the screws on the wall fit into the slots in

the bracket, then slide the phone downwards until it is hanging on

the screws.

6. Remove the handset hook (C) by pushing it upwards, and insert it in

the reversed position so that the small tab (D) protrudes. The hook

will now keep the handset in the cradle when the phone is wall

mounted.

7. Replace the handset, on the hanging peg, in the hook switch.

Operation

The display

In standby mode the date and time is indicated on the display, the total

number of calls that have been stored in the Caller ID memory, and the

number of new calls. See also Message, p.8.

Timer

During a call the display shows a call timer, indicating the duration of the

call. The timer is a simple way to help you keep track of how long the call

lasts.

English

Make a call

Normal call

1. Lift the handset.

2. Enter the phone number.

Pre dial

Pre dial allows you to enter and change a phone number before it is

dialled.

1. Enter the phone number. Delete with c.

2. Lift the handset to dial.

Re dial

Re dial allows you to call the last dialled phone numbers.

•Lift the handset and press to dial the most recently dialled phone

number.

•Repeatedly press to scroll through the dialled numbers. Lift the

handset to dial the phone number.

Handsfree/speakerphone

It is only possible for one person at a time to talk in handsfree mode.

Avoid loud background noises, e.g. music, as this interferes with the

handsfree function.

1. Press to activate the handsfree function.

2. Enter the phone number.

3. Press to end the call.

Tip: You can switch between handset and handsfree mode during a call,

press or lift the handset.

Service access dial

Shortcut keys to operator service access numbers.

1. Press and hold or 1or 2until the service access number is

displayed.

2. Lift the handset, press 0or to dial.

English

Volume control

The handset volume may be adjusted during a call with located

under the handset when not used.

The handset tone may be adjusted during a call with located on

the side of the phone.

Note! The tone control only works when the extra amplification is active.

To adjust the speakerphone volume (handsfree), use located on

the side of the phone.

Extra amplification (boost)

Press the

60dB

button to activate amplification. When activated the Am-

plifier on light is lit. The amplification is deactivated at the end of each

call to avoid harming people with normal hearing.

WARNING

The handset/headset volume can be turned up very loud. The

amplification should only be used by people with impaired hearing

ability.

Hearing aid compatible

WARNING

Do not use extra amplification (boost) together with a hearing aid if not

necessary. The handset volume can be turned up very loud.

This telephone is hearing aid compatible. Select the T-mode on your hear-

ing aid to use this feature. Hearing-aid compatibility is not a guarantee

that a specific hearing aid will work with a specific telephone. To ensure

that a specific hearing aid works well with this telephone, test them to-

gether before making a purchase.

T: To use your hearing aid in this mode, make sure that your hearing aid

is set to "T-mode" or telecoil coupling mode (not all hearing aid have this

mode). For the best results, try using the telephone in different positions

relative to your hearing aid-for example, placing the receiver slightly be-

low or in front of the ear may result in better performance.

English

Ringer

The ringer volume may be adjusted using the switch located on the

side of the phone.

Speed dial

You can use A,Bas speed dials.

Storing speed dial numbers

1. Press and hold until STORE NUMBER is displayed.

2. Enter the phone number. Press .

3. Enter the name. Press .STORAGE PLACE? is displayed.

4. Select A–Bby pressing the corresponding key. SAVED is displayed

Speed dial

1. Press the speed dialling keys Aand B. The stored phone number

is displayed.

2. Lift the handset, press 0or to dial.

Phonebook

The phonebook will store 50 sets of names and phone numbers. Con-

tacts in the phonebook are arranged alphabetically. Each name can be

up to 16 characters in length, and phone numbers can be up to 22 digits

in length.

If you subscribe to a Caller ID service, the name/number of the caller will

be shown when you receive an incoming call (for those numbers stored

in the phonebook or the memories).

Note! To access the phonebook features make sure that bis displayed.

If is displayed, press b.

Character table

Each number key has been allocated certain characters.

1[Espace] + & - / X 1

2A B C Å Ä Æ æ å ä ß 2

English

3D E F ë 3

4G H I ï 4

5J K L 5

6M N O Ñ ñ Ö əö 6

7P Q R S 7

8T U V 8 Ü ü

9W X Y Z 9

*` @ ( ) * < >

0, . : ? = 0

#$ _ % ! #

Storing contacts

1. Press b.

2. Press and hold until SAVE? is displayed. Press .

3. Enter the phone number. Press .

4. Enter the name. Press the corresponding digit key for the first letter,

one or more times, see Character table.

5. Press .SAVED is displayed.

If you need to insert a pause in the phone number press . Mistakes

can be erased with c.

Dialing from the phonebook

1. Press b.

2. Scroll using v/V. Quick search by pressing the corresponding digit

key for the first letter, one or more times, see Character table.

3. Press 0, and lift the handset.

Edit contacts

1. Press b.

2. Scroll to the desired entry using v/V.

3. Press and hold until EDIT? is displayed.

4. Press and hold .

5. Correct/change the number using cand v/V. Press .

English

6. Correct/change the name, see Character table. Press . SAVED is

displayed.

Deleting contacts

1. Press b.

2. Scroll to the desired contact using v/V.

3. Press cthe display shows DELETE?.

Tip: To delete all contacts, press and hold cuntil DELETE ALL? is

displayed.

4. Hold cdown until the number disappears.

Caller ID (caller identification)

Caller ID allows you to see who is calling before you answer a call and to

see who has called in your absence. If the number is stored in the phone-

book, the caller’s name will be shown. Received calls are stored chrono-

logically, the sequential number shown on the display.

When the Caller ID memory is full, the oldest number will be deleted au-

tomatically as the new call is logged. New calls are indicated on the dis-

play and indicated with T, the New call indicator flashes.

Note! In order for numbers to be shown you must subscribe to the Caller

ID service provided by your network operator. Contact your operator for

more information.

Retrieving and dialling incoming numbers

1. Press .

2. Press v/Vto scroll through received phone numbers/calls.

3. Press 0and lift the handset.

Message

Apart from phone numbers, the display can show:

OUT OF AREA No information received, e.g. an international call

PRIVATE The call comes from a withheld number or a PBX

TNumber not previously seen

Otros manuales para Magna 4000

Tabla de contenidos

Otros manuales de Teléfono de Doro

Doro

Doro PhoneEasy 312cs Manual de usuario

Doro

Doro 6521 Manual de usuario

Doro

Doro PhoneEasy 337ip Manual de usuario

Doro

Doro AFTI 22 Manual de usuario

Doro

Doro CONGRESS 150 Manual de usuario

Doro

Doro NeoBio 40 Manual de usuario

Doro

Doro PHONEEASY RECORD 327CR Manual de usuario

Doro

Doro CONGRESS 305 Manual de usuario

Doro

Doro ALERTACALL 200E Manual de usuario

Doro

Doro th50 Manual de usuario

Doro

Doro PhoneEasy 312ci Manual de usuario

Doro

Doro X20 Manual de usuario

Doro

Doro AUB 200 Manual de usuario

Doro

Doro AUB 300i Manual de usuario

Doro

Doro HearPlus 317ci Manual de usuario

Doro

Doro COMFORT 3005 Manual de usuario

Doro

Doro MemoryPlus 319i ph Manual de usuario

Doro

Doro PhoneEasy 311C Manual de usuario

Doro

Doro SECURE 350 Manual de usuario

Doro

Doro 7030 Manual de usuario

Doro

Doro HEARPLUS 313CI Manual de usuario

Doro

Doro 80 Manual de usuario

Doro

Doro TEL 8 PLUS Manual de usuario

Doro

Doro X30 Manual de usuario

Manuales populares de Teléfono de otras marcas

GE 2-9480 Manual de usuario

Geemarc

Geemarc PHOTOPHONE 155 Manual de usuario

D-Link

D-Link DWR-720/PW Manual de usuario

Interquartz

Interquartz Gemini IQ333 Manual de usuario

SSS Siedle

SSS Siedle HT 840-0 Manual de usuario

Motorola

Motorola TITANIUM Manual de usuario

Panasonic

Panasonic ICX Manual de usuario

LG H870DS Manual de usuario

Samsung

Samsung GT-I9500 Manual de usuario

AT&T

AT&T Trimline 205 Manual de usuario

Selta

Selta zenyth 600 Manual de usuario

UNIQCELL

UNIQCELL A1 Manual de usuario

Panasonic

Panasonic KX Series Manual de usuario

Jabra

Jabra SP5050 - Bluetooth hands-free Speakerphone Manual de usuario

BT Decor 425 Manual de usuario

NEC

NEC SV8500 Manual de usuario

Teledex

Teledex PEARL Manual de usuario

Ericsson

Ericsson Dialog 3213 Manual de usuario