Dixon 312 Manual de instrucciones

TECHNICAL DATA

ZTR Model 312

IMPORTANT -READ OPERATOR'S MANUAL BEFORE OPERATING OR MAKING ADJUSTMENTS

SEAT ADJUSTMENT

1. Pull or lift body retention latch P/N 3934

from transaxle backing plate,raise

and push body and seat assembly

forward.

2. Loosen four seat adjustment knobs P/

N 1849 and slide seat forward or

backward to desired position.

3. Re-tighten seat adjustment knobs P/N

1849. DO NOT operate mower without

seat adjustment knobs properly

tightened.

4. Close upper body and push retention

latch. P/N 3934 over transaxle backing

plate.

IXON INDUSTRIES. INC. A

BLOUNT COMPANY AIRPORT

INDUSTRIAL PARK

PO BOX 1569

COFFEYVILLE KS 67337 0945

316 251 2000

FAX 316 251 4117

REMOVING THE BODY

1. The 312 has a two-piece polyethylene body. The upper body can be folded forward to

expose the transaxle. In some cases, it may be necessary to remove the upper body to

service the transaxle.

2. To remove upper body, remove two bolts P/N 3093 from the front of upper body hinge

located on the brake shaft P/N 9283. Disconnect seat switch P/N 4761 at plug-In.

3. Reverse above procedure to reinstall.

ADJUSTMENT OF MOWER DECK DRIVE BELT

1. This mower deck drive belt is tensioned by a spring loaded engagement Idler quadrant.

2. This system Is designed to maintain the proper belt tension at all times.

3. Belt tension can be adjusted by moving the engaging rod P/N 7013 into the outside hole of

engagement handle P/N 7020.

4. After belt tension is adjusted, check to assure that the mower blade will not turn freely when

the engaging rod is in the "OFF" position.

5. If the mower blade turns freely, adjust the blade brake by loosening nut P/N 3205 at the end

of the brake rod P/N 2988.

6. After adjustment is achieved, perform the safety checks listed below.

REMOVING THE MOWER BLADE

Secure blade P/N 2483 from turning. Remove blade bolt from centerof blade P/N 3268, and

blade washer P/N 6260 then remove blade P/N 2483. To reinstall. reverse above procedure.

WARNING: Sharp edges on blade can cause injury!

Caution should be exercised when service is required on blade.

REMOVING THE MOWER DECK

1. Loosen belt keepers P/N 7026 & 7027 located under the engine by loosening two rear

engine

mounting bolts, allowing the deck drive belt to come free of the rear pulley.

2. Disconnect the wiring loom at the deck safety switch P/N 4242.

3. Remove the two clevis pins P/N 3072 from the two rear L-rods P/N 1355 and slide from slots.

4. Remove clevis pin P/N 3072 from L-rod attached to lift handle and slide from slot.

5. Remove clevis pin P/N 3072 from front deck hanger shaft P/N 1332, located at front of mower

deck on slide plates welded at battery box, and remove.

6. Lift front of mower chassis clear of deck. Roll chassis free of the deck.

7. To install, reverse the above procedure. . ~ .

MOWER BLADE OPERATION

To engage mower blades, turn engagement lever on floor slowly to the "ON" position. To

Disengage mower blades, turn leverslowly to the "OFF" position.

SAFETY CHECKS

IMPORTANT-PERFORMSAFETYCHECKSAFTERMAKINGANYREPAIRSORADJUSTMENTS

•' •'-'••••'

1. After reassembly, while seated on mower, attempt to start engine with mower deck

engaged. Engine should not start. If engine does start, returnthe mower to an Authorized

Dixon dealer for adjustment or repair.

2. Disengage mower deck and start engine. With the operator In the normal seated position. ,

engage mower deck and remove weight from seat. The engine should stop. If the engine

does not stop when operator rises from seat, return the mower to an Authorized Dixon

dealer for adjustment or repair.

3. Engage then disengage mower blade in each cutting height. Insure that blade disengages

and comes to a stop within (5) seconds in each height position. If blade does not

disengage properly, contact your Authorized Dixon dealer.

CAUTION: DO NOT OPERATE MOWER IF ANY SAFETY FEATURE IS NOT FUNCTIONING CORRECTLY

PARKING BRAKE ADJUSTMENT

Remove the body as described above. Tighten nut on brake rod P/N 2533 located In front of

the transaxle on each side, just enough to prevent brake from slipping when engaged.

CAUTION: Over-tightening may cause premature wear on the brake band P/N 5085

Revised 2/93

P/N 8114,

312 BODY ASSEMBLY

312 CHASSIS ASSEMBLY

312 TRANSAXLE ASSEMBLY

312 MOWER DECK ASSEMBLY 30'

312 WIRING ASSEMBLY

Este manual sirve para los siguientes modelos

Otros manuales de Cortacésped de Dixon

Dixon

Dixon KODIAK KODIAK 52 Manual de usuario

Dixon

Dixon Ram Ultra 50 Manual de usuario

Dixon

Dixon ZTR 5501 Manual de usuario

Dixon

Dixon ZTR 5601 Manual de usuario

Dixon

Dixon D25KH48 Manual de usuario

Dixon

Dixon ZTR 503 Manual de usuario

Dixon

Dixon ZTR Zero Turn Riding Mower Manual de usuario

Dixon

Dixon ZTR 4000 series Manual de usuario

Dixon

Dixon D17KH38 Manual de usuario

Dixon

Dixon ztr dx260 Manual de usuario

Dixon

Dixon Ultra 52 Manual de usuario

Dixon

Dixon ZTR 52 - 27 KOH Manual de usuario

Dixon

Dixon ZEETER HL 42 Manual de usuario

Dixon

Dixon ZTR 4000 series Manual de usuario

Dixon

Dixon ZTR 5020 Manual de usuario

Dixon

Dixon D22KH42 Manual de usuario

Dixon

Dixon ZTR 5421 Manual de usuario

Dixon

Dixon ZTR 4500 Series Manual de usuario

Dixon

Dixon RAM 50 Manual de usuario

Dixon

Dixon ZTR SPEEDZTR 48SE Manual de usuario

Dixon

Dixon ZTR 1950-2300 Series Manual de usuario

Dixon

Dixon SpeedZTR 46 CE Manual de usuario

Dixon

Dixon SSPDZTR 30 Manual de usuario

Dixon

Dixon ZTR 3000 Series Manual de usuario

Manuales populares de Cortacésped de otras marcas

RHINO

RHINO 1958 Manual de usuario

Wolf Garten

Wolf Garten Compact plus 40 B Manual de usuario

Cub Cadet

Cub Cadet LTX 1045 Manual de usuario

Craftsman

Craftsman 917.378461 Manual de usuario

GGP ITALY SPA

GGP ITALY SPA CR/CS 434 SERIES Manual de usuario

Challenge

Challenge CH18V2 Instrucciones de operación

TALEN TOOLS

TALEN TOOLS AVR HGM30 Manual de usuario

DEWEZE

DEWEZE ATM-725 Manual de operación

Weed Eater

Weed Eater 180083 Manual de usuario

Husqvarna

Husqvarna Poulan Pro PP185A42 Manual de usuario

Better Outdoor Products

Better Outdoor Products Quick Series Manual de usuario

Cub Cadet

Cub Cadet 23HP Z-Force 60 Manual de funcionamiento

MTD

MTD 795, 792, 791, 790 Manual de usuario

Toro

Toro Groundsmaster 3505-D Manual de usuario

Dennis

Dennis FT 610 Manual de usuario

AIRFORCE

AIRFORCE F-15 Gen 3 Manual de usuario

MTD

MTD 126-220-000 Manual de usuario

Toro

Toro 74806 Manual de usuario