Allure EC-Sensor-T_IG_10_EN
4. Mounting Instructions
The Allure EC-Sensor-T sensor has been specially designed for easy
installation. However, certain conditions apply when choosing a suitable
location for the device:
- Install the device in a location of average temperature approximately 5
ft (1.5 m) above the floor
- The device should not be installed on an exterior wall.
- The device should not be installed near a heat source.
- The device should not be installed near an air discharge grill.
- The device should not be installed in a place where it can be affected by
the sun.
- Install the device in an area that provides proper device ventilation.
Nothing must restrain air circulation to the device.
Wall Mounting Installation Procedure
The Allure EC-Sensor-T sensor can be mounted on a dry wall using supplied
screws.
1. Remove the security screw from the device (Figure 5-1).
2. Open the device by pressing in the two (2) tabs on the bottom of the
device and pulling the bottom side of the front plate out.
3. Pull all cables 6” (15cm) out of the wall, and insert them through the
central hole of the back plate.
4. Align the back plate with the wall and mark the location of the mounting
holes on the wall. Make sure to orient the proper side of the back plate
facing upwards.
5. Remove the back plate and drill holes in the wall if necessary.
6. Install anchors in the wall if necessary.
7. Make sure that the mounting surface is flat and clean.
8. Screw the back plate onto the wall. Do not over tighten.
9. Strip each wire if needed and connect each one according to the wiring
diagram shown in this document (Figure 7-1).
10. Gently push excess wiring back into the wall.
11. Reattach the front plate and make sure it clips tightly into place.
12. Install security screw.
Electrical Junction Box Installation Procedure
The Allure EC-Sensor-T sensor can be mounted in most American, European
or Asian style electrical junction box using screws.
1. Remove the security screw from the device (Figure 5-1).
2. Open the device by pressing in the two (2) tabs on the bottom of the
device and pulling the bottom side of the front plate out.
3. Pull all cables 6” (15cm) out of the wall, and insert them through the
central hole of the back plate.
4. Screw the back plate onto the electrical junction box.
5. Strip each wire if needed and connect each one according to the wiring
diagram shown in this document (Figure 7-1).
6. Gently push excess wiring back into the electrical junction box.
7. Reattach the front plate and make sure it clips tightly into place.
8. Install security screw.
5. Device Components
