DirectOut Technologies BREAKOUT Series Instrucciones de instalación
BREAKOUT Series
Hardware Guide
Version 2.0
page 2 of 16 BREAKOUT Series Hardware Guide - Version 2.0
Copyright
All rights reserved. Permission to reprint or electronically reproduce any document or
graphic in whole or in part for any reason is expressly prohibited, unless prior written
consent is obtained from the DirectOut GmbH.
All trademarks and registered trademarks belong to their respective owners. It cannot
be guaranteed that all product names, products, trademarks, requisitions, regulations,
guidelines, specifications and norms are free from trade mark rights of third parties.
All entries in this document have been thoroughly checked; however no guarantee for
correctness can be given.
DirectOut GmbH cannot be held responsible for any misleading or incorrect
information provided throughout this manual.
DirectOut GmbH reserves the right to change specifications at any time without notice.
DirectOut Technologies® is a registered trademark of the DirectOut GmbH.
© DirectOut GmbH, 2021
page 3 of 16BREAKOUT Series Hardware Guide - Version 2.0
Table of contents
About This Manual 5
How to Use This Manual............................................................................... 5
Conventions .................................................................................................. 5
Chapter 1: Overview 6
Introduction ................................................................................................... 6
Feature Summary.......................................................................................... 7
CHAPTER 2: Legal issues & facts 8
Before Installing This Device......................................................................... 8
Defective Parts/Modules ............................................................................. 8
Intended Operation ...................................................................................... 9
Updates ......................................................................................................... 9
Conditions of Warranty ................................................................................. 9
Conformity & Certificates ........................................................................... 10
Contact........................................................................................................ 10
Contents ..................................................................................................... 11
Accessories................................................................................................. 11
Chapter 3: Installation 12
Installing the Device ................................................................................... 12
CHAPTER 4: Technical Data 14
Appendix A - DSUB-25 Pin assignment 15
page 4 of 16 BREAKOUT Series Hardware Guide - Version 2.0
This page is left blank intentionally.
page 5 of 16BREAKOUT Series Hardware Guide - Version 2.0
About This Manual
About This Manual
How to Use This Manual
This manual guides you through the installation and operation of the device.
Use the Table of Contents at the beginning of the manual or Index Directory at the
end of the document to locate help on a particular topic. You can access more
information and latest news by visiting on the DirectOut website at
www.directout.eu.
Conventions
The following symbols are used to draw your attention to:
TIPS
indicate useful hints and shortcuts.
NOTES
are used for important points of clarification or cross references.
WARNINGS!
alert you when an action should always be observed.
page 6 of 16 BREAKOUT Series Hardware Guide - Version 2.0
Chapter 1: Overview
Chapter 1: Overview
Introduction
The BREAKOUT series is a range of adaptor boxes available in different variants to
extend the coverage of the ANDIAMO and PRODIDGY series. They are equipped
with XLR or BNC connectors on the front panel and DSUB-25 connectors on the
rear panel. Audio signals are carried passively between the front and rear panels.
The small form factor and angle brackets also allow for mounting the devices on
the back of an ANDIAMO or PRODIGY unit.
BREAKOUT.AN8 - analog input / output, 8 channels
Article code: DOBOB0889
BREAKOUT.AN16I - analog input, 16 channels
Article code: DOBOB0890
BREAKOUT.AN16O - analog output, 16 channels
Article code: DOBOB0891
page 7 of 16BREAKOUT Series Hardware Guide - Version 2.0
Chapter 1: Overview
BREAKOUT.AES - digital input / output, 8 AES3 ports (16 channels)
Article Code: DOBOB0887
BREAKOUT.AESID - digital input / output, 16 AESid ports (32 channels)
Article Code: DOBOB0888
Feature Summary
BREAKOUT.AN8 8 x XLR connector male
8 x XLR connector female
2 x DSUB-25 (AES59 analog pinout - 'TASCAM')
BREAKOUT.AN16I 16 x XLR connector female
2 x DSUB-25 (AES59 analog pinout - 'TASCAM')
BREAKOUT.AN16O 16 x XLR connector male
2 x DSUB-25 (AES59 analog pinout - 'TASCAM')
BREAKOUT.AES 8 x XLR connector male
8 x XLR connector female
2 x DSUB-25 (AES59 digital pinout - 'TASCAM')
BREAKOUT.AESid* 16 x BNC connector (75 Ω)
4 x DSUB-25 (AES59 digital pinout - 'TASCAM')
* Impedance and level are adapted according the specific format.
AES3: 110 Ω, 2-7 Vp-p < > AES3id: 75 Ω, 1 Vp-p
page 8 of 16 BREAKOUT Series Hardware Guide - Version 2.0
CHAPTER 2: Legal issues & facts
CHAPTER 2: Legal issues & facts
Before Installing This Device
WARNING!
Please read and observe all of the following notes before installing
this product:
• Check the hardware device for transport damage.
• Do not use the device at extreme temperatures. Proper operation can
only be guaranteed between temperatures of 5ºC and 45ºC and a
maximum relative humidity of 80%, non-condensing.
Defective Parts/Modules
WARNING!
This device contains no user-serviceable parts. Therefore do not open the device.
In the event of a hardware defect, please send the device to your DirectOut
representative together with a detailed description of the fault.
We would like to remind you to please check carefully whether the failure is
caused by erroneous configuration, operation or connection before sending parts
for repair.
page 9 of 16BREAKOUT Series Hardware Guide - Version 2.0
CHAPTER 2: Legal issues & facts
Intended Operation
The BREAKOUT series is designed for passive adaption of analog or digital audio
(AES3, AES3id) signals.
Updates
DirectOut products are continually in development, and therefore the information
in this manual may be superseded by new releases. To access the latest
documentation, please visit the DirectOut website:
www.directout.eu
WARNING!
No compensation can be claimed for damages caused by operation of this unit
other than for the intended use described above. Consecutive damages are also
excluded explicitly. The general terms and conditions of business of DirectOut
GmbH are applied.
Conditions of Warranty
This unit has been designed and examined carefully by the manufacturer and
complies with actual norms and directives.
Warranty is granted by DirectOut GmbH over the period of 36 months for all
components that are essential for proper and intended operation of the device. The
date of purchase is applied for this period.
Consumable parts (e.g. battery) are excluded from warranty claims.
WARNING!
All claims of warranty will expire once the device has been opened or modified, or
if instructions and warnings were ignored.
For warranty claims please contact the dealer where your device was acquired.
page 10 of 16 BREAKOUT Series Hardware Guide - Version 2.0
CHAPTER 2: Legal issues & facts
Conformity & Certificates
CE
This device complies with the basic requests of applicable EU guidelines. The
appropriate procedure for approval has been carried out.
RoHS
(Restriction of the use of certain Hazardous Substances)
This device was constructed fulfilling the directive on the restriction of the use of
certain hazardous substances in electrical and electronic equipment 2011/65/EU
and 2015/863.
WEEE
(Directive on Waste Electrical and Electronic Equipment)
Due to the directive 2002/96/EC for waste disposal this device must be recycled.
For correct recycling please dispatch the device to:
DirectOut GmbH,
Leipziger Str. 32
09648 Mittweida
Germany
Only stamped parcels will be accepted!
WEEE-Reg.-No. DE 64879540
Contact
DirectOut GmbH
Leipziger Str. 32, 09648 Mittweida, Germany
Phone: +49 (0)3727 5665-100
Fax: +49 (0)3727 5665-101
Mail: [email protected]
www.directout.eu
Este manual sirve para los siguientes modelos
10
Tabla de contenidos
Otros manuales de Hardware de computadora de DirectOut Technologies
Manuales populares de Hardware de computadora de otras marcas
EMC2
EMC2 VNX Series Manual del propietario
Panasonic
Panasonic DV0PM20105 Manual de usuario
Mitsubishi Electric
Mitsubishi Electric Q81BD-J61BT11 Manual de usuario
Gigabyte
Gigabyte B660M DS3H AX DDR4 Manual de usuario
Raidon
Raidon iT2300 Manual de usuario
National Instruments
National Instruments PXI-8186 Manual de usuario
