Dimplex DFI2309 Guía de inicio rápido

PARTS AND SERVICE MANUAL

FOR THE 23” INSERT FIREPLACE

MODEL NUMBER:

DFI2309

TABLE OF CONTENTS

OPERATION PAGE1

PARTS DRAWING PAGE 3

PARTSLIST PAGE4

WIRING DIAGRAM PAGE 5

LIGHT BULB REPLACEMENT PAGE 6

MAIN ON/OFF SWITCH REPLACEMENT PAGE 8

LOW HEAT ON/OFF SWITCH REPLACEMENT PAGE 9

HIGH HEAT ON/OFF SWITCH REPLACEMENT PAGE 10

FLAME MOTOR/FLAME ROD REPLACEMENT PAGE 11

HEATER ASSEMBLY REPLACEMENT PAGE 12

LIGHT HARNESS REPLACEMENT PAGE 13

POWER CORD REPLACEMENT PAGE 14

DFI2309

OPERATION

MAIN ON/OFF FLAME ON/OFF SWITCH

The ON/OFF switch supplies power to all unit functions. When this switch is in the ON

position the flame effect operates without heat.

LOW HEAT SWITCH

The LOW HEAT ON/OFF SWITCH supplies power to the heater fan and the heater

element. When the switch is in the ON position the heater operates on LOW.

HIGH HEAT SWITCH

The HIGH HEAT ON/OFF SWITCH supplies power to the heater fan and the heater

element, when the switch is in the ON position the heater operates on HIGH. The LOW

HEAT ON/OFF SWITCH must also be in the ON position for the high heat setting to

operate.

RESETTING THE TEMPERATURE CUTOFF SWITCH

The heater is protected with a safety device to prevent overheating. Should the heater

overheat, an automatic cut out will turn the heater off and it will not come back on

without being reset. It can be reset by switching the ON/OFF SWITCH to OFF and

waiting 5 minutes before switching the unit back on.

CAUTION

If you need to continuously reset the heater, unplug the unit and call your local dealer.

MAIN ON/OFF

HIGH HEAT

LOW HEAT

DFI2309

REMOTE CONTROL

The remote control has a range of approximately 50ft. (15.25m) it does not have to be

pointed at the fireplace and can pass through most obstacles (including walls). It is

supplied with one of 243 independent frequencies to prevent interference with other

units. The frequency designation is indicated on the back of the transmitter (FIGURE 3)

REMOTE CONTROL INSTALLATION

1. Plug fireplace cordset into the outlet located on the side of the receiver. (FIGURE 2)

2. Plug receiver into the wall outlet.

3. Install a 9 volt battery into the transmitter. (FIGURE 3)

NOTE

• Fireplace MAIN on/off switch must be in the

ON position prior to using the Remote Control.

• ON/OFF Remote Control may be used to

control most other electrical devices including

T.V.’s, stereos and lamps.

CAUTION

• For indoor use in dry areas only

• For use on electrical devices with 15 amp

resistive load or 1/3 HP inductive load

• 120 volt AC only

FIGURE 2

Receiver

Outlet

OPEN

Frequency

Code

Battery

Cover

FIGURE 3

DFI2309

REPLACEMENT PARTS

23” FIREPLACE INSERT

REPLACEMENT PART REPLACEMENT PART NO.

1. MAIN ON/OFF SWITCH 2800090100RP*

2. LOW HEAT ON/OFF SWITCH 2800090100RP*

3. HIGH HEAT ON/OFF SWITCH 2800090100RP*

4. CORDSET 4100090101RP

5. HEATER ASSEMBLY 2200490300RP

6. CUTOUT 2300270200RP

7. MIRROR 5900350100RP

8. LOGSET 0438200200RP

9. FLICKER MOTOR 2000220100RP

10.REFLECTOR ASSEMBLY 5900340100RP

11.LAMPHOLDER 4200120100RP

12.REMOTE CONTROL 6800050200RP

DFI2309

WIRING DIAGRAM

DFI2309

If unit was operating prior to servicing allow at least 10 minutes for light bulbs and

heating element to cool off to avoid accidental burning of skin.

Disconnect power before attempting any maintenance or cleaning to reduce the risk of

electric shock or damage to persons.

Light bulbs need to be replaced when you notice a dark section of the flame. There are

four bulbs under the log set which generate the flames and embers.

It is a good idea to replace all of the light bulbs at one time if they are close to the end of

their rated life. Group replacement will reduce the number of times you need to open

the unit to replace the light bulbs.

1. Remove the fireplace trim.

2. Remove the (2) outer screws from the log grate.

3. Slide the light assembly out of the insert by pulling the log grate

until the light assembly reaches the stop.

4. Remove the log set by lifting the log ember bed straight up.

5. Examine the bulb(s) to determine which bulb(s) require replacement.

6. Unscrew the bulbs counter clockwise.

7. Insert new bulbs.

8. Replace the log set into the insert.

9. Slide the light assembly back into the insert.

10.Install the two outer screws into the log grate.

11.Reinstall the fireplace trim.

Outer Screws

Light Assembly

Light Bulbs

Log Ember Bed

DFI2309

If unit was operating prior to servicing allow at least 10 minutes for light bulbs and

heating element to cool off to avoid accidental burning of skin.

Disconnect power before attempting any maintenance or cleaning to reduce the risk of

electric shock or damage to persons.

BULB REQUIREMENTS

Quantity 2 clear chandelier or candelabra bulbs with an E-12 (small) socket base, 60

watt rating.

DFI2309

If unit was operating prior to servicing allow at least 10 minutes for light bulbs and

heating element to cool off to avoid accidental burning of skin.

Disconnect power before attempting any maintenance or cleaning to reduce the risk of

electric shock or damage to persons.

TO REPLACE MAIN ON/OFF SWITCH

1. Remove the trim and firebox from mantel.

2. Remove the trim from firebox.

3. Remove the (2) screws located in the front middle of the top and the (2) screws at

the back of the top.

4. Locate the main on/off switch mounted in the exhaust panel and disconnect the

wiring clips and connections noting their original locations.

5. Depress the retainer clips on the rear of the switch and push the switch out of the

exhaust panel.

6. Properly orientate the new switch and connect all of the wiring clips and

connections.

7. Reassemble in the reverse order as above.

Otros manuales para DFI2309

Tabla de contenidos

Otros manuales de Chimenea de interior de Dimplex

Dimplex

Dimplex VCX1525-EU Manual de usuario

Dimplex

Dimplex LEE 20RC Manual de usuario

Dimplex

Dimplex DFP6975O Manual de usuario

Dimplex

Dimplex ELECTRALOG DF203A Manual de usuario

Dimplex

Dimplex MULTIFIRE DF3015 Manual de usuario

Dimplex

Dimplex ELECTRALOG CFP3913 Manual de usuario

Dimplex

Dimplex DF2524L Manual de usuario

Dimplex

Dimplex 34" Prism Manual de usuario

Dimplex

Dimplex DFB8842 Manual de usuario

Dimplex

Dimplex DWF120330B Manual de usuario

Dimplex

Dimplex Sierra 48 Manual de usuario

Dimplex

Dimplex 6908760100 Manual de usuario

Dimplex

Dimplex BLF3451 Manual de usuario

Dimplex

Dimplex DWOP20R Manual de usuario

Dimplex

Dimplex Mini Mozart Manual de usuario

Dimplex

Dimplex TOLUCA TLC20 Manual de instrucciones

Dimplex

Dimplex XHD23G Manual de usuario

Dimplex

Dimplex DF2608 Manual de usuario

Dimplex

Dimplex MULTIFIRE DF3215 Manual de usuario

Dimplex

Dimplex 23" Insert Fireplace DFPI2311 Guía de inicio rápido

Dimplex

Dimplex Electric fireplaces Manual de usuario

Dimplex

Dimplex RLG25FC Manual de usuario

Dimplex

Dimplex Ignite 50" Manual de usuario

Dimplex

Dimplex DFR2551G Manual de usuario

Manuales populares de Chimenea de interior de otras marcas

Brigantia

Brigantia 35-DVRS31N-2 Manual del propietario

Nordpeis

Nordpeis Bergen Manual de usuario

Superior

Superior BCT2536TMN Manual de usuario

Quadra-Fire

Quadra-Fire 5100I-GD-B Manual de usuario

Renaissance

Renaissance RUMFORD 1000 Manual de usuario

Lacunza

Lacunza IV-800 Manual de usuario

Baxi

Baxi 940 Instrucciones de uso

Dru

Dru Maestro 60/2 Tall RCH Manual de usuario

Diamond Fireglass

Diamond Fireglass SS-O22 Manual de usuario

HearthStone

HearthStone Windsor Bay 8830 Manual de programación

Napoleon

Napoleon ASCENT B42 Manual de usuario

Enviro

Enviro E33GI Manual de usuario

Smeg

Smeg L30 FABE Instrucciones de montaje

KEDDY

KEDDY K700 Manual de usuario

Godin

Godin 3451 Manual de usuario

Jøtul

Jøtul Jotul GI 535 DV IPI New Harbor Manual de usuario

Austro Flamm

Austro Flamm Heidi Back 2.0 945048 Manual de usuario

Desa

Desa CCFPDFT Manual de operación