Dimplex WFE3BE Manual de usuario

08/53943/0 ISSUE: 1

WFE Wall Fan Convector

Model: WFE3BE, WFE3SE

INSTRUCTION MANUAL

Installation and Operating

This product is supplied and operated with a Bluetooth Remote Control handset

IMPORTANT

THESE INSTRUCTIONS SHOULD BE READ CAREFULLY AND RETAINED FOR

FUTURE REFERENCE. Note also the information presented on the appliance

CAUTION: FAILURE TO FOLLOW THESE ISTRUCTIONS MAY CAUSE INJURY

AND/OR DAMAGE AND MAY INVALIDATE YOUR GUARANTEE

WARNING – This appliance must not be used in a bathroom.

WARNING – Do not use this heater in the immediate surroundings of a bath,

shower or a swimming pool.

WARNING – This heater must not be located immediately above or below a

xed socket outlet.

WARNING - This heater must be earthed

The supply circuit to the heater must incorporate a double pole isolating switch

having a contact separation of at least 3mm in all poles.

WARNING – Ensure all packaging including Bluetooth remote control is

removed from the inside of the product before wall mounting or startup.

DO NOT - Use the heater until it is wall mounted correctly.

The heater carries a warning ‘Do Not Cover’ to alert the user to the risk of

overheating that exists if the heater is accidentally covered.

Keep combustible materials such as drapes and other furnishings clear from the

front of the heater. Do not use heater to dry your laundry.

NEVER cover or obstruct in any way the air inlet slots at the front of the heater

or the heat outlet slots in the base of the heater.

This appliance can be used by children aged from 8 years and above and

persons with reduced physical, sensory or mental capabilities or lack of

expierience or knowledge if they have been given supervision or instruction

concerning the use of the appliance in a safe way and understand the hazards

involved. Children shall not play with the appliance.

Cleaning and user maintenance shall not be made by children without

supervision.

Children of less than 3 years should be kept away unless continuously

supervised.

Children aged from 3 years and less than 8 years shall only switch on/ o

the appliance provided that it has been placed or installed in its intended

normal operating position and they have been given supervision or instruction

concerning the use of the appliance in a safe way and understand the hazards

involved.

Children aged from 3 years and less than 8 years shall not plug in, regulate and

clean the appliance or perform user maintenance.

CAUTION: Some parts of this product can become very hot and cause burns.

Particular attention has to be given where children and vunerable people are

present.

If young children, the aged, or inrm are likely to be left in the vicinity of the

heater, we advise that adequate precautions should be taken. We recommend

that a guard be tted to ensure contact with the heater is avoided and objects

cannot be inserted into the product.

WARNING: In order to avoid a hazard due to inadvertent resetting of the

thermal cut-out, this appliance must not be supplied through an external

switching device, such as a timer, or connected to a circuit that is regularly

switched on and o by the utility.

DO NOT use where excessive dust or moisture is present. For further

information, please contact our guard supplier direct on Tel. No. 01603 667957,

or in the case of diculty or for further advice contact our Customer Helpline.

WARNING: KEEP BATTERIES OUT OF REACH OF CHILDREN

• Swallowing may lead to serious injury in as little as 2 hours or death, due to

chemical burns and potential perforation of the oesophagus.

• If you suspect your child has swallowed or inserted a battery go straight to a

hospital emergency room.

• Examine devices and make sure the battery compartment is correctly

secured, i.e. that the battery cover is tted securely. Do not use if the

compartment is not secure.

• Dispose of used batteries immediately and safely. Flat batteries can still be

dangerous.

Model Identiﬁer(s): WFE3BE WFE3SE

Nominal heat output Pnom 3.0kW 3.0kW

Height (mm) 350 350

Width (mm) 571 571

Depth (mm) 120 120

Minimum heat

output (indicative) Pmin 1.0kW 1.0kW

Maximum continuous heat output Pmax,c 3.0kW 3.0kW

Auxiliary electricity Consumption

At nominal heat output elmax 0.00 0.00

At minimum heat output elmin 0.00 0.00

In standby mode elSB <0.0005 <0.0005

Type of heat output/ room temperature control

Electronic room temperature control plus week timer Yes

With open window detection Yes

With adaptive start control Yes

This product complies with Lot20 of the Energy Eciency Directive (2015/1188).

Energy Related Product Directive

Technical Details

All Models

Controls

Digitally controlled, Electronic Thermostat

Timer modes:

7 Day Programmable User Timer

Continuous heat modes:

Frost Protect, Runback, Comfort O

Controller UI

Button to initiate pairing with Bluetooth remote

Controller Functions

• Heat Selection: High / Low

• Adaptive-Start

• Advance time period

• Adjustable SP range (7-30°C)

• Bluetooth for control

Construction Durable epoxy-polyester powder coated steel casing with slotted forward

facing grille

Element Stitched element with integral thermal cut-out

Installation Fixed directly to the wall through the back panel

Safety Eelectrical reset, self-hold cut-out

IP Rating No Rating

Battery Backup

None. However all programmed timer proles will be retained during

short term power losses. In order to ensure their correct operation, it is

necessary to restore the time and date settings,this happens automatically

once paired with the remote.

Supply

~230-240 V, 50Hz Class I, with earth wire

Colour / Finish

• Black body with Cherry wood side panels

• Silver body with Black side panels

Approvals CE, BEAB

Warranty 2 years

Country of Origin British Isles

Manufacturer Glen Dimplex Heating & Ventilation (GDC Group Ltd.)

Installation

WARNING: The installation of this appliance should be carried out by a competent

electrician and be in accordance with the current IEE wiring regulations

and any local or insurance regulations.

Before undertaking installation work, ensure the electricity supply is disconnected

from any relevant xed wiring. Supply cable is not provided with this appliance, and

a competent electrician should therefore install it.

The appliance must be tted horizontally with the cable or conduitentry at bottom

right. It should be mounted such that the underside is at least 350mm above the oor

and the top of the heater is 150mm below any overhanging shelf or obstruction.

This heater must be used on an A.C.~ supply only and the voltage marked on the

heater must correspond to the supply voltage.

To comply with the I.E.E. Wiring Regulations, the appliance must be earthed; the supply

circuit must be adequate for the input of the appliance, and the circuit protected by

a suitable 13A fuse. A suitable termination to the xed wiring of the premises must

be provided adjacent to the nal position of the appliance. In this instance, such a

termination can be a double-pole switch with a contact separation of at least 3mm in

all poles.

The heater must not be located immediately below a xed socket-outlet

Procedure

Release the front cover from the unit by undoing the two screws under the bottom

edge. Carefully remove the cover by pulling bottom-front forward, and then lift to

release the top from the retaining slots. Remove packaging containing Bluetooth

remote control.

Mark screw xing positions on the wall in accordance with the dimensions shown on

the diagram in Fig 2. The unit must be secured to the wall with four screws through

the holes provided.

The two upper holes are keyhole shaped to enable the two upper screws to be

positioned rst. The unit can then be hung on these screws while the two lower

screws are positioned. Before nally tightening all four screws, ensure the unit is truly

horizontal. Fit a 3 core 1.5 square millimetre exible cord through the cable entry bush,

connect wires to the appropriate terminals and tighten cable clamp.

Alternatively the heater may be connectedwith conduit through the base after

removing the knockout containing the cable entry bush (see ‘A’ in Fig. 2).

Fig. 1

Fig. 2

shelf

571mm

510mm

150mm min

6mm

8mm

10mm

350mm

280

‘A’ 350mm

35mm

571

120

350

350mm

MIN

Wiring

See Fig. 3

Component

A. Terminal Block

B. Cable Clamp

C. Power Supply Cable

After ensuring the electricity supply is not live, electrical connections can be made,

either to an adjacent double-pole switch having a contact separation of at least

3mm in all poles or to a plug-top for use in a standard 13A socket.

If the latter: Connect Green and Yellow wire to plug terminal marked Eor Green or

Green and Yellow. Connect Blue wire to plug terminal marked Nor Black. Connect

Brown wire to plug terminal marked L or Red.

Ret cover, rst hooking top over the back of the unit and then securing the bottom

by retting the two screws under the bottom edge.

The appliance is now ready for use and the electricity supply can be reinstated.

WARNING: This appliance must be earthed

Electrical

Fig. 3

The product is supplied with a Bluetooth remote control, the remote control should be

contained in the carrier bag along with these instructions. This remote control is required

to operate the appliance. When paired with the remote control various operational modes

and features can be accessed.

IMPORTANT NOTE:

The remote control is required to operate the appliance. It is important

that the remote control remains near the appliance at all times.

Remote Control

1Display Screen

2‘Menu’ Button

3‘Back’ Button

4‘Advance’ Button

5‘Up and Down’ Arrows

6‘Enter’ Button

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Calentador de Dimplex

Dimplex

Dimplex Monterey MFP050 Manual de usuario

Dimplex

Dimplex H 260/4 Manual de usuario

Dimplex

Dimplex QUBEFAN Q2TSNH Manual de usuario

Dimplex

Dimplex PLX 500 Manual de usuario

Dimplex

Dimplex Saletto LPP050 Manual de usuario

Dimplex

Dimplex IRX50N Manual de usuario

Dimplex

Dimplex QM050 Manual de usuario

Dimplex

Dimplex EMC4240 Manual de usuario

Dimplex

Dimplex FW 550S Manual de usuario

Dimplex

Dimplex DES 1821 Manual de usuario

Dimplex

Dimplex CXLS18N Manual de usuario

Dimplex

Dimplex Heater Manual de usuario

Dimplex

Dimplex Canfield Canfield Canfield CFD20 Manual de usuario

Dimplex

Dimplex xln Manual de usuario

Dimplex

Dimplex SmartRad SRX80 Manual técnico

Dimplex

Dimplex FX 20V Manual de usuario

Dimplex

Dimplex EPX 500 Manual de usuario

Dimplex

Dimplex 403BTB Manual de usuario

Dimplex

Dimplex XMS718N Manual de usuario

Dimplex

Dimplex BRENTA BNT20 Manual de usuario

Dimplex

Dimplex DHCER20WIFI Manual de usuario

Dimplex

Dimplex LC Series Manual de usuario

Dimplex

Dimplex DIR Series Manual de usuario

Dimplex

Dimplex EVORAD2E Manual de usuario

Manuales populares de Calentador de otras marcas

oventrop

oventrop Regucor Series Manual de usuario

Blaze King

Blaze King CLARITY CL2118.IPI.1 Manual de usuario

ELMEKO

ELMEKO ML 150 Manual de usuario

BN Thermic

BN Thermic 830T Manual de usuario

KING

KING K Series Guía

Empire Comfort Systems

Empire Comfort Systems RH-50-5 Guía de inicio rápido

Well Straler

Well Straler RC-16B Manual de usuario

EUROM

EUROM 333299 Manual de usuario

Heylo

Heylo K 170 Manual de usuario

Eterna

Eterna TR70W Manual de usuario

Clarke

Clarke GRH15 Manual de instrucciones

IRSAP

IRSAP The Radiator Company Ovali Manual de usuario

Empire Heating Systems

Empire Heating Systems WCC65 Manual de usuario

Wetekom

Wetekom 92 86 43 Manual de usuario

Desa

Desa SPC170-F Manual de usuario

Watlow

Watlow Watrod Electric Tubular Heaters Manual de usuario

Haverland

Haverland ECO-DRY GPS Series Manual de lista de piezas

Stelpro

Stelpro ASILVC2060 Series Manual de usuario