Digitus DN-60012 Manual de usuario

8-Port Fast Ethernet

Desktop Switch

Manual

DN-60012

Introduction

The DN-60012 is a compact Ethernet desktop switch that provides wire-speed, a

Fast Ethernet switching function which allows high-performance, low-cost

connections to 10M/ 100M bps Ethernet network. The Ethernet Switch delivers all

the advantages of a switching hub in a compact desktop size and is ideal for small

office or SOHO network users.

This switch provides 8 auto-sensing 10/100 Mbps Ethernet RJ-45 ports which

automatically detect the speed of the devices that you plug into them. This

switching function allows Full/Half-duplex devices to communicate on the same

network without having to replace any infrastructure. This flexible feature allows

your network a timely, economical migration to DIGITUS network switch.

Key Features

Conforms to IEEE802.3, 802.3u, 802.3x

Automatic MDI/MDIX crossover for all ports

N-Way Auto-negotiation for 10/100Mbps transmissions

Space-saving compact size

Store-and-Forward switching architecture

Auto-detection of full/half-duplex mode in all ports

Plug-and-Play configuration auto address learning

LED indicators for Power, Link/activity

Package Contents

Ethernet Switch

DC Power adapter

User’s manual

Four (4) adhesive-backed rubber feet attached.

IMPORTANT: If any piece is missing or damaged, please contact your local

dealer or reseller for service.

Product Specifications

DN-60012 (8-Port 10/100Base-TX Fast Ethernet Switch)

Ports: 8-Port 10/100Base-TX

MAC Address: 1K Mac address table

Jumbo Frame: 9KB

LED Indicator: Per port: Link/Activity

Per unit: Power

Dimension: 137mm x 74mm x 24mm (W x D x H)

Operating Temp: 0°C to 45°C (32°F to 113°F)

Operating Humidity: 10% to 90% (Non-condensing)

Power Consumption: 6.8 Watt @ AC 240V/60Hz (Maximum)

EMI: CE Class B

Hardware Description

The Front Panel

The front panel consists of LED Indications.

LED Indicators

Per Device: Power

Per Port: LINK/ACT (Link/Activity)

Figure 1. Front panel view

LED Status Color Description

Power On Green The switch is supplied with suitable power.

LINK/ACT Off - The port is not linked successfully with the device.

The Real Panel

The rear panel view of the switch consists of a DC power connector and

8 auto-sensing ports.

Figure 2. Rear panel view

Power Indicator

LINK/ACT Indicators

RJ-45 Ports (Auto MDI/MDIX)

8 auto-sensing ports of 10Base-T, 100Base-TX connections. [In general, MDI means

connecting to another Hub or Switch while MDIX means connecting to a workstation

or PC. Therefore, Auto MDI/MDIX means that you can connect to another Switch or

workstation without changing pin-to-pin or crossover cabling.]

DC Power Connector

Plug the female connector into the switch and male connector into a power outlet.

Supports input voltages 5VDC at 1000 mA.

Troubleshooting

The Switch can be easily monitored through panel indicators to assist in identifying

problems. This section describes common problems you may encounter and possible

solutions.

Power

If the power indicator does not light when the power cord is plugged in, you may

have a problem with the power outlet or cord. However, if the power LED goes off

after running for a while, check for loose power connections, power losses or surges

at the power outlet. Turn off power, wait 30 seconds and turn power on again. If

problem is still not resolved call for dealer’s assistance

Diagnosing LED Indicators

If link indicator does not light after making a connection, check whether network

interface (e.g., a network adapter card on the attached device), network cable, or

switch port is defective. Be sure the cable is plugged into both the switch and

corresponding device. Verify the proper cable type is used and its length does not

exceed specified limits.

Cabling

Verify that the cabling type is correct. Make sure all cable connectors are securely

seated in the required ports. Use only standard Unshielded Twisted-Pair (UTP),

Category 3, 4, 5, or 5e cables. Use only Category 5 or 5e when connecting with Fast

Ethernet. Make certain the maximum distance between the Switch and what it’s

connected to is 100 meters or less.

NOTE: Do not plug a standard telephone cord into an RJ-45 port. This may damage

the switch

Hereby ASSMANN Electronic GmbH, declares that this device is in compliance with the

requirements of Directive 2014/30/EU (EMC), Directive 2014/35/EU (LVD) and the Directive

2011/65/EU for RoHS compliance. The complete declaration of conformity can be requested

by post under the below mentioned manufacturer address.

Warning:

This device is a class B product. This equipment may cause some radio interference in living

environment. In this case, the user can be requested to undertake appropriate measures to

prevent interference.

www.assmann.com

Assmann Electronic GmbH

Auf dem Schüffel 3

58513 Lüdenscheid

Germany

Tabla de contenidos

Otros manuales de Enrutador de red de Digitus

Digitus

Digitus DN-95330 Manual de usuario

Digitus

Digitus DN-11004-O Manual de usuario

Digitus

Digitus DN-95346 Manual de usuario

Digitus

Digitus WHITE WEASEL MOBILITY Manual de usuario

Digitus

Digitus DS-23200 Manual de usuario

Digitus

Digitus DN-15017 Manual de usuario

Digitus

Digitus EASY WEASEL Manual de usuario

Digitus

Digitus DN-95312 Manual de usuario

Digitus

Digitus DN-8007C1 Manual de usuario

Digitus

Digitus EASY WEASEL DN-7062 Manual de usuario

Digitus

Digitus DN-7039 Manual de usuario

Digitus

Digitus DN-7017 Manual de usuario

Digitus

Digitus DN-80110 Manual de usuario

Digitus

Digitus GreyRapid N Manual de usuario

Digitus

Digitus DN-15019-2 Manual de usuario

Digitus

Digitus DN-8006C1 Manual de usuario

Digitus

Digitus DN-95323 Manual de usuario

Digitus

Digitus DN-7039-B Manual de usuario

Digitus

Digitus DN-50011 Manual de usuario

Digitus

Digitus 15019-2 Manual de usuario

Digitus

Digitus DN-60021-2 Manual de usuario

Digitus

Digitus DN-11009 Manual de usuario

Digitus

Digitus GreyRapid N DN-7049-1 Manual de usuario

Digitus

Digitus DN-95301 Manual de usuario

Manuales populares de Enrutador de red de otras marcas

Allnet

Allnet ALL0333AU Manual de usuario

HomeSeer

HomeSeer HT-SEL Manual de usuario

Sercomm

Sercomm Genesis OC3505D Manual de usuario

Billion

Billion BIPAC 5102 Series Manual de usuario

TP-Link

TP-Link TD-8817 Manual de usuario

Motorola

Motorola MR1900 Manual de usuario

Digi

Digi IX14 Manual de usuario

Cisco

Cisco NCS 540 Manual

XAVi

XAVi X8821e Manual de usuario

BEC

BEC 6200WZL Manual de usuario

MikroTik

MikroTik hAP ac3 Series Manual de usuario

Korenix

Korenix JetNet 5428G Series Manual de usuario

NETGEAR

NETGEAR FS526T - Switch Manual de usuario

Korenix

Korenix JetNet 5710G Series Manual de usuario

Automated Logic

Automated Logic ZN551 Manual del propietario

Cisco

Cisco ASR 1000 Series Manual del operador

EnGenius

EnGenius ESR-9710 Manual de usuario

Cisco

Cisco 805 Series Instrucciones de funcionamiento y seguridad