DIGITIZE System 3500 Manual de usuario
SYSTEM 3500 NETWORK CONTROLLER
INSTALLATION and OPERATION
MANUAL
Digitize, Inc.
158 Edison Road
Lake Hopatcong, New Jersey 07849
Tel: (973) 663-1011
Fax: (973) 663-4333
E-Mail: <info>@digitize-inc.com
Website: http://www.digitize-inc.com
Part Number: 700232-0001
Issue Revision: A
Issue Date: 02/00
TRADEMARKS
DIGITIZE (stylized) is a registered trademark of Digitize, Inc.
All of the above are trademarks of Digitize, Inc.
Any logos or product names mentioned in this document may be trademarks and are used for
identification purposes only.
PROPRIETARY NOTICE
AND DISCLAIMER
DIGITIZE, INC.
158 EDISON ROAD
LAKE HOPATCONG, NJ 07849
(973) 663-1011
FAX: (973) 663-4333
Website: http://www.digitize-inc.com
ThismanualhasbeenpreparedbyDIGITIZE,INC.forusebyitslicensees,distributorsandcustomers.
The information contained herein is the property of DIGITIZE, INC. and may not be copied, disclosed
or reproduced, in whole or in part, without the prior written approval of DIGITIZE, INC. Any
unauthorized disclosure to, or use of the enclosed information by, unauthorized third persons shall
void any and all representations, warranties and obligations on the part of DIGITIZE, INC.
DIGITIZE, INC. reserves the right to make changes to the specifications and material contained
herein without prior notice. The information and/or examples (including, but not limited to circuitry,
wiring diagrams, programming, the operation or use shown) described in this manual are intended
solely to illustrate the operating principles of the particular product. They are not a warranty,
representationorguaranteethataparticularexampleoruseshownwill perform in a particular situation.
They are given for illustration purposes only. DIGITIZE, INC. shall not be responsible, nor does it
represent, that any example of illustration will perform in a particular environment or practice unless
it specifically makes a representation to that effect.
The material set forth herein is for informational purposes only, and DIGITIZE, INC. assumes no
patent liability with respect to any information or illustrations contained herein.
FCC NOTICE
In compliance with Paragraph 15.105 of the FCC Rules and Regulations, the following notice is pro-
vided.
NOTE: This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protec-
tion againste harmful interference when the equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency energy, and, if not installed and used in
accordance with the instruction manual, may cause interference to radio communications. Operation
of this equipment in a residential area is likely to cause interference, in which case the user will be
required to correct the interference at his own expense.
P/N 700120 Rev C
Table of Contents
SECTION 1 GENERAL INFORMATION
1.1. SYSTEM DESCRIPTION ........................................................................................................ 1-1
1.2. NETWORK CONTROLLER..................................................................................................... 1-1
1.3. DISPLAY (FIGURE 1)............................................................................................................ 1-2
1.4. MEMORY................................................................................................................................ 1-2
1.4.1. MEM-600 MEMORY CHIP.......................................................................................... 1-2
1.4.2. MBD-4800 MEMORY MOTHERBOARD .................................................................. 1-4
1.5. SPECIFICATIONS ..................................................................................................................... 1-4
1.5.1. ELECTRICAL ............................................................................................................... 1-4
1.5.2. FUSES ........................................................................................................................... 1-4
1.5.3. INPUTS ......................................................................................................................... 1-4
1.5.4. OUTPUTS ..................................................................................................................... 1-4
1.5.5. CONSTRUCTION......................................................................................................... 1-5
1.5.6. DIMENSIONS............................................................................................................... 1-5
1.5.7. WEIGHT........................................................................................................................ 1-5
1.5.8. TEMPERATURE AND HUMIDITY ............................................................................ 1-5
1.5.9. STRIP PRINTER ........................................................................................................... 1-5
1.5.10. DISPLAY ..................................................................................................................... 1-6
1.5.11. KEYPAD...................................................................................................................... 1-6
1.6 AUTOMATION PROTOCOLS............................................................................................... 1-6
1.7. FCC REQUIREMENTS............................................................................................................. 1-6
1.8. APPLICABLE PUBLICATIONS............................................................................................... 1-6
SECTION 2 INSTALLATION
2.1. HANDLING ............................................................................................................................... 2-1
2.1.1. PRECAUTIONS ............................................................................................................ 2-1
2.1.2. UNPACKING AND INSPECTION .............................................................................. 2-1
2.2. INSTALLATION PROCEDURE ............................................................................................... 2-1
2.3. WIRING ..................................................................................................................................... 2-1
2.3.2. FIELD WIRING ............................................................................................................ 2-1
SECTION 3 SYSTEM INITIALIZATION
3.1. GENERAL.................................................................................................................................. 3-1
3.2. ASSEMBLY ............................................................................................................................... 3-1
3.3. BATTERY INSTALLATION ..................................................................................................... 3-1
3.4. POWER-UP................................................................................................................................ 3-1
3.4.1. AC POWER................................................................................................................... 3-1
3.4.2. DC POWER................................................................................................................... 3-1
3.4.3. POWER TRANSFER .................................................................................................... 3-2
3.5. PROGRAM INITIALIZATION ................................................................................................. 3-2
3.6. CONNECTIONS AND SETTINGS........................................................................................... 3-3
SECTION 4 USER TEXT
4.1. USING THE EXTERNAL KEYBOARD .................................................................................. 4-1
4.1.1. GENERAL..................................................................................................................... 4-1
4.1.2. INITIAL SET-UP .......................................................................................................... 4-1
4.1.3. CONTROL & FUNCTION KEYS................................................................................ 4-1
4.1.4. ACCESS ........................................................................................................................ 4-2
4.2. EXTERNAL KEYBOARD MENU SELECTIONS .................................................................. 4-3
4.2.1. DIALER/STU MENU ................................................................................................... 4-3
4.2.1.1. ADDING TEXT TO A ZONE ...................................................................... 4-3
4.3. USER TEXT TYPES ................................................................................................................. 4-5
4.3.1. GENERIC ...................................................................................................................... 4-8
4.3.2. ZONE SPECIFIC........................................................................................................... 4-8
4.3.2.1. CHANGING ZONE TEXT ........................................................................... 4-9
4.3.2.2. DELETING ZONE TEXT............................................................................. 4-9
4.3.8. PASSWORD MENU ..................................................................................................... 4-10
4.3.9. EXIT DATA ENTRY MODE ........................................................................................ 4-11
4.3.10. TOTAL PAGES INSTALLED, USED, AND DELETED........................................... 4-11
SECTION 5 FRONT PANEL ACCESS
5.1. FRONT PANEL ACCESS, GENERAL..................................................................................... 5-1
5.2. FRONT PANEL MENUS........................................................................................................... 5-2
5.2.1. TIME MODE / TIME SET............................................................................................ 5-3
5.2.2. DAY / DATE / YEAR.................................................................................................... 5-3
5.2.3. ALARM LEVEL / TONE ............................................................................................. 5-4
5.2.4. THERMAL PRINTER INTENSITY............................................................................. 5-5
5.2.5. SERIAL PORT COMMUNICATIONS ......................................................................... 5-5
5.2.8. IN/OUT SERVICE PASSWORD YES/NO ................................................................... 5-6
5.2.8.1. CHANGING LEVEL DESCRIPTORS......................................................... 5-6
5.2.8.2. IN/OUT SERVICE PASSWORD .................................................................. 5-6
5.2.13. STATUS PRINTOUT SETUP MODE ........................................................................ 5-7
SECTION 6 OPERATION
6.1 CONTROLS ................................................................................................................................ 6-1
6.1.1. PAPER ADVANCE ....................................................................................................... 6-1
6.1.2. PRINT............................................................................................................................ 6-1
6.1.3. KEY SELECT ............................................................................................................... 6-1
6.1.5. DIALER LOOK UP....................................................................................................... 6-1
6.1.6. ZONE LOOK UP........................................................................................................... 6-2
6.1.7. NUMERIC KEYS.......................................................................................................... 6-2
6.1.8. CLEAR BUTTON ......................................................................................................... 6-2
6.1.9. HYPHEN (-) BUTTON ................................................................................................. 6-2
6.1.10. FUNC BUTTON.......................................................................................................... 6-2
6.1.11. SET BUTTON ............................................................................................................. 6-2
6.1.12. ON / - BUTTON ......................................................................................................... 6-3
6.1.13. OFF/ ¯ BUTTON....................................................................................................... 6-3
6.1.14. ACK BUTTON............................................................................................................ 6-3
6.1.15. IN/OUT SERVICE....................................................................................................... 6-3
6.1.16. SHIFT KEY ( ).......................................................................................................... 6-4
6.1.17. STATUS ....................................................................................................................... 6-4
6.1.18. REPORT KEY ............................................................................................................. 6-4
6.1.19 PROGRAMMABLE KEYS ....................................................................................... 6-4
6.1.19.1 HISTORY ................................................................................................... 6-5
6.1.19.2 NEXT PAGE HISTORY ............................................................................ 6-5
6.1.19.9. STATUS PRINTOUT................................................................................. 6-5
6.1.20. SCROLL KEYS ......................................................................................................... 6-5
6.1.20.1 RESTORE TO NORMAL QUE ................................................................ 6-5
6.1.20.2 BOTTOM OF ALARM QUE .................................................................... 6-5
6.1.20.3 MIDDLE OF ALARM QUE...................................................................... 6-5
6.1.20.4 TOP OF THE ALARM QUE..................................................................... 6-5
6.1.20.5 SNGL/MULTI PAGE DISP ....................................................................... 6-6
6.1.21. RESTART BUTTON................................................................................................... 6-6
6.1.22. KEYBOARD JACK .................................................................................................... 6-6
6.2. INDICATORS............................................................................................................................. 6-6
6.2.1. AC POWER................................................................................................................... 6-6
6.2.2. CONDITION INDICATOR........................................................................................ 6-6
6.2.3. CLEAR .......................................................................................................................... 6-6
6.2.4. ACK ............................................................................................................................... 6-6
6.2.5. ALARM INDICATOR................................................................................................... 6-7
6.3. OPERATING PROCEDURE ..................................................................................................... 6-7
6.3.1. PRIORITIES .................................................................................................................. 6-7
6.3.2. NORMAL QUIESCENT OPERATION........................................................................ 6-8
6.3.3. ALARM CONDITION.................................................................................................. 6-8
6.3.4. TROUBLE CONDITION.............................................................................................. 6-8
6.3.5. TAKING A ZONE TEMPORARILY OUT OF SERVICE ........................................... 6-9
6.3.7. INITIATING STATUS PRINTOUT FOR NON-SECURE ZONES ............................. 6-9
6.3.8. CHECKING STATUS/MESSAGE OF INDIVIDUAL ZONE ..................................... 6-9
6.3.10. CHANGING THE PAPER TAPE................................................................................ 6-9
6.3.11. SERIAL OUTPUT FROM THE SYSTEM 3500 NETWORK CONTROLLER ....... 6-10
SECTION 7 DERIVED CHANNEL NETWORK CONTROLLER
7.1 OVERVIEW ............................................................................................................................ 7-1
7.2 INITIALIZATION AND PORT SETTINGS........................................................................... 7-2
7.3 DERIVED CHANNEL SETUP SCREEN .............................................................................. 7-3
7.3.1 PASSWORD .................................................................................................................. 7-4
7.4 DERIVED CHANNEL STU AND GLOBAL SETTINGS..................................................... 7-4
7.4.1 GLOBAL SETTINGS ................................................................................................ 7-5
7.4.2 ADD/CHANGE/REMOVE STU ............................................................................... 7-5
7.5 DERIVED CHANNEL PROGRAMMABLE KEYS (FIGURE 7-1) ..................................... 7-7
7.5.1 STU CONTROL KEYS ............................................................................................. 7-7
7.5.2 STU INFO KEYS ....................................................................................................... 7-8
7.5.3 LIST/LOAD COMMANDS KEYS............................................................................ 7-8
SECTION 8 COMPUTER INTERFACE OPTIONS
8.1. OVERVIEW ............................................................................................................................ 8-1
8.2. CGRMS ................................................................................................................................... 8-1
8.3. CAPS ....................................................................................................................................... 8-1
8.3.1 CAPS DATA TRANSMISSION ................................................................................ 8-1
8.3.2 MESSAGE TYPE....................................................................................................... 8-1
8.3.3 TYPE NUMBER ........................................................................................................ 8-2
8.3.4 CONDITION .............................................................................................................. 8-2
8.4. CAPS PLUS............................................................................................................................. 8-2
SECTION 9 UPLOADING NEW SOFTWARE VERSIONS
9.1 OVERVIEW ............................................................................................................................... 9-1
9.2 UPLOADING FROM DISKETTE ............................................................................................ 9-1
8.2.1. SAVE COMMAND ...................................................................................................... 9-3
9.2.2. UPLOAD COMMAND ................................................................................................ 9-4
9.2.3. RUN COMMAND........................................................................................................ 9-5
APPENDIX A USER TEXT STEP-BY-STEP PROCEDURES ....................................A-1
APPENDIX B SYSTEM 3500 NETWORK CONTROLLER
SET MENUS STEP-BY-STEP PROCEDURES ...................................................... B- 1
APPENDIX C INSTALLATION DRAWINGS
SYSTEM 3500 NETWORK CONTROLLER........................................................... C-1
Otros manuales para System 3500
1
Tabla de contenidos
Otros manuales de Controladores de DIGITIZE
