Specifications subject to change without notice
© Digital View Ltd – Doc Ver 1.00: 23 Feb, 2023 Page 3 of 16
The HD-3000v2 provides a SD/HD-SDI signal front end to Digital View LCD controller boards.
HD-3000v2 Key Features
a. Converts SD/HD-SDI (SD, HD and 3G) video input to HDMI output, up to Full-HD resolution.
b. Re-clocked loop through outputs for “daisy chaining” multiple monitors or other equipment to the same HD-SDI source, includes
embedded audio.
c. Fully compliant with the SMPTE 259M-C, SMPTE 292M, SMPTE 424M, 425M standards.
d. Supports 1.5Gbits & 3Gbits bit rate input signal support. The mode support is listed in page 10.
e. Two SDI input port switching with One HDMI out supported.
HD-3000v2 supports Path A (HD-SDI input from J1 port convert to output HDMI at HDMI1/HDMI1A port) or Path B (HD-SDI input
from J2 port convert to output HDMI at HDMI1/HDMI1A port). See Figure below :
f. HD-SDI re-clock loop through output. J1 HD-SDI input and re-clock loop through to J3 HD-SDI output. J2 HD-SDI input and re-clock
loop through to J4 HD-SDI output.
g. HDMI (v1.3) x 1 output port. One HDMI output ports are HDMI1/HDMI1A outputting 1920x1080p60 mode.
h. Stereo embedded audio support .
i. Input interlaced SDI video is de-interlaced to HDMI output for non-frame buffered DV controller.
g. Provide fast input port switching between the dual SDI inputs if the two SDI inputs are in the same video format. (HDMI output is
always ON).
h. PIP support option (custom firmware required).
