Digital Watchdog D2372TIR Series Manual de usuario

D2372TIR Series

About manual

INSTRUCTION MANUAL

Before installing and using the camera, please read this

manual carefully.

Be sure to keep it handy for future reference.

5436 W Crenshaw Street

Tampa, FL 33634

www.digital-watchdog.com

Technical Support : 1-866-446-3595/813-888-9555

Before installing and using the camera, please read this

manual carefully.

Be sure to keep it handy for future reference.

5436 W Crenshaw Street

Tampa, FL 33634

www.digital-watchdog.com

Technical Support : 1-866-446-3595/813-888-9555

PRECAUTIONS

■Do not open or modify

Do not open the case except during maintenance and installation,

as it may be dangerous and cause damages.

■Do not put objects inside the unit

Make sure that no metal objects or flammable substances

get inside the camera. It could cause fire, short-circuits or damages.

■Be careful when handling the unit

To prevent damage, do not drop the camera or subject it to

strong shock or vibration.

■Install away from electric or magnetic fields

■Protect from humidity and dust

■Protect from high temperature

Be careful when installing close to the ceiling , in a kitchen or boiler

room, as the temperature may rise to high levels.

■Do not open or modify

Do not open the case except during maintenance and installation,

as it may be dangerous and cause damages.

■Do not put objects inside the unit

Make sure that no metal objects or flammable substances

get inside the camera. It could cause fire, short-circuits or damages.

■Be careful when handling the unit

To prevent damage, do not drop the camera or subject it to

strong shock or vibration.

■Install away from electric or magnetic fields

■Protect from humidity and dust

■Protect from high temperature

Be careful when installing close to the ceiling , in a kitchen or boiler

room, as the temperature may rise to high levels.

■Cleaning

Dirt can be removed from the case only by wiping it with a soft cloth

moistened with a soft detergent solution.

■Mounting Surface

The mounting surface material must be strong enough to support

the camera.

TROUBLESHOOTING

Before sending the camera out for repair, check the items below.

If the problem persists after checking these items, contact your service

center.

■If no image appears

Is the coaxial cable attached securely?

Are the power and voltage normal?

Has the iris of the lens inside the camera been

adjusted correctly (with the level volume) ?

Is there adequate illumination?

■If the image is unclear

Is the lens in focus?

Is the lens dirty?

Dirt or fingerprints on the lens can adversely affect the

Before sending the camera out for repair, check the items below.

If the problem persists after checking these items, contact your service

center.

■If no image appears

Is the coaxial cable attached securely?

Are the power and voltage normal?

Has the iris of the lens inside the camera been

adjusted correctly (with the level volume) ?

Is there adequate illumination?

■If the image is unclear

Is the lens in focus?

Is the lens dirty?

Dirt or fingerprints on the lens can adversely affect the

images. Gently wipe any dirt or fingerprints off the lens

with a soft cloth or lens cleaning paper and cleaning

fluid (commercially available).

Is the monitor adjusted correctly?

WARNING:

TO PREVENT THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE

THIS APPLIANCE TO RAIN OR MOISTURE.

DIMENSION (mm)

D2372TIR SeriesD2372TIR Series

INSTALLATION

INSTALLATION (cont.)

1. Loosen the fixing screw (A) using a screwdriver.

2. Separate the upper case (B) and the base case (D).

3. Cut a hole in the ceiling for routing the cables.

4. Place the camera horizontally on the ceiling, drill the screw

holes at the marked four positions.

5. Pass the power cable (E) and video cable (F) from the camera

unit through the cable hole in the ceiling.

6. Align the screw holes of the camera unit with the holes in the

ceiling, secure with the four screws.

7. Install and adjust the camera unit.

8. Adjust the dome liner to show the lens through the camera

window fix to the base(D)

A. Loosen the fixing screw using the L-wrench that came with the camera

B. Separate the upper case and the base case.

C. Cut a hole in the ceiling for routing the cables.

D. Place the camera horizontally on the ceiling, drill the screw

holes at the marked four positions.

E Pass the power cable and video cable from the camera

unit through the cable hole in the ceiling.

F. Align the screw holes of the camera unit with the holes in the

ceiling, secure with the four screws.

G. Install and adjust the camera unit.

H. Adjust the dome liner to show the lens through the camera

dtt hit

tthb

1. Loosen the fixing screw (A) using a screwdriver.

2. Separate the upper case (B) and the base case (D).

3. Cut a hole in the ceiling for routing the cables.

4. Place the camera horizontally on the ceiling, drill the screw

holes at the marked four positions.

5. Pass the power cable (E) and video cable (F) from the camera

unit through the cable hole in the ceiling.

6. Align the screw holes of the camera unit with the holes in the

ceiling, secure with the four screws.

7. Install and adjust the camera unit.

8. Adjust the dome liner to show the lens through the camera

window, fix to the base(D).

9. Put the upper case (B) and the base (D) together.

10. Tighten the screw (A) for the upper/base cases not to be

separated .

A. Loosen the fixing screw using the L-wrench that came with the camera

B. Separate the upper case and the base case.

C. Cut a hole in the ceiling for routing the cables.

D. Place the camera horizontally on the ceiling, drill the screw

holes at the marked four positions.

E Pass the power cable and video cable from the camera

unit through the cable hole in the ceiling.

F. Align the screw holes of the camera unit with the holes in the

ceiling, secure with the four screws.

G. Install and adjust the camera unit.

H. Adjust the dome liner to show the lens through the camera

window and attach it to the base.

I. Put the upper case and the base together.

J. Tighten the screws with the L-wrench for the upper and base not to be

separated .

CONNECTION

DC12

DC12V / AC24V

CAUTION :

Check for polarity when using a DC 12V power supply.

DC12

DC12V / AC24V

■LENS ADJUSTMENT

CAMERA SETTINGS

B. Focus lever

A. Zoom Lever

A. Set the zoom lever to the desired position by moving Zoom lever.

B. Set the Focus by moving Focus lever.

B. Focus lever

A. Zoom Lever

REMOTE CONTROL- D2372TIR Series [OPTIONAL]

KEY BUTTON

OSD BUTTON

PAN FOCUS CONTROL BUTTON

Omni‐FocusRemoteControlInstructions

1. ChecktheDipswitch(SW4)forcameraID(Defaultis0)

2. Pointtheremotecontroltowardsthecamera,thenpressand

hold[0]untiltheRedLEDlightstartflashing.

3. PressandholdtheKEYbutton,untilLEDturnsasolidRED.

4. PressthePlussign(+)toZOOMIN,Minussign(‐)toZOOMOUT

5. Pressthe[ENT]buttontoenterthesetupMenuandpress[KEY]

buttontoexit.

KEY BUTTON

OSD BUTTON

PAN FOCUS CONTROL BUTTON

ID BUTTON

Omni‐FocusRemoteControlInstructions

1. ChecktheDipswitch(SW4)forcameraID(Defaultis0)

2. Pointtheremotecontroltowardsthecamera,thenpressand

hold[0]untiltheRedLEDlightstartflashing.

3. PressandholdtheKEYbutton,untilLEDturnsasolidRED.

4. PressthePlussign(+)toZOOMIN,Minussign(‐)toZOOMOUT

5. Pressthe[ENT]buttontoenterthesetupMenuandpress[KEY]

buttontoexit.

D2372TIR

(1) Ad

ustin

level volume

(

)

If the entire image is too dark or bright, or the backlight compensation is not correct

CAMERA SETTING FOR SIDE OSD CONTROL BOARD

2'nd Video

Omni Focus Lens

(Zoom in/Zoom out)

Joy Stick Key

ID Number

even after LENS is set to "DC", you need to adjust the level volume.

CCW (Low) Close the lens iris, making the entire image darker

CW(High) Open the lens iris, making the entire image brighter

(2) Second Video Out Connector

(

2'ND VIDEO

)

If installer uses a portable monitor, this connector should be connected.

(3) Omni Focus Lens

The focus is always set correctly during the change of angle of view.

Zoom In The lens focal length goes to max 8.5mm

Zoom out The lens focal length goes to max 2.9mm

(4) ID number

(※1,2,4,8(BCD code) means ID number, and ID contains 10 numbers from 0 to 9.)

2'nd Video

Omni Focus Lens

(Zoom in/Zoom out)

Joy Stick Key

ID Number

Tabla de contenidos

Otros manuales de Cámara IP de Digital Watchdog

Digital Watchdog

Digital Watchdog DWC-MTT4Wi36 Manual de usuario

Digital Watchdog

Digital Watchdog Megapix DWC-MTT4Wi28 Manual de usuario

Digital Watchdog

Digital Watchdog DWC-PB2M4TIR Manual de usuario

Digital Watchdog

Digital Watchdog MEGApix FLEX DWC-PVX16W Manual de usuario

Digital Watchdog

Digital Watchdog MEGApix DWC-MV72Wi4A Manual de usuario

Digital Watchdog

Digital Watchdog DWC-MV84WiAC6 Manual de usuario

Digital Watchdog

Digital Watchdog MEGApix DWC-MPTZ20XFM Manual de usuario

Digital Watchdog

Digital Watchdog DWC-PB6M4T Manual de usuario

Digital Watchdog

Digital Watchdog Star-Light Plus DWC-VA583WTIR Manual de usuario

Digital Watchdog

Digital Watchdog DWC-MB721M4TIR Manual de usuario

Digital Watchdog

Digital Watchdog MEGApix IVA DWC-MVD8WiATW Manual de usuario

Digital Watchdog

Digital Watchdog Star-Light Plus DWC-VA553WTIR Manual de usuario

Digital Watchdog

Digital Watchdog DWC-MB721M8TIR Manual de usuario

Digital Watchdog

Digital Watchdog MEGApix DWC-MPTZ336XW Manual de usuario

Digital Watchdog

Digital Watchdog DWC-PB6M4T Manual de usuario

Digital Watchdog

Digital Watchdog MEGApix DWC-MVT4Wi6 Manual de usuario

Digital Watchdog

Digital Watchdog MEGApix DWC-MF2Wi4TW Manual de usuario

Digital Watchdog

Digital Watchdog DWC-V6863WTIRW Manual de usuario

Digital Watchdog

Digital Watchdog DWCA-C128-64 Manual de usuario

Digital Watchdog

Digital Watchdog DWC-B6883WTIR Manual de usuario

Digital Watchdog

Digital Watchdog MegaPix DWC-MB421TIR Manual de usuario

Digital Watchdog

Digital Watchdog MEGApix IVA+ DWC-MPV45WiATW Manual de usuario

Digital Watchdog

Digital Watchdog MEGApix DWC-MV75Wi28TW Manual de usuario

Digital Watchdog

Digital Watchdog MEGApix DWC-MF21M4TIR Manual de usuario

Manuales populares de Cámara IP de otras marcas

FLIR

FLIR Exx series Manual de usuario

Avigilon

Avigilon H4A-BO1-IR Manual de usuario

ShareTech

ShareTech AV1 Manual de usuario

Ezviz

Ezviz C6C Manual de usuario

Melchioni

Melchioni UCAM 2015 Manual de usuario

Geutebruck

Geutebruck G-Cam/ESD-4630 Manual de usuario

Arecont Vision

Arecont Vision MegaBall AV3146DN-3310-D-LG Manual de usuario

Mitel

Mitel 6800i Series Manual de servicio

Vitek

Vitek VTC-IR403-212NP Manual de usuario

THOMSON

THOMSON DSC - 323W Manual de usuario

AVer

AVer FB2027 Manual de usuario

ENFORCER

ENFORCER EV-T5105-N2SQ Manual de usuario

Wansview

Wansview NC543 Manual de usuario

Eneo

Eneo MCB-64A0003M0A Manual de usuario

deView electronics

deView electronics CBDNI36F Manual de usuario

Swann

Swann SwannEye Manual de usuario

LevelOne

LevelOne IP CamSecure Manual de usuario

Digitus

Digitus DN-16085-1 Manual de usuario