Digital Watchdog DW-LPR650AHD Manual de usuario
07/2015
ABOUT MANUAL
Before installing and using the camera, please read this manual carefully.
Be sure to keep it handy for future reference.
License Plate Recognition
Camera
DWC-LPR650AHD
2
PRECAUTIONS
Do not open or modify.
Do not open the case except during maintenence and installation,
for it may be dangerous and can cause damages.
Do not put objects into the unit.
Keep metal objects and flammable substances from entering the camera.
It can cause fire, short-circuits, or other damages.
Be careful when handling the unit.
To prevent damages, do not drop the camera or subject it to shock or vibration.
Do not install near electric or magnetic fields.
Protect from humidity and dust.
Protect from high temperature.
Be careful when installing near the ceiling of a kitchen or a boiler room,
as the temperature may rise to high levels.
Cleaning:
To remove dirt from the case, moisten a soft cloth with a soft detergent solution and wipe.
Mounting Surface:
The material of the mounting surface must be strong enough to support the camera.
FCC COMPLIANCE
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection
against harmful interference, when the equipment is operated in a residential environment. This
equipment generates, uses, and radiates radio frequency energy; and if it is not installed and used in
accordance with the instruction manual, it may cause harmful interference to radio communications.
WARNING: Changes or modifications are not expressly approved by the manufacturer.
Table of Contents
3
TABLE OF CONTENTS
Introduction
Installation
Module OSD Menu
Troubleshooting
Warranty Information
Specifications
Features
Parts and Descriptions
Dimensions
Inside the Box
Mount Installation Instructions
Connecting to Monitors 11
LPR Installation Instructions
Control Board
4
5
6-7
8
9
10
12
13
14-25
26
27-28
29-30
Adjusting the Camera Angle
4
FEATURES*
Analog High Definition (AHD) HD over Coax Technology
AHD LPR™ License Plate Recognition Technology captures reflective
license plates up to 50mph with a 13’~30’ Capture Range
Reliable Performance under Any Lighting Conditions
External OSD and Lens Adjustment
1080P Resolution at 30fps
Varifocal P-Iris Lens 6~50mm
Smart IR™ with Intelligent Camera Sync. 115ft Range
Smart DNR™ 3D Digital Noise Reduction
Highlight Masking Exposure (HME)
Secondary Video-BNC Output
OSD Control via Coax Cable using UTC
Easy Icon Driven OSD Menu with Built-in Joystick
Programmable Privacy Zones
Auto Gain Control (AGC)
Back Light Compensation (BLC)
Dynamic Range Compressor (DRC) Reveals Low Light Detail
No Fog or Condensation Under any Weather Conditions
IP66 Certified (Weather Resistant)
Set Screw
5
PARTS & DESCRIPTION*
Sunshiled Cover
Test Video Slot
Con Cap
OSD Joystick Controller
Mounting Bracket
Zoom Control
focus Control
6
DIMENSIONS IN MILLIMETERS (IN)*
248.0
(2.76”)
226.0
(8.9”)
86.5
(3.4”)
95.0
(3.74”)
131.0
(5.15”)
96.7
(3.8”)
7
INSIDE THE BOX*
Included with Bullet Camera:
1
2
3
4
6
5
User Manual
Mounting Template
4 Machine Screws and 4 Dry Wall Anchors
Secondary Video-BNC Cable
L-Key
Test Monitor Cable
6
07/2015
ABOUT MANUAL
Before installing and using the camera, please read this manual carefully.
Be sure to keep it handy for future reference.
License Plate Recognition
Camera
DWC-LPR650AHD
8
INSTALLATION INSTRUCTIONS*
1. Using the mounting template or your own camera,
mark and drill the necessary holes to mount the
bracket to a wall or ceiling.
2. Pull all necessary wires through and make the
proper connections.
3. Use the four (4) mounting screws to install
the camera on the wall or ceiling.
NPT 3/4” Pipe
*Installation Using a Junction Box
*Note: Electrical junction box and
required screws sold separately.
9
INSTALLATION INSTRUCTIONS*
An LPR camera is designed to read a license plate only. When a license plate passes by the
camera, the reflective film on the plate will be reflected back to the camera which gives you
the good clear shot of the plate. You will ONLY capture an image of the plate.
US license plates need to be at least 130 pixels wide. This translates roughly into an image
no wider than 5-6 feet assuming 4CIF standard definition video.
1. The horizontal angle between the camera and plate should be within 20° degrees. This
means that if your camera is 10 feet away from the plate, the plate cannot be more than 3
feet to the right or left of the camera.
2. The vertical angle between the camera and plate is within 30° degrees. This means that if
your camera is 10 feet away from the plate and the plate is 3 feet off the ground, the camera
cannot be mounted more than 8 feet high.
3. Attempting to position the security camera at odd angles or exceeding the distance
capabilities will result in a poor shot of the plate
4. The DVR’s recording fps should be at the highest to assure best capture quality.
THE CAPTURED IMAGE SHOULD BE FILLED WITH THE FULL WIDTH OF THE VEHICLES
10
INSTALLATION INSTRUCTIONS*
LPR Camera Installation
THE CAMERA SHOULD BE MOUNTED AT AN ANGLE NO GREATER THAN 30 DEGREES
3–8
< 30°
< 20°
CAMERA ANGLE NO GREATER THAN 20 DEGREES FOR SIDE MOUNT INSTALLATIONS
Tabla de contenidos
Otros manuales de Cámara digital de Digital Watchdog
Digital Watchdog
Digital Watchdog STAR-LIGHT PLUS DWC-D4883WTIRW Manual de usuario
Digital Watchdog
Digital Watchdog MegaPix Pano DWC-PVF5M1TIRC6 Manual de usuario
Digital Watchdog
Digital Watchdog STAR-LIGHT DWC-B6263WTIR650 Manual de usuario
Digital Watchdog
Digital Watchdog DWC-PZPARAM Manual de usuario
Digital Watchdog
Digital Watchdog MEGApix CaaS DWC-MB44LPRC6 Manual de usuario
Digital Watchdog
Digital Watchdog DWC-P230FMW Manual de usuario
Digital Watchdog
Digital Watchdog DWC-B6263WTIR Manual de usuario
Digital Watchdog
Digital Watchdog Starlight B1363TIR Manual de usuario
Digital Watchdog
Digital Watchdog DWC-MF4Wi4C6 Manual de usuario
