Installation and Operation (Receiver)
For best results, the receiver should be placed at least 1m off the ground, and should
not be placed directly in front of the speaker system.
-Position the receiver on a stable platform and attach the AC adaptor.
-Plug one end of the provided lead into the AF output connector of the
receiver, and the other end to the input jack of your amplifier or PA system.
-Plug the power adaptor into a suitable electrical wall socket and turn the
power on.
-Select the channel you would like to use.
Installation and Operation (Transmitter)
-Open the battery compartment, insert 1 x AAA battery and close the battery
cover.
-Plug the transmitter plug into your instrument and turn the power switch
on.
-The signal level indicator on the receiver should now light up indicating that
the signal is being received. It will only light up for a few seconds.
-Adjust your instrument and amplifier controls to the desired volume and
tone.
-Please ensure you select the same channel (CH1 or CH2) as the receiver on
the transmitter.
-When finished, turn the power switch off before removing from the
instrument.
