
2.2. The On-Board USB-Charger
The On-Board charging circuit is an active switch mode attery charger in contrast to the
often used linear charger on other circuits. The active charger has the main advantage that
it is much more efficient. This ena les the circuit to charge with much higher currents
compared to a linear charger, and thus charging the attery faster.
The charger is compati le with the attery charging specification 1.2 (BC1.2). The
specification defines how a charging circuit should detect the supply strength of the source
connected to it. Thus the charger can detect how much current it may draw from the
source, i.e. 500mA from a PC or laptop up to 3A from a dedicated charging port.
On the oard there is a vertical 5pin Micro-USB-B plug on an extension oard, which can
e cut off, if not used in that position. There is also the option to order the oard with a
mini-USB plug populated on the ottom side (see ordering in formation).
Beside this there is an option to populate a 6pin 0.5mm pitch FPC connector on the oard
and soldering pads on the ottom. The usage of this FPC connector has two options:
- When solder jumper J2 is closed, an external daughter oard can e connected y the
FPC connection, carrying an USB plug, which is mounted anywhere else in the design.
- When solder jumper J3 is closed AND J1 opened, the FPC plug is connected to the attery
instead of the on- oard charger.
This gives the opportunity to implement a different charger, or, when two atteries in
series are used, to charge the atteries with a charger capa le to charge 2 series atteries.
When the on- oard charger circuitry is used note the following ehavior: As soon as the
USB-Plug is connected (with a attery connected to the oard), the red LED lamp is on to
show the charging is in progress. When the attery is almost completely charged, the LED
starts linking slowly and is off, when attery is fully charged.
By plugging in the USB-ca le, the processor is switched on as well. Note that the processor
will not react to any uttons, if it was actively switched off efore the USB-ca le was
attached or when it was actively switched off while the USB ca le is attached.
It can only e switched on again y removing the USB-connection and pressing the fire
utton five times in this case.
If it was NOT switched off actively y the user, ut ecause of auto-power-off, the uttons
will react normal.
It is also possi le to vape during the charging, although this is not recommended ecause
the charging circuit performs the charging in different steps, which depend on the attery
voltage. By vaping during charging, the voltage drop in the attery can let the charger
switch etween phases and reset certain safety timers. Normally this is not critical, ut
with defective or ad atteries, the safety timers will not work properly in this case.