Dickinson Radex 1 Manual de usuario

Form# 7.2-63 (2)
Radex 1
&
Radex 2
Operator’s Manual
This manual must be read
and the requirements carried out
to ensure satisfactory performance.
DICKINSON RESERVES THE RIGHT TO MAKE CHANGES TO PRODUCTS OR DOCUMENTS AT
ANY TIME
QUALITY INSPECTED BY- Doug & Don AUG. 26
TH
2011

Form# 7.2-63 (2)
Warnings and Disclosures
FOLLOW ALL INSTALLATION AND OPERATING PROCEDURES
WARNING! DO NOT MOUNT THIS HEATER IN THE BILGE AREA OR IN
AN AREA THAT DRAWS AIR FROM THE BILGE.
WARNING! ENGINE COOLANT OR BOILER HEATED WATER CAN CAUSE
INJURY AND PAINFUL BURNS. USE CAUTION AND ENSURE ALL CLAMPS
AND FITTINGS ARE TIGHT AND SECURE
WARNING! ENSURE HANDS, WIRES, LOOSE CLOTHES AND OTHER
OBSRUCTIONS ARE CLEAR OF THE FAN (S) IN THE HEATER BEFORE
OPERATION.
DO NOT USE SUBSTITUTE PARTS
Keep your proof of purchase and product serial number for warranty
Diagram

Form# 7.2-63 (2)
Note: 24 volt motors may be in stock depending on inventory stock
YourRadexHeater
Thank you for choosing the Radex water to air heat exchanger. The Radex heater is designed
to efficiently use the waste water heat produced by a water cooled engine or a hot water boiler
system, to generate a source of forced air heat. The Radex is suitable for use in boats, RVs,
trucks, cars and anywhere else a source of circulating hot water and 12v power is available.
There are two Radex models, the Radex 1 and the larger Radex 2. Each use a very quiet,
low amp draw fan to push air through the heated coil to heat a space.
MountingKits
Two mounting kits are available for the Radex 1 and Radex 2.
Side mount bracket kit 22-001 fits both the large and the small Radex and is used to
mount the Radex to the floor, a wall or ceiling. The frame mount kit (22-002 for Radex 1
and 22-003 for Radex 2) is used to install a recessed Radex flush in a bulkhead or cabinet
with a trim panel.
A B C D E F
Radex 1 10.38” /
26.37cm
7.00” /
17.78cm
5.00” /
12.7cm
2.00” /
5.08cm
12.38” /
31.45cm
3.00” /
7.62cm
Radex 2 16.88” /
42.88cm
7.00” /
17.78cm
5.00” /
12.7cm
2.00” /
5.08cm
18.00” /
45.72cm
3.00” /
7.62cm
VOLTS AMPS CFM BTU/HR -
KW
WEIGHT
Radex 1 12 0.74 100 12000/
3.5kW
6.5lbs / 3kg
Radex 2 12 1.48 200 24000/ 7 kW 9lbs / 4kg

Form# 7.2-63 (2)
Blower Fan
Your Radex is equipped with one or two low amp 12v fans. Each fan is controlled by a
separate on and off switch. We suggest that a 3 amp fuse be used in the installation.

Form# 7.2-63 (2)
Installation
To make sure your unit has an adequate air supply install the Radex so there is at least 2”
(5.08cm) of airspace behind the fan.
Connect the circulating hot water to the pipes as shown. The outside dimension of the
copper tubing is a ¾” diameter (1.9cm). If using 5/8ths heater hose, ensure the clamp is
secure at the end of the hose to prevent slipping . We recommend the use of compression
fittings with a 3/4” diameter female tube to a 5/8” diameter male hose barb fitting (and
hose clamp).
Operate the heater and check all connections for leaks prior to final installation into wall
or cabinet.
After the fan wiring and water installation are complete, secure the Radex in the mounted
position with the desired mounting kit.
Fresh water cooled engines should mount the heater below the level of the radiator cap or
use an air bleeder to prevent trapped air locks. The Radex 2 has an installed manual air
bleed valve. Be sure the hoses are not kinked or restricted in any way.
REPORT ANY DEFICIENCIES OR MISSING COMPONENTS IMMEDIATELY

Form# 7.2-63 (2)
Limited Warranty
WARRANTY PROVISIONS : Dickinson warrants this product to be free of defects in workmanship and materials for
a period of one year. This warranty is limited to claims submitted in writing within a one-year period following the
date of purchase. If any part of your new product fails because of a manufacturing defect within the warranty period
Dickinson offers to replace said parts free of charge, provided, however, that such parts have not been improperly
repaired, altered or tampered with or subjected to misuse, abuse or exposed to corrosive conditions. This warranty,
however, is limited by certain exclusions, time limits and exceptions as listed below. Read these limitations and
exclusions carefully.
TIME LIMIT : This warranty is given too and covers only the original purchaser. Coverage terminates one year from
the date of purchase for parts replacement. EXCLUSIONS : This warranty does not cover or include : (a) Any normal
deterioration of the product and appearance of items, due to wear and/or exposure; (b) any guarantees, promises,
representations, warranties or service agreements given or made by an authorized distributor or other person selling this
product, other than those specifically stated herein; (c) any damage or defect due to accident, improper repair,
alteration, unreasonable use including failure to provide reasonable and necessary maintenance, misuse or abuse of the
equipment, or exposure to corrosive conditions. This warranty is conditioned upon normal use, reasonable and
necessary maintenance and service of your product, and written notice being given promptly upon Buyer's discovery of
a warranty claim, pursuant to paragraph 6 below. Reasonable and necessary maintenance is maintenance which you
are expected to do yourself or have done for you. It is maintenance, which is necessary to keep your product
performing its intended function and operating at a reasonable level of performance.
DAMAGE LIMITATION WARNING : IN NO EVENT SHALL Dickinson BE LIABLE FOR ANY INCIDENTAL
OR CONSEQUENTIAL DAMAGES, INCLUDING (BUT NOT LIMITED TO) LOSS OF USE OF THE PRODUCT,
LOSS OF TIME, INCONVENIENCE, EXPENSES FOR TRAVEL, LODGING TRANSPORTATION CHARGES,
LOSS BY DAMAGE TO PERSONAL PROPERTY OR LOSS OF INCOME, PROFITS OR REVENUE.
ORAL OR IMPLIED WARRANTY LIMITATIONS : The foregoing warranty is exclusive and in lieu of all other
warranties, written or oral, expressed or implied, including but not limited to any warranty or merchantability or fitness
for a particular purpose.
TRANSFER LIMITATIONS : This warranty is not assignable or transferable. It covers only the original purchaser.
CLAIM PROCEDURE : In the event of a defect, problem or that a breach of this warranty is discovered, in order to
protect any warranty rights you must promptly notify Dickinson. Give name, address, and model name, location of
unit, description of problem and where you can be reached during business hours.
RESERVED RIGHT TO CHANGE : Dickinson reserves the right to make changes or improvements to products it
produces in the future without imposing on itself any obligations to install the same improvements in the products it has
previously manufactured.
SECOND OR SUBSEQUENT OWNER : Dickinson does not give any warranty to secondary or subsequent
purchasers, and it disclaims all implied warranties to such owners.
INSPECTION : To assist you in avoiding problems with your product and to validate this warranty you are required to
do the following : (a) read the warranty; (b) inspect the product. Do not accept delivery until you have examined the
product with your supplier; (c) ask questions about anything you do not understand concerning the product.
OWNER REGISTRATION : Fill out the WARRANTY CARD within 30 days from the date of delivery.
WARRANTY : RETURN OF THE CARD IS CONDITION PRECEDENT TO WARRANTY COVERAGE AND
PERFORMANCE. IF YOU DO NOT FILL OUT AND MAIL THE CARD AS DIRECTED, YOU WILL NOT
HAVE A WARRANTY.
LEGAL RIGHTS : This warranty gives you specific legal rights and you may also have other rights, which may vary
within different government jurisdictions.

Form# 7.2-63 (2)
Return to:
SINCE 1932
WARRANTY FORM
I have read and understand the Limited Warranty and the Instruction Manual
and agree to the terms and condition
(please print)
Date……………………………………………………………………………
Purchaser’s Name……………………………………………………………..
Address………………………………………………………………………..
………………………………………………………………………………...
Model Name……
Radex
……----------………………………………………
Serial Number…………………………………………………………………
Date Of Purchase…………….………………………………………………..
Signature………………..……………………………………………………..
Name of Seller…………..………………………………………………….....
.
Seller Location…………..…………………………………………………….
Note: The warranty info can be sent in via e-mail:
info@dickinsonmarine.com

Form# 7.2-63 (2)
Dickinson Marine
#101-17728 66
th
AVE
SURREY, BC V3S7X1 Canada
Tel: 604-574-8641
Fax: 604-574-8659
E-mail: [email protected]
Website: www.dickinsonmarine.com
All rights reserved. No part of this manual may be reproduced without permission in writing from
Dickinson Marine. Dickinson also reserves the right to modify or change without notice, any
materials, applications, equipment, accessories, and/or prices. All measurements and weights are
approximate.
Este manual sirve para los siguientes modelos
1
Tabla de contenidos
Otros manuales de Calentador de Dickinson
Manuales populares de Calentador de otras marcas

Empire Heating Systems
Empire Heating Systems WCC65 Manual de usuario

Wetekom
Wetekom 92 86 43 Manual de usuario

Desa
Desa SPC170-F Manual de usuario

Watlow
Watlow Watrod Electric Tubular Heaters Manual de usuario

Haverland
Haverland ECO-DRY GPS Series Manual de lista de piezas

Stelpro
Stelpro ASILVC2060 Series Manual de usuario















